Macroporous poly(dicyclopentadiene) beads

Real-Time Polymer Viscosity-Catalytic Activity Relationships on the Microscale

Polymer growth induces physical changes to catalyst microenvironments. Here, these physical changes are quantified in real time and are found to influence microscale chemical catalysis and the polymerization rate. By developing a method to "peer into" optically transparent living-polymer particles, simultaneous imaging of both viscosity changes and chemical activity was achieved for the first time with high spatiotemporal resolution through a combination of fluorescence intensity microscopy and fluorescence lifetime imaging microscopy techniques. Specifically, an increase in microenvironment viscosity led to a corresponding local decrease in the catalytic molecular ruthenium ring-opening metathesis polymerization rate, plausibly by restricting diffusional access to active catalytic centers. Consistent with this diffusional-access model, these viscosity changes were found to be monomer-dependent, showing larger changes in microenvironment viscosity in cross-linked polydicyclopentadiene compared to non-crosslinked polynorbornene. The sensitivity and high spatial resolution of the imaging technique revealed significant variations in microviscosities between different particles and subparticle regions. These revealed spatial heterogeneities would not be observable through alternative ensemble analytical techniques that provide sample-averaged measurements. The observed spatial heterogeneities provide a physical mechanism for variation in catalytic chemical activity on the microscale that may accumulate and lead to nonhomogeneous polymer properties on the bulk scale.

Assembly of organic monolayers on polydicyclopentadiene

The first well-defined organic monolayers assembled on polydicyclopentadiene is reported. Commercial grade dicyclopentadiene was polymerized with the Grubbs' second-generation catalyst in a fume hood under ambient conditions at very low monomer to catalyst loadings of 20 000 to 1. This simple method resulted in a polymer that was a hard solid and appeared slightly yellow. Brief exposures of a few seconds of this polymer to Br 2 lead to a surface with approximately half of the olefins brominated as shown by X-ray photoelectron spectroscopy (XPS) and attenuated total reflection-infrared (ATR-IR) spectroscopy. The ATR-IR spectroscopy was carried out with the polymer in contact with a Ge hemisphere housed in a GATR accessory from Harrick. This brominated polydicyclopentadiene was immersed in DMF with 4-(trifluoromethyl)benzylamine to assemble a monolayer. The amines displaced Br on the surface to form a monolayer that exposed a CF 3 group on the surface. The surface was extensively studied by XPS using the method described by Tougaard to find the distribution of F within the surface layer. The ratio for the peak area, Ap, to the background height, B, measured 30 eV below the peak maximum was 109.8 eV. This value clearly indicated that F was found only at the surface and was not found within the polymer. A surface coverage of 1.37 amines per nm (2) was estimated and indicated that the monolayer was 28% as dense as a similar monolayer assembled from thiols on gold. Finally, a simple method to pattern these monolayers using soft lithography is described. This work is critically important because it reports the first monolayers on a relatively new and emerging polymer that has many desirable physical characteristics such as high hardness, chemical stability, and ease of forming different shapes.