Red-light sensitized hole-conducting polymer for energy conversion

We report a novel hole conductive polymer with photoactive Os(ii) complexes in the side chains. This PPV derivative can be activated upon absorption of red visible light and delivers notable photocurrents when used as photocathode material. Thus, the polymer presents as a stepping stone towards developing soft matter alternatives to NiO photocathodes, which function under visible light irradiation. To show the concept we combine electrical impedance spectroscopy with steady state spectroscopy. As light-driven hole injection from Os complex to the PPV polymer is thermodynamically feasible both based on reductive quenching of photoexcited PPV and based on oxidative quenching of the photoexcited Os chromophores we investigate the impact of illumination wavelengths on the photocathode behavior and photochemical stability of the material. While both blue and red light excitation, i.e., excitation of the chromophoric units PPV and excitation of the metal-to-ligand charge transfer transitions in the side-chain pendant Os chromophores yield cathodic photocurrents, the photochemical stability is drastically enhanced upon red-light excitation. Hence, the results of the investigations discussed show the validity of the concept developing red-light sensitized hole-conducting polymers for energy conversion.

Proton-Coupled Electron Transfer for Photoinduced Generation of Two-Electron Reduced Species of Quinone

Purpose-built molecules that follow the fundamental process of photosynthesis have significance in developing better insight into the natural photosynthesis process. Quinones have a significant role as electron acceptors in natural photosynthesis, and their reduction is assisted through H-bond donation or protonation. The major challenge in such studies is to couple the multielectron and proton-transfer process and to achieve a reasonably stable charge-separated state for the elucidation of the mechanistic pathway. We have tried to address this issue through the design of a donor-acceptor-donor molecular triad (2RuAQ) derived from two equivalent [Ru(bpy)₃]²⁺ derivatives and a bridging anthraquinone moiety (AQ). Photoinduced proton-coupled electron transfer (PCET) for this molecular triad was systematically investigated in the absence and presence of hexafluoroisopropanol and p-toluenesulfonic acid (PTSA) using time-resolved absorption spectroscopy in the ultrafast time domain. Results reveal the generation of a relatively long-lived charge-separated state in this multi-electron transfer reaction, and we could confirm the generation of AQ^2- and Ru^III as the transient intermediates. We could rationalize the mechanistic pathway and the dynamics associated with photoinduced processes and the role of H-bonding in stabilizing charge-separated states. Transient absorption spectroscopic studies reveal that the rates of intramolecular electron transfer and the mechanistic pathways associated with the PCET process are significantly different in different solvent compositions having different polarities. In acetonitrile, a concerted PCET mechanism prevails, whereas the stepwise PCET reaction process is observed in the presence of PTSA. The results of the present study represent a unique model for the mechanistic diversity of PCET reactions.

Introducing the concept of pulsed vapor phase copper-free surface click-chemistry using the ALD technique

We report for the first time on a pulsed vapor phase copper-free azide-alkyne click reaction on ZnO by using the atomic layer deposition (ALD) process technology. This reproducible and fast method is based on an in situ two-step reaction consisting of sequential exposures of ZnO to propiolic acid and benzyl azide.

Development of type-I/type-II hybrid dye sensitizer with both pyridyl group and catechol unit as anchoring group for type-I/type-II dye-sensitized solar cell

A type-I/type-II hybrid dye sensitizer with a pyridyl group and a catechol unit as the anchoring group has been developed and its photovoltaic performance in dye-sensitized solar cells (DSSCs) is investigated. The sensitizer has the ability to adsorb on a TiO₂ electrode through both the coordination bond at Lewis acid sites and the bidentate binuclear bridging linkage at Brønsted acid sites on the TiO₂ surface, which makes it possible to inject an electron into the conduction band of the TiO₂ electrode by the intramolecular charge-transfer (ICT) excitation (type-I pathway) and by the photoexcitation of the dye-to-TiO₂ charge transfer (DTCT) band (type-II pathway). It was found that the type-I/type-II hybrid dye sensitizer adsorbed on TiO₂ film exhibits a broad photoabsorption band originating from ICT and DTCT characteristics. Here we reveal the photophysical and electrochemical properties of the type-I/type-II hybrid dye sensitizer bearing a pyridyl group and a catechol unit, along with its adsorption modes onto TiO₂ film, and its photovoltaic performance in type-I/type-II DSSC, based on optical (photoabsorption and fluorescence spectroscopy) and electrochemical measurements (cyclic voltammetry), density functional theory (DFT) calculation, FT-IR spectroscopy of the dyes adsorbed on TiO₂ film, photocurrent-voltage (I-V) curves, incident photon-to-current conversion efficiency (IPCE) spectra, and electrochemical impedance spectroscopy (EIS) for DSSC.

Characterizing the Solvated Structure of Photoexcited [Os(terpy)₂](2+) with X-ray Transient Absorption Spectroscopy and DFT Calculations

Characterizing the geometric and electronic structures of individual photoexcited dye molecules in solution is an important step towards understanding the interfacial properties of photo-active electrodes. The broad family of “red sensitizers” based on osmium(II) polypyridyl compounds often undergoes small photo-induced structural changes which are challenging to characterize. In this work, X-ray transient absorption spectroscopy with picosecond temporal resolution is employed to determine the geometric and electronic structures of the photoexcited triplet state of [Os(terpy)₂]²⁺ (terpy: 2,2′:6′,2″-terpyridine) solvated in methanol. From the EXAFS analysis, the structural changes can be characterized by a slight overall expansion of the first coordination shell [OsN₆]. DFT calculations supports the XTA results. They also provide additional information about the nature of the molecular orbitals that contribute to the optical spectrum (with TD-DFT) and the near-edge region of the X-ray spectra.

Effect of Substituents in Catechol Dye Sensitizers on Photovoltaic Performance of Type II Dye-Sensitized Solar Cells

In order to provide a direction in molecular design of catechol (Cat) dyes for type II dye-sensitized solar cells (DSSCs), the dye-to-TiO2 charge-transfer (DTCT) characteristics of Cat dyes with various substituents and their photovoltaic performance in DSSCs are investigated. The Cat dyes with electron-donating or moderately electron-withdrawing substituents exhibit a broad absorption band corresponding to DTCT upon binding to TiO2 films, whereas those with strongly electron-withdrawing substituents exhibit weak DTCT. This study indicates that the introduction of a moderately electron-withdrawing substituent on the Cat moiety leads to not only an increase in the DTCT efficiency, but also the retardation of back electron transfer. This results in favorable conditions for the type II electron-injection pathway from the ground state of the Cat dye to the conduction band of the TiO2 electrode by the photoexcitation of DTCT bands.

Extensive reduction in back electron transfer in twisted intramolecular charge-transfer (TICT) coumarin-dye-sensitized TiO(2) nanoparticles/film: a femtosecond transient absorption study

We report the synthesis, characterization, and optical and electrochemical properties of two structurally similar coumarin dyes (C1 and C2). These dyes have been deployed as sensitizers in TiO2 nanoparticles and thin films, and the effect of molecular structure on interfacial electron-transfer dynamics has been studied. Steady-state optical absorption, emission, and time-resolved emission studies on both C1 and C2, varying the polarity of the solvent and the solution pH, suggest that both photoexcited dyes exist in a locally excited (LE) state in solvents of low polarity. In highly polar solvents, however, C1 exists in an intramolecular charge-transfer (ICT) state, whereas C2 exists in both ICT and twisted intramolecular charge-transfer (TICT) states, their populations depending on the degree of polarity of the solvent and the pH of the solution. We have employed femtosecond transient absorption spectroscopy to monitor the charge-transfer dynamics in C1- and C2-sensitized TiO2 nanoparticles and thin films. Electron injection has been confirmed by direct detection of electrons in the conduction band of TiO2 nanoparticles and of radical cations of the dyes in the visible and near-IR regions of the transient absorption spectra. Electron injection in both the C1/TiO2 and C2/TiO2 systems has been found to be pulse-width limited (<100 fs); however, back-electron-transfer (BET) dynamics has been found to be slower in the C2/TiO2 system than in the C1/TiO2 system. The involvement of TICT states in C2 is solely responsible for the higher electron injection yield as well as the slower BET process compared to those in the C1/TiO2 system. Further pH-dependent experiments on C1- and C2-sensitized TiO2 thin films have corroborated the participation of the TICT state in the slower BET process in the C2/TiO2 system.

Design of Os(II) -based sensitizers for dye-sensitized solar cells: influence of heterocyclic ancillaries

A series of Os(II) sensitizers (TFOS-x, in which x=1, 2, or 3) with a single 4,4'-dicarboxy-2,2'-dipyridine (H2 dcbpy) anchor and two chelating 2-pyridyl (or 2-pyrimidyl) triazolate ancillaries was successfully prepared. Single-crystal X-ray structural analysis showed that the core geometry of the Os(II) -based sensitizers consisted of one H2 dcbpy unit and two eclipsed cis-triazolate fragments; this was notably different from the Ru(II) -based counterparts, in which the azolate (both pyrazolate and triazolate) fragments are located at the mutual trans-positions. The basic properties were extensively probed by using spectroscopic and electrochemical methods as well as time-dependent density functional theory (TD-DFT) calculations. Fabrication of dye-sensitized solar cells (DSCs) was then attempted by using the I(-) /I3 (-) -based electrolyte solution. One such DSC device, which utilized TFOS-2 as the sensitizer, showed promising performance characteristics with a short-circuit current density (JSC ) of 15.7 mA cm(-2) , an open-circuit voltage of 610 mV, a fill factor of 0.63, and a power conversion efficiency of 6.08 % under AM 1.5G simulated one-sun irradiation. Importantly, adequate incident photon-to-current conversion efficiency performances were observed for all TFOS derivatives over the wide spectral region of 450 to 950 nm, showing a panchromatic light harvesting capability that extended into the near-infrared regime. Our results underlined a feasible strategy for maximizing JSC and increasing the efficiency of DSCs.

Catechol-based biomimetic functional materials

Catechols are found in nature taking part in a remarkably broad scope of biochemical processes and functions. Though not exclusively, such versatility may be traced back to several properties uniquely found together in the o-dihydroxyaryl chemical function; namely, its ability to establish reversible equilibria at moderate redox potentials and pHs and to irreversibly cross-link through complex oxidation mechanisms; its excellent chelating properties, greatly exemplified by, but by no means exclusive, to the binding of Fe(3+); and the diverse modes of interaction of the vicinal hydroxyl groups with all kinds of surfaces of remarkably different chemical and physical nature. Thanks to this diversity, catechols can be found either as simple molecular systems, forming part of supramolacular structures, coordinated to different metal ions or as macromolecules mostly arising from polymerization mechanisms through covalent bonds. Such versatility has allowed catechols to participate in several natural processes and functions that range from the adhesive properties of marine organisms to the storage of some transition metal ions. As a result of such an astonishing range of functionalities, catechol-based systems have in recent years been subject to intense research, aimed at mimicking these natural systems in order to develop new functional materials and coatings. A comprehensive review of these studies is discussed in this paper.

Complex Förster energy transfer interactions between semiconductor quantum dots and a redox-active osmium assembly

The ability of luminescent semiconductor quantum dots (QDs) to engage in diverse energy transfer processes with organic dyes, light-harvesting proteins, metal complexes, and redox-active labels continues to stimulate interest in developing them for biosensing and light-harvesting applications. Within biosensing configurations, changes in the rate of energy transfer between the QD and the proximal donor, or acceptor, based upon some external (biological) event form the principle basis for signal transduction. However, designing QD sensors to function optimally is predicated on a full understanding of all relevant energy transfer mechanisms. In this report, we examine energy transfer between a range of CdSe-ZnS core-shell QDs and a redox-active osmium(II) polypyridyl complex. To facilitate this, the Os complex was synthesized as a reactive isothiocyanate and used to label a hexahistidine-terminated peptide. The Os-labeled peptide was ratiometrically self-assembled to the QDs via metal affinity coordination, bringing the Os complex into close proximity of the nanocrystal surface. QDs displaying different emission maxima were assembled with increasing ratios of Os-peptide complex and subjected to detailed steady-state, ultrafast transient absorption, and luminescence lifetime decay analyses. Although the possibility exists for charge transfer quenching interactions, we find that the QD donors engage in relatively efficient Förster resonance energy transfer with the Os complex acceptor despite relatively low overall spectral overlap. These results are in contrast to other similar QD donor-redox-active acceptor systems with similar separation distances, but displaying far higher spectral overlap, where charge transfer processes were reported to be the dominant QD quenching mechanism.

Sequential Energy and Electron Transfer in Polynuclear Complex Sensitized TiO2 Nanoparticles

Polynuclear-polypyridyl complexes exhibit a directional energy-transfer property that can improve their photosensitization activity. In the present work, the energy-transfer process is explored in a trinuclear Ru2(∧)Os1 complex using transient absorption spectroscopy. This study reveals an efficient excitation energy transfer from the terminal (Ru(II) complex) to the core (Os(II) complex) region in the ultrafast time domain (400 fs-40 ps). The excitation energy funnel is useful in improving the functionalized core activity. This is evidenced in an interfacial electron-transfer study of Ru2(∧)Os1, Ru2(∧)Ru1, and Os1 complex sensitized TiO2 nanoparticle (TiO2 NP) systems. The intramolecular energy transfer causes sequential excitation of the core part of the Ru2(∧)Os1 complex, which leads to multiexponential electron injection into TiO2 NP. Besides this, the electronic coupling between the metal ion centers stabilizes the positive charge within the trinuclear complex, which results in a slow charge recombination reaction. This study shows that polynuclear complexes can be very useful for their panchromatic effects, unidirectional energy- and electron-transfer properties.

Enantioselective total synthesis of (+)-galbulin via organocatalytic domino Michael-Michael-aldol condensation

A concise and practical enantioselective synthesis of (+)-galbulin has been achieved using organocatalytic domino Michael-Michael-aldol condensation and organocatalytic kinetic resolution as the key steps.