Extraction of Graphene Nanostructures from Colocasia esculenta and Nelumbo nucifera Leaves and Surface Functionalization with Tin Oxide: Evaluation of Their Antibacterial Properties

Use of Few-Layer Graphene Synthesized under Conditions of Self-Propagating High-Temperature Synthesis for Supercapacitors Applications

Graphene nanostructures (GNSs) are among the most promising materials for producing supercapacitors. However, GNSs are still not used in creating supercapacitors due to the impossibility of obtaining large volumes of high-quality material at an acceptable cost. In our previous works, we have shown the possibility of synthesizing large volumes of few-layer graphene (FLG, the number of layers is not more than five) from cyclic biopolymers under conditions of self-propagating high-temperature synthesis (SHS). Using the SHS process makes it possible to synthesize large volumes of FLG without Stone-Wales defects. This work is devoted to the study of the possibility of using FLG synthesized under the conditions of the SHS process in the creation of supercapacitors. It was found that the synthesized FLG makes it possible to obtain better results than using classical materials, namely activated carbon (AC). It was found that the sample based on FLG had a higher specific capacitance of 65 F × g-1 compared to the sample from AC, the specific capacitance of which was 35 F × g-1; for a speed of 5 mV × s-1, these values were170 and 64 F × g-1, respectively. The drop in capacitance over 1000 cycles was 4%, indicating a sufficiently high FLG stability, allowing us to consider FLG as a prospective material for use in supercapacitors.

Efficient Removal of Phosphate from Wastewater by a Novel Phyto-Graphene Composite Derived from Palm Byproducts

The increased demand for clean water especially in overpopulated countries is of great concern; thus, the development of eco-friendly and cost-effective techniques and materials that can remediate polluted water for possible reuse in agricultural purposes can offer a life-saving solution to improve human welfare, especially in view of climate change impacts. In the current study, the agricultural byproducts of palm trees have been used for the first time as a carbon source to produce graphene functionalized with ferrocene in a composite form to enhance its water treatment potential. Scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy, X-ray diffraction (XRD), ultraviolet-visible, Fourier transform infrared spectroscopy, zeta potential, thermogravimetric analysis, and Raman techniques have been used to characterize the produced materials. SEM investigations confirmed the formation of multiple sheets of the graphene composite. Data collected from the zeta potential revealed that graphene was supported with a negative surface charge that maintains its stability while XRD elucidated that graphene characteristic peaks were evident at 2θ = 22.4 and 22.08° using palm leaves and fibers, respectively. Batch adsorption experiments were conducted to find out the most suitable conditions to remove PO₄ ^3- from wastewater by applying different parameters, including pH, adsorbent dose, initial concentration, and time. Their effect on the adsorption process was also investigated. Results demonstrated that the best adsorption capacity was 58.93 mg/g (removal percentage: 78.57%) using graphene derived from palm fibers at 15 mg L^-1 initial concentration, pH = 3, dose = 10 mg, and 60 min contact time. Both linear and non-linear forms of kinetic and isotherm models were investigated. The adsorption process obeyed the pseudo-second-order kinetic model and was well fitted to the Langmuir isotherm.