Vibrational spectral fingerprinting for chemical recognition of biominerals

Effect of Magnesium Substitution on Structural Features and Properties of Hydroxyapatite

Hydroxyapatite (HAP) is the main mineral component of bones and teeth. It is widely used in medicine as a bone filler and coating for implants to promote new bone growth. Ion substitutions into the HAP structure highly affect its properties. One of the most important substituents is magnesium. This paper presents new results obtained using high-precision hybrid density functional theory calculations for Mg/Ca substitutions in HAP in a wide magnesium concentration range within a 2 × 2 × 2 supercell model. Experimental data on the mechanochemical synthesis of HAP-Mg samples with different Mg concentrations are also presented. A comparison between the experiment and the theory showed good agreement: the HAP-Mg unit cell parameters and volume decreased with increasing degree of Mg/Ca substitution. The changes in the distances between the Ca and O, Ca and H, and Mg and O ions upon Mg/Ca substitution in different calcium positions was analyzed. The resulting asymmetry and distortion of the cell parameters were evaluated. It was shown that bulk modulus, energy levels, and band gap depend on the degree of Mg substitutions in the Ca1 and Ca2 positions. The formation energies of Mg/Ca substitutions showed non-monotonic behavior that was different for Ca1 and Ca2 positions. The Ca2 position had a slightly higher probability (~5 meV/f.u.) of substitution than Ca1 position at a Mg concentration x = 0.5. At x = 1, substitution in both positions can coexist. The simulated IR spectra for different Mg/Ca substitutions showed that Mg in the Ca2 position changes the IR spectrum more significantly than Mg in the Ca1 position. Similar changes were recorded in the IR spectra of the synthesized samples. The electronic structure is shown to be sensitive to the number and position of substitutions, which may be used to tweak the optical properties of the HAP-Mg material.

Development of a Hybrid Biomimetic Enamel-Biocomposite Interface and a Study of Its Molecular Features Using Synchrotron Submicron ATR-FTIR Microspectroscopy and Multivariate Analysis Techniques

Using a biomimetic strategy and bioinspired materials, our work proposed a new technological approach to create a hybrid transitional layer between enamel and dental biocomposite. For this purpose, an amino acid booster conditioner based on a set of polar amino acids (lysine, arginine, hyaluronic acid), calcium alkali, and a modified adhesive based on BisGMA and nanocrystalline carbonate-substituted hydroxyapatite are used during dental enamel restoration. The molecular properties of the hybrid interface formed using the proposed strategy were understood using methods of multivariate statistical analysis of spectral information collected using the technique of synchrotron infrared microspectroscopy. The results obtained indicate the possibility of forming a bonding that mimics the properties of natural tissue with controlled molecular properties in the hybrid layer. The diffusion of the amino acid booster conditioner component, the calcium alkali, and the modified adhesive with nanocrystalline carbonate-substituted hydroxyapatite in the hybrid interface region creates a structure that should stabilize the reconstituted crystalline enamel layer. The developed technology can form the basis for an individualized, personalized approach to dental enamel restorations.

Biomimetic Mineralization of Tooth Enamel Using Nanocrystalline Hydroxyapatite under Various Dental Surface Pretreatment Conditions

In this report, we demonstrated the formation of a biomimetic mineralizing layer obtained on the surface of dental enamel (biotemplate) using bioinspired nanocrystalline carbonate-substituted calcium hydroxyapatite (ncHAp), whose physical and chemical properties are closest to the natural apatite dental matrix, together with a complex of polyfunctional organic and polar amino acids. Using a set of structural, spectroscopy, and advanced microscopy techniques, we confirmed the formation of a nanosized ncHAp-based mineralized layer, as well as studying its chemical, substructural, and morphological features by means of various methods for the pretreatment of dental enamel. The pretreatment of a biotemplate in an alkaline solution of Ca(OH)₂ and an amino acid booster, together with the executed subsequent mineralization with ncHAp, led to the formation of a mineralized layer with homogeneous micromorphology and the preferential orientation of the ncHAp nanocrystals. It was shown that the homogeneous crystallization of hydroxyapatite on the biotemplate surface and binding of individual nanocrystals and agglomerates into a single complex by an amino acid booster resulted in an increase (~15%) in the nanohardness value in the enamel rods area, compared to that of healthy natural enamel. Obtaining a similar hierarchy and cleavage characteristics as natural enamel in the mineralized layer, taking into account the micromorphological features of dental tissue, is an urgent problem for future research.

Raman and XANES Spectroscopic Study of the Influence of Coordination Atomic and Molecular Environments in Biomimetic Composite Materials Integrated with Dental Tissue

In this work, for the first time, the influence of the coordination environment as well as Ca and P atomic states on biomimetic composites integrated with dental tissue was investigated. Bioinspired dental composites were synthesised based on nanocrystalline calcium carbonate-substituted hydroxyapatite Ca4ICa6IIPO46−xCO3x+yOH2−y (nano-cHAp) obtained from a biogenic source and a set of polar amino acids that modelled the organic matrix. Biomimetic composites, as well as natural dental tissue samples, were investigated using Raman spectromicroscopy and synchrotron X-ray absorption near edge structure (XANES) spectroscopy. Molecular structure and energy structure studies revealed several important features related to the different calcium atomic environments. It was shown that biomimetic composites created in order to reproduce the physicochemical properties of dental tissue provide good imitation of molecular and electron energetic properties, including the carbonate anion CO₃²⁻ and the atomic Ca/P ratio in nanocrystals. The features of the molecular structure of biomimetic composites are inherited from the nano-cHAp (to a greater extent) and the amino acid cocktail used for their creation, and are caused by the ratio between the mineral and organic components, which is similar to the composition of natural enamel and dentine. In this case, violation of the nano-cHAp stoichiometry, which is the mineral basis of the natural and bioinspired composites, as well as the inclusion of different molecular groups in the nano-cHAp lattice, do not affect the coordination environment of phosphorus atoms. The differences observed in the molecular and electron energetic structures of the natural enamel and dentine and the imitation of their properties by biomimetic materials are caused by rearrangement in the local environment of the calcium atoms in the HAp crystal lattice. The surface of the nano-cHAp crystals in the natural enamel and dentine involved in the formation of bonds with the organic matrix is characterised by the coordination environment of the calcium atom, corresponding to its location in the Ca^I position—that is, bound through common oxygen atoms with PO₄ tetrahedrons. At the same time, on the surface of nano-cHAp crystals in bioinspired dental materials, the calcium atom is characteristically located in the Ca^II position, bound to the hydroxyl OH group. The features detected in the atomic and molecular coordination environment in nano-cHAp play a fundamental role in recreating a biomimetic dental composite of the natural organomineral interaction in mineralised tissue and will help to find an optimal way to integrate the dental biocomposite with natural tissue.

A Case of Silicone and Sarcoid Granulomas in a Patient with "Highly Cohesive" Silicone Breast Implants: A Histopathologic and Laser Raman Microprobe Analysis

Foreign body giant cell (FBGC) reaction to silicone material in the lymph nodes of patients with silicone breast implants has been documented in the literature, with a number of case reports dating back to 1978. Many of these case reports describe histologic features of silicone lymphadenopathy in regional lymph nodes from patients with multiple sets of different types of implants, including single lumen smooth surface gel, single lumen textured surface gel, single lumen with polyethylene terephthalate patch, single lumen with polyurethane coating, and double lumen smooth surface. Only one other case report described a patient with highly-cohesive breast implants and silicone granulomas of the skin. In this article, we describe a patient with a clinical presentation of systemic sarcoidosis following highly cohesive breast implant placement. Histopathologic analysis and Confocal Laser Raman Microprobe (CLRM) examination were used to confirm the presence of silicone in the axillary lymph node and capsular tissues. This is the first report where chemical spectroscopic mapping has been used to establish and identify the coexistence of Schaumann bodies, consisting of calcium oxalate and calcium phosphate minerals, together with silicone implant material.

Tolerance to Stretching in Thiol-Terminated Single-Molecule Junctions Characterized by Surface-Enhanced Raman Scattering

We investigated the change in the metal-molecule interaction in a 1,4-benzenedithiol (BDT) single-molecule junction using a combination of surface-enhanced Raman scattering spectra and current-voltage curves. During the stretching process, the conductance of the junction systematically decreased, accompanied by an increase in the vibrational energy of the CC stretching mode. By analyzing the current-voltage curves and Raman spectra, we found that the interaction between the π orbital of BDT and the electronic states of Au was diminished by the orientation change of BDT during the stretching process. A comparison with a 4,4'-bipyridine single-molecule junction revealed that the reduction of coupling of the Au-S contacts was smaller than that of Au-pyridine contacts. Therefore, the electronic states originating from the contact geometry are responsible for the tolerance to the stretching of thiol-terminated molecular junctions.