A commercial production route to prepare polymer-based nanocomposites by unmodified multilayer graphene

Non-Isothermal Crystallization Kinetics of Polyamide 6/Graphene Nanoplatelets Nanocomposites Obtained via In Situ Polymerization: Effect of Nanofiller Size

Thermoplastic resin transfer molding (T-RTM) technology was applied to synthesize graphene nanoplatelets-based nanocomposites via anionic ring-opening polymerization (AROP). Polyamide 6 (PA6) was obtained by AROP and was used as the polymeric matrix of the developed nanocomposites. The non-isothermal crystallization behavior of PA6 and nanocomposites was analyzed by differential scanning calorimetry (DSC). Nanocomposites with 0.5 wt.% of graphene nanoplatelets (GNPs) with two different diameter sizes were prepared. Results have shown that the crystallization temperature shifted to higher values in the presence of GNPs. This behavior is more noticeable for the nanocomposite prepared with smaller GNPs (PA6/GN). The crystallization kinetic behavior of all samples was assessed by Avrami and Liu's models. It was observed that GNPs increased the crystallization rate, thus revealing a nucleating ability, and also validated the reduction of half-time crystallization values. Such tendency was also supported by the lower activation energy values determined by Friedman's method.

Polymers and Related Composites via Anionic Ring-Opening Polymerization of Lactams: Recent Developments and Future Trends

This paper presents a comprehensive overview of polymers and related (nano)composites produced via anionic ring opening polymerization (AROP) of lactams. It was aimed at surveying and showing the important research and development results achieved in this field mostly over the last two decades. This review covers the chemical background of the AROP of lactams, their homopolymers, copolymers, and in situ produced blends. The composites produced by AROP were grouped into nanocomposites, discontinuous fiber, continuous fiber, textile fabric, and self-reinforced composites. The manufacturing techniques were introduced and the most recent developments highlighted. Based on this state-of-art survey some future trends were deduced and as their "driving forces" novel and improved manufacturing techniques identified.

Microwave-synthesized freestanding iron-carbon nanotubes on polyester composites of woven Kevlar fibre and silver nanoparticle-decorated graphene

We synthesized Ag nanoparticle-decorated multilayered graphene nanosheets (Ag-graphene) from graphite nanoplatelets and silver nitrate through 90–100 s of microwave exposure, without the use of any mineral acids or harsh reducing agents. Fe nanoparticle-decorated carbon nanotubes (Fe-CNTs) were grown on polypyrrole (PPy) deposited on woven Kevlar fibre (WKF), using ferrocene as a catalyst, under microwave irradiation. Fe-CNTs grown on WKF and Ag-graphene dispersed in polyester resin (PES) were combined to fabricate Ag-graphene/Fe-CNT/PPy-coated WKF/PES composites by vacuum-assisted resin transfer moulding. The combined effect of Fe-CNTs and Ag-graphene in the resulting composites resulted in a remarkable enhancement of tensile properties (a 192.56% increase in strength and 100.64% increase in modulus) as well as impact resistance (a 116.33% increase). The electrical conductivity significantly increased for Ag-graphene/Fe-CNT/PPy-coated WKF/PES composites. The effectiveness of electromagnetic interference shielding, which relies strongly on the Ag-graphene content in the composites, was 25 times higher in Ag-graphene/Fe-CNT/PPy-coated WKF/PES than in neat WKF/PES composites. The current work offers a novel route for fabricating highly promising, cost effective WKF/PES composites through microwave-assisted synthesis of Fe-CNTs and Ag-graphene.