Solvent- and Ligand-free Diboration of Alkynes and Alkenes Catalyzed by Platinum Nanoparticles on Titania

Porous alumina nanosheet-supported asymmetric platinum clusters for efficient diboration of alkynes

Precisely designing asymmetrical structures is an effective strategy to optimize the performance of metallic catalysts. Asymmetric Pt clusters were attached to defect-rich porous alumina nanosheets (Pt clu/dp-Al2O3) using a pyrolysis technique coupled with wet impregnation. These Pt-functionalized nanosheets feature a high concentration of active sites, demonstrating remarkable cycling performance and catalytic activity in alkyne diboration. The conversion yield and selectivity can reach up to 97% and 95%, correspondingly.

Tetraazacoronenes and Their Dimers, Trimers and Tetramers

Tetraazacoronenes were synthesized from bay-functionalized tetraazaperylenes by Zr-mediated cyclization and four-fold Suzuki-Miyaura cross coupling. In the Zr-mediated approach, an η4 -cyclobutadiene-zirconium(IV) complex was isolated as an intermediate to cyclobutene-annulated derivatives. Using bis(pinacolatoboryl)vinyltrimethylsilane as a C2 building block gave the tetraazacoronene target compound along with the condensed azacoronene dimer as well as higher oligomers. The series of extended azacoronenes show highly resolved UV/Vis absorption bands with increased extinction coefficients for the extended aromatic cores and fluorescence quantum yields of up to 80 % at 659 nm.

Stabilizing Single-Atomic Pt by Forming PtFe Bonds for Efficient Diboration of Alkynes

Precisely tailoring the oxidation state of single-atomic metal in heterogeneous catalysis is an efficient way to stabilize the single-atomic site and promote their activity, but realizing this approach remains a grand challenge to date. Herein, a class of stable single-atomic catalysts with well-tuned oxidation state of Pt by forming PtFe atomic bonds is reported, which are supported by defective Fe₂ O₃  nanosheets on reduced graphene oxide (PFARFNs). These as-synthesized materials can greatly enhance the catalytic activity, stability, and selectivity for the diboration of alkynes. The PFARFNs exhibit high conversion of 99% at 100 °C with an outstanding turnover frequency (TOF) of 545 h^-1 , and a relatively high conversion of 58% at room temperature (25 °C) with a TOF of 310 h^-1 , which has been hardly achieved previously. Through both experimental and theoretical investigation, it is demonstrated that the fast electron transfer from Fe to Pt in Fe-Pt-O atomic sites in PFARFNs can not only stabilize the single-atomic Pt, but also significantly improve their catalytic activity.

Selective, Transition Metal-free 1,2-Diboration of Alkyl Halides, Tosylates, and Alcohols

Defunctionalization of readily available feedstocks to provide alkenes for the synthesis of multifunctional molecules represents an extremely useful process in organic synthesis. Herein, we describe a transition metal-free, simple and efficient strategy to access alkyl 1,2-bis(boronate esters) via regio- and diastereoselective diboration of secondary and tertiary alkyl halides (Br, Cl, I), tosylates, and alcohols. Control experiments demonstrated that the key to this high reactivity and selectivity is the addition of a combination of potassium iodide and N,N-dimethylacetamide (DMA). The practicality and industrial potential of this transformation are demonstrated by its operational simplicity, wide functional group tolerance, and the late-stage modification of complex molecules. From a drug discovery perspective, this synthetic method offers control of the position of diversification and diastereoselectivity in complex ring scaffolds, which would be especially useful in a lead optimization program.

Directed cis-hydrosilylation of borylalkynes to borylsilylalkenes

Directed by the choice of catalyst cis-hydrosilylation of borylalkynes leads to novel borylsilylalkenes which are crucial synthons for the introduction of the carbon–carbon double bonds in organic synthesis.

Fabricating polyoxometalates-stabilized single-atom site catalysts in confined space with enhanced activity for alkynes diboration

Effecting the synergistic function of single metal atom sites and their supports is of great importance to achieve high-performance catalysts. Herein, we successfully fabricate polyoxometalates (POMs)-stabilized atomically dispersed platinum sites by employing three-dimensional metal-organic frameworks (MOFs) as the finite spatial skeleton to govern the accessible quantity, spatial dispersion, and mobility of metal precursors around each POM unit. The isolated single platinum atoms (Pt₁) are steadily anchored in the square-planar sites on the surface of monodispersed Keggin-type phosphomolybdic acid (PMo) in the cavities of various MOFs, including MIL-101, HKUST-1, and ZIF-67. In contrast, either the absence of POMs or MOFs yielded only platinum nanoparticles. Pt₁-PMo@MIL-101 are seven times more active than the corresponding nanoparticles in the diboration of phenylacetylene, which can be attributed to the synergistic effect of the preconcentration of organic reaction substrates by porous MOFs skeleton and the decreased desorption energy of products on isolated Pt atom sites.

It is of great significance to exert the synergistic effect between single atom and support. Here, the authors prepare polyoxometalates-stabilized single-atom site catalysts in confined space with enhanced activity for alkynes diboration.

Diastereoselective Diboration of Cyclic Alkenes: Application to the Synthesis of Aristeromycin

The Pt-catalyzed diboration of cyclic alkenes is extended to unsaturated heterocycles and bicyclic compounds and can be accomplished in a diastereoselective fashion. The optimal procedures, substrate scope, and diastereoselectivity were investigated, and examples employing both homogeneous and heterogeneous catalysis were examined. Lastly, application to the construction of the nucleoside analog (±)-aristeromycin was conducted.

A general strategy to prepare atomically dispersed biomimetic catalysts based on host-guest chemistry

Herein, we report a general strategy based on host-guest interactions to fabricate atomically dispersed biomimetic catalysts, which were evaluated by diboration of phenylacetylene. The structure and function of these mimics are quite similar to those of enzymes, namely, the atomically dispersed metal serves as an active site, the external macromolecular structure plays a role as an enzyme catalytic pocket to stabilize the reaction intermediates and the interactions between the intermediates and functional groups near to the active site can reduce the reaction activation energy.

Aminoazanium of DABCO: An Amination Reagent for Alkyl and Aryl Pinacol Boronates

The aminoazanium of DABCO (H₂ N-DABCO) has been developed as a general and practical amination reagent for the direct amination of alkyl and aryl pinacol boronates. This compound is stable and practical for use as a reagent. Various primary, secondary. and tertiary alkyl-Bpin and aryl-Bpin substrates were aminated to give the corresponding amine derivatives. The amination is stereospecific. The anti-Markovnikov hydroamination of olefins was easily achieved by catalytic hydroboration with HBpin and in subsequent situ amination using H₂ N-DABCO. Moreover, the combination of 1,2-diboration of olefins, using B₂ pin₂ , with this amination process achieved the unprecedented 1,2-diamination of olefins. The amination protocol was also successfully extended to aryl pinacol boronates.

Metal catalyst-free photo-induced alkyl C–O bond borylation

Tertiary alkyl boronates were prepared via the C–O bond borylation of the corresponding oxalates under catalyst-free/(DMF)₂–B₂cat₂ initiated visible light-induced conditions.

Atomic-dispersed platinum anchored on porous alumina sheets as an efficient catalyst for diboration of alkynes

An atomic-dispersed Pt catalyst (Pt/dp-Al₂O₃) was fabricated via a simple wet impregnation method and demonstrated to be highly active and stable for the diboration of phenylacetylene, which is due to Pt/dp-Al₂O₃ providing unique catalytic sites.

A greener catalyst for hydroboration of imines-external electric field modify the reaction mechanism

Usually, an extra catalyst (for example, the transition metal complexes) need to be used in catalyzing hydroboration, which involved the cost, environment, and so forth. Here, a greener and controllable catalyst-external electric field (EEF) was used to study its effect on hydroboration of N-(4-methylbenzyl)aniline (PhN═CHPhMe) with pinacolboane (HBPin). The results demonstrated that EEF could affect the barrier heights of both two pathways of this reaction. More significantly, flipping the direction of EEF could modify the reaction mechanism to induce a dominant inverse hydroboration at some field strength. That is to say, oriented EEF is a controlling switch for the anti- or Markovnikov hydroboration reaction of imines. This investigation is meaningful for the exploration of greener catalyst for chemistry reaction and guide a new method for the Markovnikov hydroboration addition. © 2019 Wiley Periodicals, Inc.

Copper-Catalyzed Trifunctionalization of Alkynes: Rapid Formation of Oxindoles Bearing Geminal Diboronates

A copper-catalyzed trifunctionalization of alkynes that provides rapid access to oxindoles bearing a geminal diboronate side chain, highlighted by the simultaneous formation of one C-C bond and two C-B bonds, is reported. This new reaction features simple reaction conditions (ligand-free catalysis), a general substrate scope, and excellent chemoselectivity. Mechanistic study revealed a reaction sequence constituted by, in the order, borylation, intramolecular cross-coupling, hydroboration, which has been rarely documented.

Cation vacancy stabilization of single-atomic-site Pt1/Ni(OH)x catalyst for diboration of alkynes and alkenes

Development of single-atomic-site catalysts with high metal loading is highly desirable but proved to be very challenging. Although utilizing defects on supports to stabilize independent metal atoms has become a powerful method to fabricate single-atomic-site catalysts, little attention has been devoted to cation vacancy defects. Here we report a nickel hydroxide nanoboard with abundant Ni²⁺ vacancy defects serving as the practical support to achieve a single-atomic-site Pt catalyst (Pt₁/Ni(OH)_x) containing Pt up to 2.3 wt% just by a simple wet impregnation method. The Ni²⁺ vacancies are found to have strong stabilizing effect of single-atomic Pt species, which is determined by X-ray absorption spectrometry analyses and density functional theory calculations. This Pt₁/Ni(OH)_x catalyst shows a high catalytic efficiency in diboration of a variety of alkynes and alkenes, yielding an overall turnover frequency value upon reaction completion for phenylacetylene of ~3000 h^-1, which is much higher than other reported heterogeneous catalysts.

A nano-catalytic approach for C–B bond formation reactions

Nanoparticle-catalysed borylation is one of the most convenient methods for the synthesis of organoboranes to overcome the confines of homogeneous catalysis such as recyclability and heavy metal contamination.

Substrate-Assisted, Transition-Metal-Free Diboration of Alkynamides with Mixed Diboron: Regio- and Stereoselective Access to trans-1,2-Vinyldiboronates

A substrate-assisted diboration of alkynamides using the unsymmetrical pinacolato-1,8-diaminonaphthalenato diboron (pinBBdan) is described. The transition-metal-free reaction proceeds in a regio- and stereoselective fashion to exclusively afford trans-vinyldiboronates in good to excellent yields. Notably, Bdan and Bpin are installed on the α- and β-carbon atoms, respectively.

Synthesis of 1-Amino-1H-Indenes via a Sequential Suzuki-Miyaura Coupling/Petasis Condensation Sequence

An efficient and straightforward synthesis of 1-amino-1H-indenes is reported from 1,2-bis(boronates) via a sequential Suzuki-Miyaura coupling/Petasis cyclization reaction. Starting from the same monoboronic ester intermediates, an intermolecular version of this approach also afforded (Z)-α,β-unsaturated amino esters in moderate to good yields.

Transition-metal-free PhI(OAc)2-promoted highly selective hydroboration of terminal alkynes under air

A new transition-metal-free PhI(OAc)₂-promoted highly selective hydroboration of terminal alkynes with bis(pinacolato)diboron has been developed at room temperature under air.

Formation of C–C, C–S and C–N bonds catalysed by supported copper nanoparticles

Copper nanoparticles on different supports are effective reusable catalysts for the palladium- and ligand-free coupling of aryl halides with alkynes, thiols and azoles.

Catalytic and catalyst-free diboration of alkynes

The present review provides a comprehensive summary of the catalytic and catalyst-free diboration of alkynes.

Diboron(4) Compounds: From Structural Curiosity to Synthetic Workhorse

Although known for over 90 years, only in the past two decades has the chemistry of diboron(4) compounds been extensively explored. Many interesting structural features and reaction patterns have emerged, and more importantly, these compounds now feature prominently in both metal-catalyzed and metal-free methodologies for the formation of B-C bonds and other processes.

An experimental and theoretical study into the facile, homogenous (N-heterocyclic carbene)2-Pd(0) catalyzed diboration of internal and terminal alkynes

Pd(ITMe)₂(PhCCPh) is a pre-catalyst in the unprecedented homogenous catalyzed diboration of terminal and internal alkynes.