Voltammetry in Two‐Electrode Mode for Rapid Electrochemical Screening Using a Fully Printed and Flexible Multiplexer Sensor

Theoretical Framework and Guidelines for the Cyclic Voltammetry of Closed Bipolar Cells

Closed bipolar cells (cBPCs) can offer valuable platforms for the development of electrochemical sensors. On the other hand, such systems are more intricate to model and interpret than conventional systems with a single polarizable interface, with the applied potential "splitting" into two polarized interfaces where two coupled charge transfers take place concomitantly. As a result, the voltammetry of cBPCs shows peculiarities that can be misleading if analyzed under the framework of classic electrochemical cells. In this work, rigorous mathematical solutions are deduced for the cyclic voltammetry (CV) of cBPCs, including the current-potential response, the interfacial potentials, and the interfacial redox concentrations. With such theoretical tools, a comprehensive view of the behavior of cBPCs can be gained, and adequate diagnosis criteria are established on the basis of the shape, magnitude, and position of the CV signal as a function of the scan rate and of the experimental conditions in the anodic and cathodic compartments.

Rapid Electrochemical Flow Analysis of Urinary Creatinine on Paper: Unleashing the Potential of Two-Electrode Detection

The development of low-cost, disposable electrochemical sensors is an essential step in moving traditionally inaccessible quantitative diagnostic assays toward the point of need. However, a major remaining limitation of current technologies is the reliance on standardized reference electrode materials. Integrating these reference electrodes considerably restricts the choice of the electrode substrate and drastically increases the fabrication costs. Herein, we demonstrate that adoption of two-electrode detection systems can circumvent these limitations and allow for the development of low-cost, paper-based devices. We showcase the power of this approach by developing a continuous flow assay for urinary creatinine enabled by an embedded graphenic two-electrode detector. The detection system not only simplifies sensor fabrication and readout hardware but also provides a robust sensing performance with high detection efficiencies. In addition to enabling high-throughput analysis of clinical urine samples, our two-electrode sensors provide unprecedented insights into the fundamental mechanism of the ferricyanide-mediated creatinine reaction. Finally, we developed a simplified circuitry to drive the detector. This forms the basis of a smart reader that guides the user through the measurement process. This study showcases the potential of affordable capillary-driven cartridges for clinical analysis within primary care settings.

Functionalisation of Electrospun Cellulose Acetate Membranes with PEDOT and PPy for Electronic Controlled Drug Release

Controlled drug release via electrical stimulation from drug-impregnated fibres was studied using electrospun cellulose acetate (CA) membranes and encapsulated ibuprofen (IBU). This research outlines the influence of polypyrrole (PPy) and poly(3,4-ethylenedioxythiophene) (PEDOT)-functionalised CA membranes and their suitability for dermal electronic-controlled drug release. Micro Raman analysis confirmed polymer functionalisation of CA membranes and drug incorporation. Scanning electron microscopy (SEM) images evidenced the presence of PPy and PEDOT coatings. The kinetic of drug release was analysed, and the passive and active release was compared. In the proposed systems, the drug release is controlled by very low electrical potentials. A potential of -0.3 V applied to membranes showed the ibuprofen retention, and a positive potential of +0.3 V, +0.5 V, or +0.8 V, depending on the conductive polymer and membrane configuration, enhanced the drug release. A small adhesive patch was constructed to validate this system for cutaneous application and verified an "ON/OFF" ibuprofen release pattern from membranes.