Effect of biologic materials on the outcomes of horizontal alveolar ridge augmentation: A retrospective study

Horizontal ridge augmentation with particulate cortico-cancellous freeze-dried bone allograft alone or combined with injectable-platelet rich fibrin in a randomized clinical trial

OBJECTIVES

The objective of this study is to assess the effectiveness of horizontal ridge augmentation using FDBA in combination with injectable-platelet rich fibrin (i-PRF) versus FDBA alone. To fulfill this aim, the radiographic and histomorphometric outcomes are compared.

METHOD

The study involved 41 patients who had horizontal alveolar ridge defects categorized as either B (2.5-7 mm) or C (0-2.5 mm). The control group received FDBA alone (n = 20), while the test group received FDBA in combination with i-PRF (n = 21). The horizontal dimensions of the alveolar ridge were measured at 0, 2, 4, and 6 mm from the bone crest using CBCT before and 6 months after alveolar ridge augmentation. In the second-stage surgery, 24 biopsies were taken from the augmented bone - 13 from the control group and 11 from the test group, and were examined histologically and histomorphometrically. The data were analyzed using Pearson correlation coefficient, chi-square, paired-t, and two-sample t tests.

RESULTS

There was no significant difference (p > 0.05) in the increase of mean ridge width between the test group and the control group after 6 months at distances of 0, 2, 4, and 6 mm from the crest, with differences of -0.28, 0.12, 0.52, and 1.04 mm, respectively. However, the amount of newly formed bone and material residues was significantly higher in the FDBA + i-PRF group compared to the FDBA alone group (45.01% and 13.06% vs 54.03% and 8.48%, respectively). There was no significant difference in the amount of soft tissue between the two groups (41.02% and 37.5%, p > 0.05).

CONCLUSION

The study found that there was no statistically significant difference in the increase of horizontal ridge width between the FDBA + i-PRF group and the FDBA group. However, the histomorphometric analysis revealed that the FDBA + i-PRF group had a higher proportion of newly formed bone, less connective tissue, and fewer residual particles. This suggests a superior quality of bone formation compared to the FDBA group.

Tooth as graft material: Histologic study

Background

An effective regenerative protocol is key to reestablish and maintain the hard and soft tissue dimensions over time. The choice of the graft material and its properties also could have an impact on the results. To prevent alveolar ridge dimensional changes, since numerous graft materials have been suggested and in the past years, a growing interest in teeth material has been observed as a valuable alternative to synthetic biomaterials.

Aim

The aim of the study was to explore the histomorphometric outcomes of tooth derivative materials as used as bone substitute material in socket preservation procedure.

Methods

After alveolar socket preservation (ASP) procedures using autologous demineralized tooth as graft material prepared by means of an innovative device, was evaluated. A total of 101 histological samples, from 96 subjects, were analyzed by evaluating the total amount of bone (BV), residual tooth material (residual graft, TT), and vital bone (VB). The section from each sample was then split in nine subsections, resulting in 909 subsections, to allow statistical comparison between the different areas.

Results

It was not noticed a statistically significant difference between maxillary and mandibular sites, being the amount of VB in upper jaw sites 37.9 ± 21.9% and 38.0 ± 22.0% in lower jaw sites and the amount of TT was 7.7 ± 12.2% in maxilla and 7.0 ± 11.1% in mandibles. None of the other considered parameters, including defect type and section position, were statistically correlated to the results of the histomorphometric analysis.

Conclusions

ASP procedure using demineralized autologous tooth‐derived biomaterial may be a predictable procedure to produce new vital bone potentially capable to support dental implant rehabilitation.

Horizontal guided bone regeneration on knife-edge ridges: A retrospective case-control pilot study comparing two surgical techniques

INTRODUCTION

Studies evaluating guided bone regeneration (GBR) on knife-edge ridges using absorbable membranes with staged approaches have reported various horizontal bone gains. This study compared the horizontal bone gain obtained via a conventional technique of GBR and a recently-reported technique. Bone loss during the healing process was also measured.

METHODS

Consecutive patients who underwent GBR on knife-edge ridges via a conventional technique (control group) or the Sausage Technique (test group) were included in this study. GBR was performed using a collagen membrane and deproteinized bovine bone mineral combined with an autogenous graft at a 1:1 ratio. Cone-beam computed tomography (CBCT) was performed preoperatively, postoperatively, and after the patient healed. Horizontal bone width was measured on CBCT images 2 mm apical from the top of the crest. The preoperative CBCT and posthealing CBCT were superimposed to calculate the bone gain after healing, and the preoperative and postoperative CBCT scans were superimposed to calculate the bone gain after surgery. Bone loss during healing was calculated by subtracting the width of the ridge after healing from the postoperative width.

RESULTS

The mean horizontal bone gain was significantly lower in the control group (2.7 ± 1.8 mm; 83.2%) than in the test group (5.3 ± 2.3 mm; 216.8%) (p = 0.003). The average horizontal bone loss between regeneration and implant placement was 0.9 mm in the control group (27.9%) and 2.1 mm in the test group (29.4%). While the absolute bone loss was significantly different (p = 0.012), the percentage of bone resorption was not (p = 0.608).

CONCLUSION

The new technique resulted in significantly more bone gain than a conventional GBR technique. The rate of graft resorption during healing was stable regardless of the amount of grafted material.

Effect of biologic materials on the outcomes of horizontal alveolar ridge augmentation: A retrospective study

PURPOSE

The purpose of this study was to investigate if the addition of biologic agents to a particulate bone graft enhances horizontal ridge augmentation outcomes in terms of bone dimensions, bone density, and successful implant placement.

MATERIALS AND METHODS

A retrospective chart review was done to assess the clinical and radiographic outcomes in 52 horizontal ridge augmentation sites in 43 patients. Information was gathered regarding surgical technique, type of graft material, biologic agents used (PRP or rhPDGF-BB), method of space maintenance, and achieved alveolar ridge width and bone density changes as quantified on CBCT scans.

RESULTS

The use of tenting screws, a resorbable membrane, and a combination of particulate allogenic and xenogenic bone graft material provided an average horizontal bone gain of 3.6 mm in the 52 augmented sites. There was no statistically significant difference observed in the amount of horizontal bone gain between sites treated with the addition of biologic agents (n = 21), or with a particulate bone graft alone (n = 31). A marginally statistically significant difference was found in the density of the grafted bone with the addition of biologics (p value = .0653).

CONCLUSION

The addition of biologic agents to the graft materials did not have a significant effect on the amount of horizontal bone gain or successful implant placement; however, it marginally enhanced the bone density of the grafted area.