Flavin-Catalyzed Oxidation of Amines and Sulfides with Molecular Oxygen: Biomimetic Green Oxidation

Enhanced Solid-State Fluorescence of Flavin Derivatives by Incorporation in the Metal-Organic Frameworks MIL-53(Al) and MOF-5

The flavin derivatives 10-methyl-isoalloxazine (MIA) and 6-fluoro-10-methyl-isoalloxazine (6F-MIA) were incorporated in two alternative metal-organic frameworks, (MOFs) MIL-53(Al) and MOF-5. We used a post-synthetic, diffusion-based incorporation into microcrystalline MIL-53 powders with one-dimensional (1D) pores and an in-situ approach during the synthesis of MOF-5 with its 3D channel network. The maximum amount of flavin dye incorporation is 3.9 wt% for MIA@MIL-53(Al) and 1.5 wt% for 6F-MIA@MIL-53(Al), 0.85 wt% for MIA@MOF-5 and 5.2 wt% for 6F-MIA@MOF-5. For the high incorporation yields the probability to have more than one dye molecule in a pore volume is significant. As compared to the flavins in solution, the fluorescence spectrum of these flavin@MOF composites is broadened at the bathocromic side especially for MIA. Time-resolved spectroscopy showed that multi-exponential fluorescence lifetimes were needed to describe the decays. The fluorescence-weighted lifetime of flavin@MOF of 4 ± 1 ns also corresponds to those in solution but is significantly prolonged compared to the solid flavin dyes with less than 1 ns, thereby confirming the concept of "solid solutions" for dye@MOF composites. The fluorescence quantum yield (Φ_F) of the flavin@MOF composites is about half of the solution but is significantly higher compared to the solid flavin dyes. Both the fluorescence lifetime and quantum yield of flavin@MOF decrease with the flavin loading in MIL-53 due to the formation of various J-aggregates. Theoretical calculations using plane-wave and QM/MM methods are in good correspondence with the experimental results and explain the electronic structures as well as the photophysical properties of crystalline MIA and the flavin@MOF composites. In the solid flavins, π-stacking interactions of the molecules lead to a charge transfer state with low oscillator strength resulting in aggregation-caused quenching (ACQ) with low lifetimes and quantum yields. In the MOF pores, single flavin molecules represent a major population and the computed MIA@MOF structures do not find π-stacking interactions with the pore walls but only weak van-der-Waals contacts which reasons the enhanced fluorescence lifetime and quantum yield of the flavins in the composites compared to their neat solid state. To analyze the orientation of flavins in MOFs, we measured fluorescence anisotropy images of single flavin@MOF-5 crystals and a static ensemble flavin@MIL53 microcrystals, respectively. Based on image information, anisotropy distributions and overall curve of the time-resolved anisotropy curves combined with theoretical calculations, we can prove that all fluorescent flavins species have a defined and rather homogeneous orientation in the MOF framework. In MIL-53, the transition dipole moments of flavins are orientated along the 1D channel axis, whereas in MOF-5 we resolved an average orientation that is tilted with respect to the cubic crystal lattice. Notably, the more hydrophobic 6F-MIA exhibits a higher degree order than MIA. The flexible MOF MIL-53(Al) was optimized essentially to the experimental large-pore form in the guest-free state with QuantumEspresso (QE) and with MIA molecules in the pores the structure contracted to close to the experimental narrow-pore form which was also confirmed by PXRD. In summary, the incorporation of flavins in MOFs yields solid-state materials with enhanced rigidity, stabilized conformation, defined orientation and reduced aggregations of the flavins, leading to increased fluorescence lifetime and quantum yield as controllable photo-luminescent and photo-physical properties.

Tuning the Photophysical Properties of Flavins by Attaching an Aryl Moiety via Direct C-C Bond Coupling

Palladium-catalyzed Suzuki reactions of brominated flavin derivatives (5-deazaflavins, alloxazines, and isoalloxazines) with boronic acids or boronic acid esters that occur readily under mild conditions were shown to be an effective tool for the synthesis of a broad range of 7/8-arylflavins. In general, the introduction of an aryl/heteroaryl group by means of a direct C-C bond has been shown to be a promising approach to tuning the photophysical properties of flavin derivatives. The aryl substituents caused a bathochromic shift in the absorption spectra of up to 52 nm and prolonged the fluorescence lifetime by up to 1 order of magnitude. Moreover, arylation of flavin derivatives decreased their ability to generate singlet oxygen.

Immobilization of a flavin molecule onto poly(methacrylic acid)s and its application in aerobic oxidation catalysis: effect of polymer stereoregularity

The isoalloxazine ring system, called flavin, was successfully immobilized on poly(methacrylic acid)s, PMAAs, with different tacticity via post-polymerization modification under suitable conditions. The resulting flavin-containing polymers showed catalytic activity for aerobic oxidation reactions, in which the polymer stereoregularity clearly influenced their catalytic activity.

A flavin-inspired covalent organic framework for photocatalytic alcohol oxidation

Covalent organic frameworks (COFs) offer a number of key properties that predestine them to be used as heterogeneous photocatalysts, including intrinsic porosity, long-range order, and light absorption. Since COFs can be constructed from a practically unlimited library of organic building blocks, these properties can be precisely tuned by choosing suitable linkers. Herein, we report the construction and use of a novel COF (FEAx-COF) photocatalyst, inspired by natural flavin cofactors. We show that the functionality of the alloxazine chromophore incorporated into the COF backbone is retained and study the effects of this heterogenization approach by comparison with similar molecular photocatalysts. We find that the integration of alloxazine chromophores into the framework significantly extends the absorption spectrum into the visible range, allowing for photocatalytic oxidation of benzylic alcohols to aldehydes even with low-energy visible light. In addition, the activity of the heterogeneous COF photocatalyst is less dependent on the chosen solvent, making it more versatile compared to molecular alloxazines. Finally, the use of oxygen as the terminal oxidant renders FEAx-COF a promising and “green” heterogeneous photocatalyst.

In this manuscript, we report the development of a novel alloxazine COF inspired by naturally occurring flavin cofactors for photoredox catalysis.

Synthetic applications of flavin photocatalysis: a review

Encouraging developments in the field of photocatalysis in last decades, biomolecules namely flavins have been observed to act as a catalyst in several photoredox-catalysed synthetic methodologies.

Determination of acid dissociation constants of flavin analogues by capillary zone electrophoresis

Acid dissociation constants (pK_a ) of nine kinds of flavin analogues as molecular catalyst candidates were determined by CZE. Although some of the analogues are instable and degradable under the light exposure or in alkaline aqueous solutions, the effective electrophoretic mobility of the flavin analogue of interest has been measured with the residual substance. The pK_a values of the flavin analogues were analyzed through the changes in the effective electrophoretic mobility with varying pH of the separation buffer. One or two steps pK_a values were determined by the analysis. One of the degraded species from the flavin analogues, lumichrome, was also detected in the CZE analysis, and its pK_a values were also determined. While coexisting impurities generated over the storage conditions were found in some analogues, the pK_a values of the target analogues were successfully determined with the help of the CZE separations. A pressure-assisted CZE was utilized for the determination or the estimation of the pK_a values of such analogues as possessing carboxylic acid moiety.

Synthesis and Transformations of Nitrones for Organic Synthesis

Nitrones are important compounds and are highly useful in many aspects. The first part describes the methods for synthesis of nitrones, which are useful and environmentally friendly. Catalytic oxidations, condensations, and other useful reactions are described. The nitrones thus obtained are key intermediates for the synthesis of biologically important nitrogen compounds. The second part describes the fundamental transformations of nitrones, which will provide the strategies and means for the construction of nitrogen compounds. The reactions with nucleophiles or radicals, C-H functionalization, and various addition reactions are described. The last reactions are particularly important for highly selective carbon-carbon bond formations. 1,3-Dipolar cycloaddition reactions are excluded because the size of the review is limited and excellent reviews have been published in Chemical Reviews.

Comparison of riboflavin-derived flavinium salts applied to catalytic H2O2 oxidations

A series of flavinium salts, 5-ethylisoalloxazinium, 5-ethylalloxazinium, and 1,10-ethylene-bridged alloxazinium triflates, were prepared from commercially available riboflavin. This study presents a comparison between their optical and redox properties, and their catalytic activity in H2O2 oxidations of sulfide, tertiary amine, and cyclobutanone. Reflecting the difference between the π-conjugated ring structures, the flavinium salts displayed very different redox properties, with reduction potentials in the order of: 5-ethylisoalloxazinium > 5-ethylalloxazinium > 1,10-ethylene-bridged alloxazinium. A comparison of their catalytic activity revealed that 5-ethylisoalloxazinium triflate specifically oxidises sulfide and cyclobutanone, and 5-ethylalloxazinium triflate smoothly oxidises tertiary amine. 1,10-Bridged alloxazinium triflate, which can be readily obtained from riboflavin in large quantities, showed moderate catalytic activity for the H2O2 oxidation of sulfide and cyclobutanone.

Design of peptide-containing N5-unmodified neutral flavins that catalyze aerobic oxygenations

Simulation of the monooxygenation function of flavoenzyme (Fl-Enz) has been long-studied with N5-modified cationic flavins (FlEt+ ), but never with N5-unmodified neutral flavins (Fl) despite the fact that Fl is genuinely equal to the active center of Fl-Enz. This is because of the greater lability of 4a-hydroperoxy adduct of Fl, FlOOH , compared to those of FlEt+ , FlEtOOH , and Fl-Enz, FlOOH-Enz. In this study, Fl incorporated into a short peptide, flavopeptide (Fl-Pep), was designed by a rational top-down approach using a computational method, which could stabilize the corresponding 4a-hydroperoxy adduct (FlOOH-Pep) through intramolecular hydrogen bonds. We report catalytic chemoselective sulfoxidation as well as Baeyer-Villiger oxidation by means of Fl-Pep under light-shielding and aerobic conditions, which are the first Fl-Enz-mimetic aerobic oxygenation reactions catalyzed by Fl under non-enzymatic conditions.

Facile Preparation of Flavinium Organocatalysts

We developed a safe, simple, inexpensive, and environmentally benign method for preparing N(5)-ethylated flavinium organocatalysts without using hazardous reagents or inert conditions as previously required. 5-Ethyl-3-methyllumiflavinium cation was prepared from its reduced form by NaNO₂ -free aerobic oxidation, which was subsequently extracted onto commercial cation-exchange resins under NaClO₄ -free conditions. The resulting resin-immobilized flavinium salts were found to be effective organocatalysts for aerobic oxidation reactions.

Biomimetic flavin-catalysed reactions for organic synthesis

Using simple riboflavin related compounds as biomimetic catalysts, catalytic oxidation of various substrates with hydrogen peroxide or molecular oxygen can be performed selectively under mild conditions. The principle of these reactions is fundamental and will provide a wide scope for environmentally benign future practical methods.

Flavin-catalyzed aerobic oxidation of sulfides and thiols with formic acid/triethylamine

An efficient and practical method for flavin-catalyzed aerobic oxidation of sulfides and thiols with formic acid/TEA is described.

Efficient and convenient oxidation of sulfides to sulfoxides with molecular oxygen catalyzed by Mn(OAc)2 in ionic liquid [C12mim][NO3]

A simple, efficient, and eco-friendly procedure for aerobic oxidation of sulfides catalyzed by Mn(OAc)₂/[C₁₂mim][NO₃] has been developed.

Oxidation of primary amines to oximes with molecular oxygen using 1,1-diphenyl-2-picrylhydrazyl and WO3/Al2O3 as catalysts

The oxidative transformation of primary amines to their corresponding oximes proceeds with high efficiency under molecular oxygen diluted with molecular nitrogen (O2/N2 = 7/93 v/v, 5 MPa) in the presence of the catalysts 1,1-diphenyl-2-picrylhydrazyl (DPPH) and tungusten oxide/alumina (WO3/Al2O3). The method is environmentally benign, because the reaction requires only molecular oxygen as the terminal oxidant and gives water as a side product. Various alicyclic amines and aliphatic amines can be converted to their corresponding oximes in excellent yields. It is noteworthy that the oxidative transformation of primary amines proceeds chemoselectively in the presence of other functional groups. The key step of the present oxidation is a fast electron transfer from the primary amine to DPPH followed by proton transfer to give the α-aminoalkyl radical intermediate, which undergoes reaction with molecular oxygen and hydrogen abstraction to give α-aminoalkyl hydroperoxide. Subsequent reaction of the peroxide with WO3/Al2O3 gives oximes. The aerobic oxidation of secondary amines gives the corresponding nitrones. Aerobic oxidative transformation of cyclohexylamines to cyclohexanone oximes is important as a method for industrial production of ε-caprolactam, a raw material for Nylon 6.

Development of biomimetic catalytic oxidation methods and non-salt methods using transition metal-based acid and base ambiphilic catalysts

This review focuses on the development of ruthenium and flavin catalysts for environmentally benign oxidation reactions based on mimicking the functions of cytochrome P-450 and flavoenzymes, and low valent transition-metal catalysts that replace conventional acids and bases. Several new concepts and new types of catalytic reactions based on these concepts are described. (Communicated by Ryoji Noyori, M.J.A.).