Anthraquinone Sulfonate Modified, Layered Double Hydroxide Nanosheets for Dye-Sensitized Solar Cells

Incorporation of Photo- and Thermoresponsive N-Salicylidene Aniline Derivatives into Cobalt and Zinc Layered Hydroxides

In search of new multifunctional hybrid materials and in order to investigate the influence of chemical modification on the possible synergy between properties, the carboxylate and sulfonate derivatives of photo- and thermochromic N-salicylidene aniline were successfully inserted into Co(II)- and Zn(II)-based layered simple hydroxides, resulting in four novel hybrids: Co-N-Sali-COO, Co-N-Sali-SO3, Zn-N-Sali-COO, and Zn-N-Sali-SO3. All synthesized hybrids adopt a double organic layered configuration, which prevents the cis-trans photoisomerization ability of N-Sali-R molecules in the hybrids. However, the Zn hybrids exhibit fluorescence upon exposure to UV light due to the excited-state intramolecular proton transfer (ESIPT) mechanism. The thermally stimulated keto-enol tautomerization of N-salicylidene aniline in the hybrids was related with the changes in interlamellar spacings observed by temperature-dependent PXRD. This tautomerization process was prominently evident in the Co-N-Sali-SO3 hybrid (about 11% increase in d-spacing upon decreasing the temperature to -180 °C). Finally, the Co-N-Sali-R hybrids exhibit the typical magnetic behavior associated with Co(II)-based LSHs (ferrimagnetic ordering at TN = 6.8 and 7.7 K for Co-N-Sali-COO and Co-N-Sali-SO3, respectively). This work offers insights into isomerization in LSHs and the ESIPT mechanism's potential in new luminescent materials and prospects for designing new multifunctional materials.

Exfoliated Single Layers of Layered Cobalt Hydroxide for Ultrafine Co3 O4 Nanoparticles on Graphene Nanosheets as an Efficient Electrocatalyst for Oxygen Reduction

A highly effective way to produce an oxygen reduction electrocatalyst was developed through the self-assembly of exfoliated single layers of cobalt hydroxide (Co(OH)₂ ) and graphene oxide (GO). These 2D materials have complete contact with one another because of their physical flexibility and the electrostatic attraction between negatively charged GO and positively charged Co(OH)₂ layers. The strong coupling induces transformation of the Co(OH)₂ single layer into a discrete nanocrystal of spinel Co₃ O₄ with an average size of 8 nm on reduced GO (RGO) during calcination, which could not be obtained with bulk-layered cobalt hydroxide because of its rapid layer collapse. The ultrafine Co₃ O₄ /RGO hybrid exhibited not only comparable performance in the oxygen reduction reaction but also higher durability compared with the commercial 20 wt % Pt/C catalyst.

Preparation of Photoactive Transition-Metal Layered Double Hydroxides (LDH) to Replace Dye-Sensitized Materials in Solar Cells

This work highlights the use of Fe-modified MgAl-layered double hydroxides (LDHs) to replace dye and semiconductor complexes in dye-sensitized solar cells (DSSCs), forming a layered double hydroxide solar cell (LDHSC). For this purpose, a MgAl-LDH and a Fe-modified MgAl LDH were prepared. X-ray diffraction spectroscopy (XRD), scanning electron microscopy (SEM), and energy-dispersive X-ray (EDX) spectroscopy were used to analyze the structural properties, morphology, and success of the Fe-modification of the synthesized LDHs. Ultraviolet-visible (UV-Vis) absorption spectroscopy was used to analyze the photoactive behavior of these LDHs and compare it to that of TiO2 and dye-sensitized TiO2. Current-voltage (I-V) solar simulation was used to determine the fill factor (FF), open circuit voltage (VOC), short circuit current (ISC), and efficiency of the LDHSCs. It was shown that the MgFeAl-LDH can act as a simultaneous photoabsorber and charge separator, effectively replacing the dye and semiconductor complex in DSSCs and yielding an efficiency of 1.56%.

Hierarchical self-supported ZnAlEu LDH nanotubes hosting luminescent CdTe quantum dots

Self-assembled, cylindrical LDH nanotubes (∅ 20nm) host large species such as nanodots or bulky substrates in their central cavity, leaving the interlayer space available for anionic sensitizer molecules.

Controlling the fluorescence behavior of 1-pyrenesulfonate by cointercalation with a surfactant in a layered double hydroxide

Zn-Al layered double hydroxides (LDHs) containing solely 1-pyrenesulfonate (PS) or 1-heptanesulfonate (HS) anions, or a mixture of the two with HS/PS molar ratios ranging between ca. 7.5 and 82, were prepared by the direct synthesis method and characterized by powder X-ray diffraction, thermal and elemental analyses, scanning electron microscopy, and FT-IR, FT-Raman, and (13)C{(1)H} CP MAS NMR spectroscopies. Well-ordered intercalates were obtained with basal spacings of 18.8 Å for the LDH intercalated by PS and 19.2-19.4 Å for the other materials containing HS. The photophysics of the solids, as well as the PS probe dissolved in water and common organic solvents (aiming to compare the behavior of the "isolated" molecule with that in the solid), were investigated by steady-state and time-resolved fluorescence techniques. The fluorescence spectra of the solid samples display two bands with maxima at 376 and 495 nm. Depending on the HS/PS ratios, the band intensity ratio (obtained at 375 and 520 nm) changes, reflecting different contributions from monomer and dimer species. The decays collected at 375 nm are biexponentials with a major component (∼97% of the total fluorescence) of 105 ns for the highest HS/PS ratio, which further loses importance with an increase in the PS content. When the decays are collected at 480 and 520 nm, the fits are triexponentials with a major component varying from 108 to 124 ns, attributed to an excimer. Steady-state and time-resolved measurements with PS in solution (ethanol, methanol, DMF, DMSO, and water) were also measured, and a comparison of the vibronic I1/I3 ratio and lifetimes in water (65 ns) with those in the LDHs indicates that the PS probe in the cointercalated LDHs is surrounded by the HS surfactant.