Integration of anatomical and radiological analysis suggests more segments in the human kidney

Anatomical variability of kidney arterial vasculature based on zonal and segmental topography

Introduction

To date, there is no unified approach to the lobar, zonal, and segmental structure of the kidney vasculature. There is no recognizable approach to define basic characteristics in regard to the lobes and segments identifying of the kidney. The branching of the renal artery has often been the subject of scientific research. This study aimed to analyze the arterial anatomy on the basis of zonal and segmental topography.

Materials and methods

This study is a prospective cadaver study on autopsy material using corrosion casting and CT imaging techniques. The arterial vasculature was visualized using corrosive casting. In this study, 116 vascular casts were included. We identified the number of arteries in the kidney hilum, their topography, branching variations of the renal artery, and local blood supply zones of renal masses considering second- and third-order renal artery branches. We used a micro-CT BRUKER SkyScan 1178, digital camera, Mimics-8.1, and R.

Results

This study has shown that RA divides into two or three zonal arteries, forming a two- or three-zonal vascular supply system. In the case of the two-zonal system, 54.3% of cases accounted for RA branching into ventral and dorsal arteries, whereas 15.5% of cases referred to superior polar and inferior polar zonal arteries. The three-zonal system implies 4 types of RA branching: 1) superior polar, ventral, and dorsal zonal branches (12.9%); 2) ventral, dorsal, and inferior polar zonal branches (9.5%); 3) two ventral and one dorsal zonal branches (5.2%), and 4) superior polar, central, and inferior polar zonal branches (2.5%).

Conclusions

The results of this research make us reconsider Grave's classification theory.

Application of low-dose CT to the creation of 3D-printed kidney and perinephric tissue models for laparoscopic nephrectomy

PURPOSE

The aim of this study was to explore the feasibility of 3D printing of kidney and perinephric fat based on low-dose CT technology.

PATIENTS AND METHODS

A total of 184 patients with stage T1 complex renal tumors who underwent laparoscopic nephrectomy were prospectively enrolled and divided into three groups: group A (conventional dose kidney and perinephric fat 3D printing group, n = 62), group B (low-dose kidney and perinephric fat 3D printing, n = 64), and group C (conventional dose merely kidney 3D printing group, n = 58). The effective dose (ED), signal-to-noise ratio (SNR), and contrast-to-noise ratio (CNR) were determined. The 3D printing quality was evaluated using a 4-point scale, and interobserver agreement was assessed using the intraclass correlation coefficient (ICC).

RESULTS

The ED of group B was lower than that of group A, with a decrease of 55.1%. The subjective scores of 3D printing quality in all groups were 3 or 4 points. The interobserver agreement among the three observers in 3D printing quality was good (ICC = 0.84-0.92). The perioperative indexes showed that operation time (OT), warm ischemia time (WIT), estimated blood loss (EBL), and laparoscopic partial nephrectomy (LPN) conversion to laparoscopic radical nephrectomy (LRN) in groups A or B were significantly less than those in group C. LPN was more frequent in group A and group B than in group C (all p < 0.017). There were no significant differences in perioperative indexes between group A and group B (all p > 0.017).

CONCLUSION

Low-dose CT technology can be effectively applied to 3D printing of kidney and perinephric fat and reduce the patient's radiation dose without compromising 3D printing quality. 3D printing of kidney and perinephric fat can significantly increase the success rate of LPN and decrease OT, WIT, and EBL.