Fluid Characteristics of Biodiesel Produced from Palm Oil with Various Initial Water Contents

Biodiesel is regarded as a significant alternative fuel to petrodiesel due to its excellent combustion features and renewable character. The water content in the reactant mixtures needs to be considered so as to retard the conversion rate and it is suggested to be kept as low as possible. The fluid characteristics of biodiesel might be affected by initial water content; however, the optimum ratio of water content added to raw oil for achieving superior fluid characteristics of biodiesel has not yet been studied. Hence, this study empirically investigated the influences of the initial water content added to raw feedstock oil on the fluid characteristics of biodiesel. The experimental results show that an adequate amount of water content in the reactant mixture was found effective for improving the transesterification reaction and, in turn, the fluid characteristics. The biodiesel made from raw oil with 0.05 wt. % water content added was observed to bear the lowest water content, acid value, and cold filter plugging point (CFPP) and, therefore, superior fluidity at low temperatures. The lower CFPP of biodiesel is attributed to its more unsaturated fatty acids and lower iodine value. In addition, the biodiesel produced from feedstock oil with 0.02 wt. % water added was observed to have the lowest iodine value but the highest kinematic viscosity. The optimum content of initial water added to palm oil for superior fluid characteristics of the biodiesel product is thus suggested to be in the range between 0.02 wt. % and 0.05 wt. %.

Concentration of Lipase from Aspergillus oryzae Expressing Fusarium heterosporum by Nanofiltration to Enhance Transesterification

Nanofiltration membrane separation is an energy-saving technology that was used in this study to concentrate extracellular lipase and increase its total activity for biodiesel production. Lipase was produced by recombinant Aspergillus oryzae expressing Fusarium heterosporum lipase (FHL). A sulfonated polyethersulfone nanofiltration membrane, NTR-7410, with a molecular weight cut-off of 3 kDa was used for the separation, because recombinant lipase has a molecular weight of approximately 20 kDa, which differs from commercial lipase at around 30 kDa for CalleraTM Trans L (CalT). After concentration via nanofiltration, recombinant lipase achieved a 96.8% yield of fatty acid methyl ester (FAME) from unrefined palm oil, compared to 50.2% for CalT in 24 h. Meanwhile, the initial lipase activity (32.6 U/mL) of recombinant lipase was similar to that of CalT. The composition of FAME produced from recombinant concentrated lipase, i.e., C14:1, C16:0, C18:0, C18:1 cis, and C18:2 cis were 0.79%, 34.46%, 5.41%, 45.90%, and 12.46%, respectively, after transesterification. This FAME composition, even after being subjected to nanofiltration, was not significantly different from that produced from CalT. This study reveals the applicability of a simple and scalable nanofiltration membrane technology that can enhance enzymatic biodiesel production.

Lipase catalyzed epoxidation of fatty acid methyl esters derived from unsaturated vegetable oils in absence of carboxylic acid

Nowadays the industrial chemistry reactions rely on green technologies. Enzymes as lipases are increasing its use in diverse chemical processes. Epoxidized fatty acid methyl esters obtained from transesterification of vegetable oils have recently found applications as polymer plasticizer, agrochemical, cosmetics, pharmaceuticals and food additives. In this research article, grapeseed, avocado and olive oils naturally containing high percents of mono and poly unsaturations were used as starting materials for the production of unsaturated fatty acid methyl esters. The effect of lauric acid as an active oxygen carrier was studied on epoxidation reactions where unsaturated fatty acid methyl esters were converted to epoxy fatty acid methyl esters using immobilized Candida antarctica Lipase type B as catalyst and hydrogen peroxide as oxygen donor at mild temperature and pressure conditions. After this study it was confirmed by ¹H NMR, ¹³C NMR and GC–MS that the addition of lauric acid to the enzymatic reaction is unnecessary to transform the alkenes in to epoxides. It was found that quantitative conversions were possible in despite of a carboxylic acid absence.

Enzymatic Production of Biodiesel: Strategies to Overcome Methanol Inactivation

Lipase-catalyzed transesterification of triglycerides and alcohols to obtain biodiesel is an environmentally friendly and sustainable route for fuels production since, besides proceeding in mild reaction conditions, it allows for the use of low-cost feedstocks that contain water and free fatty acids, for example non-edible oils and waste oils. This review article reports recent advances in the field and focus in particular on a major issue in the enzymatic process, the inactivation of most lipases caused by methanol, the preferred acyl acceptor used for alcoholysis. The recent results about immobilization of enzymes on nano-materials and the use of whole-cell biocatalysts, as well as the use of cell-surface display technologies and metabolic engineering strategies for microbial production of biodiesel are described. It is discussed also insight into the effects of methanol on lipases obtained by modeling approaches and report on studies aimed at mining novel alcohol stable enzymes or at improving robustness in existing ones by protein engineering.