New Fluorescent Conjugates Displaying Solvatochromic Properties

The solvent-regulated excited state reaction mechanism of 2-(2'-hydroxyphenyl)benzothiazole aggregates

The excited state relaxation dynamics of 2-(2'-hydroxyphenyl)benzothiazole (HBT) in the gas phase and the solvents have been explored experimentally and theoretically. However, the fundamental mechanism of its emission in aggregates is still unexplored. In this article, we have presented a detail investigation of solvent-regulated excited state (ES) reactions for HBT aggregates with the aid of several experimental and theoretical research. The careful investigation of solvatochromic and electrochemical behavior elucidates that the emission around 460 nm of HBT in DMSO and DMSO-water fraction correspond to the excited state internal charge transfer (ESICT). The quantum chemical analysis further supports this observation. The concentration-dependent 1H NMR and emission studies of HBT in DMSO revealed the formation of aggregates at higher concentrations that facilitate the charge transfer. The emission pattern of HBT in the AcN-water fraction demonstrates that the sequential internal charge transfer-proton transfer (ESICT-ESIPT) occurs in HBT aggregates. The pH studies show that HBT aggregates are potential ratiometric sensors for near-physiological pH ranges. Moreover, a ground-state zwitterionic conformation of HBT is observed in the basic medium formed by ground-state internal proton transfer (GSIPT). Overall, this study provides a better understanding of solvent-regulated ES reaction mechanism in the case of HBT aggregates and other substituted HBT compound aggregates published previously.

Water-Soluble Single-Benzene Chromophores: Excited State Dynamics and Fluorescence Detection

Two water-soluble single-benzene-based chromophores, 2,5-di(azetidine-1-yl)-tereph- thalic acid (DAPA) and its disodium carboxylate (DAP-Na), were conveniently obtained. Both chromophores preserved moderate quantum yields in a wide range of polar and protonic solvents. Spectroscopic studies demonstrated that DAPA exhibited red luminescence as well as large Stokes shift (>200 nm) in aqueous solutions. Femtosecond transient absorption spectra illustrated quadrupolar DAPA usually involved the formation of an intramolecular charge transfer state. Its Frank−Condon state could be rapidly relaxed to a slight symmetry-breaking state upon light excitation following the solvent relaxation, then the slight charge separation may occur and the charge localization became partially asymmetrical in polar environments. Density functional theory (DFT) calculation results were supported well with the experimental measurements. Unique pH-dependent fluorescent properties endows the two chromophores with rapid, highly selective, and sensitive responses to the amino acids in aqueous media. In detail, DAPA served as a fluorescence turn-on probe with a detection limit (DL) of 0.50 μM for Arg and with that of 0.41 μM for Lys. In contrast, DAP-Na featured bright green luminescence and showed fluorescence turn-off responses to Asp and Glu with the DLs of 0.12 μM and 0.16 μM, respectively. Meanwhile, these two simple-structure probes exhibited strong anti-interference ability towards other natural amino acids and realized visual identification of specific analytes. The present work helps to understand the photophysic−structure relationship of these kinds of compounds and render their fluorescent detection applications.

Dual-Mode Photonic Sensor Array for Detecting and Discriminating Hydrazine and Aliphatic Amines

Colorimetric chemosensors have attracted tremendous interest for sensing hazardous substances in an uncomplicated and economical manner. Herein, a series of push-pull dicyanovinyl-substituted oligothiophene derivatives were designed, and the impacts of different end-cappers on their photophysical properties were comprehensively investigated. Interestingly, combined with a zinc porphyrin derivative (Zn-TPP), one dicyanovinyl-substituted oligothiophene derivative (NA-3T-CN) can be further developed into colorimetric and fluorescent sensor array for dual-mode detection of aliphatic amines and hydrazine. The obtained sensors showed satisfactory results between optical response and analyte's concentration both in selective single-sensor type and in enhanced multisensory mode. Based on the fluorescence change of the NA-3T-CN system, the detection limit for N₂H₄ was calculated to be around 1.22 × 10^-5 mol/L in THF. The stained TLC-supported sensor array offers obvious optical changes for down to 0.5 wt % hydrazine solution for naked-eye sensing. An aromatic amine like aniline has no obvious effect on the dicyanovinyl-substituted oligothiophene derivatives. We also found that a zinc porphyrin derivative has an obvious colorimetric response to the presence of hydrazine, ethanolamine, and aniline. Furthermore, smartphone-enabled readout system and data treatment based on RGB changes of the sensor array were performed, and the discrimination capability among hydrazine, aliphatic amines, and aromatic amine was satisfactory. In this regard, related push-pull oligothiophene derivatives not only can be regarded as models for a fundamental understanding of the relationship between molecular structure and photophysical properties but also present potential applications in the field of real-time and visual detection of hazardous chemicals.

Development of a Column-Shaped Fluorometric Sensor Array and Its Application in Visual Discrimination of Alcohols from Vapor Phase

Portable, miniaturized, and inexpensive detectors are in high demand for detecting and discriminating volatile organic compounds (VOCs). Sensor array design and exploitation are two key issues for new detector development. In contrast to the most reported plane-shaped sensor array for gaseous analyte sensing, here we report a column-shaped fluorometric sensor array by using fluorophore-loaded silica particles (∼40 μm) filled capillary. In the design, the capillary serves as test chamber and facilitates visualization. The orifices of the capillary were used as inlet and outlet for gaseous analyte. Sensing modules are installed in series, which lays foundation for their even and effective contact with the gaseous analyte. Meanwhile, further capsulation could be avoided. Silica particles were chosen as carries due to their preferred adsorption behavior to VOCs. By choosing four typical fluorophores (PBI-CB, Py-CB-Ph, Py-At, and NA-Ch) as sensing units, a 4-element fluorometric sensor array was achieved. Fluorescence of the array varied when different alcohol vapors were pumped in. The six tested alcohols could not only be distinguished as primary, secondary, or tertiary, but also be identified individually. The array had good reproducibility in visualization of the six alcohols. In addition, the orders of the fluorophores can be changed as desired. It is believed that the proofed concept provides not only a totally new design of sensor array but also contributes a new strategy for the discrimination of the alcohols as examined.

Highly Sensitive and Discriminative Detection of BTEX in the Vapor Phase: A Film-Based Fluorescent Approach

BTEX (benzene, toluene, ethylbenzene, o-xylene, m-xylene, and p-xylene) represents a group of volatile organic compounds (VOCs) and constitutes a great threat to human health. However, sensitive, selective, and speedy detection of them on-site and in the vapor phase remains a challenge for years. Herein, we report a film-based fluorescent approach and a conceptual sensor, which shows unprecedented sensitivity, speed, and reversibility to the aromatic hydrocarbons in the vapor phase. In the studies, pentiptycene was employed to produce a nonplanar perylene bisimide (PBI) derivative, P-PBI. The compound was further utilized to fabricate the film. The novelty of the design is the combination of capillary condensation and solvent effect, which is expected to enrich the analytes from vapor phase and shows outputs at the same time. Importantly, the film permits instant response (∼3 s) and real-time identification (<1 min) of benzene and toluene from other aromatic hydrocarbons. The experimental detection limits (DLs) of the six analytes are lower than 9.2, 2.7, 1.9, 0.2, 0.4, and 0.4 ppm, which with the exception of benzene, are significantly lower than the NIOSH recommended long-term exposure limits. More importantly, the film is photochemically stable, and more than 300 repetitive tests showed no observable bleaching. In addition, the sensing is fully reversible. The superior performance of the film device is in support of the assumption that the combination of capillary condensation and solvation effect would constitute an effective way to design high-performance fluorescent films, especially for challenging chemical inert and photoelectronically inactive VOCs.