The role of zinc(II) in the absorption-desorption of CO2 by aqueous NH3, a potentially cost-effective method for CO2 capture and recycling

A realistic perspective for CO2 triggered tuning of electrical conductivity

To seek sustainable CO₂ sequestration and conversion, an electrochemical cell has been investigated for carbon capture and utilization strategy (CCU). In this cell, atmospheric CO₂ is captured under ambient conditions and incorporated into power generation using zinc nanopowder as the catalyst. As a result, a method was developed to tune the electronic property of zinc by passing CO₂. It was observed that nearly three orders of magnitude of conductivity could be changed along with achieving a carbon capture strategy. The system also exhibited good stability. In this process, it was observed that efficient current generation could be achieved due to zinc's active participation as a catalyst. The detailed physicochemical characterizations of catalysts were also examined. XRD, FTIR and TEM analysis perform the structural and morphological characterization. The system performance was further investigated using different criteria.

Water Vapour Promotes CO2 Transport in Poly(ionic liquid)/Ionic Liquid-Based Thin-Film Composite Membranes Containing Zinc Salt for Flue Gas Treatment

A poly(ionic-liquid) (PIL) matrix can be altered by incorporating additives that will disrupt the polymer chain packing, such as an ionic liquid (IL) and inorganic salts to boost their exploitation as materials for membrane production to be used in CO2 capture. Herein, potential of PIL/IL/salt blends is investigated on the example of poly(diallyldimethyl ammonium) bis(trifluoromethylsulfonyl)imide (P[DADMA][Tf2N]) with N-butyl-N-methyl pyrrolidinium bis(trifluoromethylsulfonyl)imide ([Pyrr14][Tf2N]) and zinc di-bis(trifluoromethylsulfonyl)imide (Zn[Tf2N]2). Composite material with IL and a higher amount of Zn2+ showed an increase in the equilibrium CO2 sorption capacity to 2.77 cm3 (STP)cm −3 bar−1. Prepared blends were successfully processed into thick, dense membranes and thin-film composite membranes. Their CO2 separation efficiency was determined using ideal and mixed-gas feed (vol% CO2 = 50 , dry and with 90% relative humidity). The dominant role of solubility in the transport mechanism is confirmed by combining direct gravimetric sorption measurements and indirect estimations from time-lag experiments. The maximum incorporated amount of Zn2+ salts increased equilibrium solubility selectivity by at least 50% in comparison to the parent PIL. All materials showed increased CO2 permeance values by at least 30% in dry conditions, and 60% in humidified conditions when compared to the parent PIL; the performance of pure PIL remained unchanged upon addition of water vapor to the feed stream. Mixed-gas selectivities for all materials rose by 10% in humidified conditions when compared to dry feed experiments. Our results confirm that the addition of IL improves the performance of PIL-based composites due to lower stiffness of the membrane matrix. The addition of Zn2+-based salt had a marginal effect on CO2 separation efficiency, suggesting that the cation participates in the facilitated transport of CO2.

Improved solvent formulations for efficient CO₂ absorption and low-temperature desorption

This experimental study describes efficient CO₂ capture by 2-amino-2-methyl-1-propanol (AMP)/piperazine (PZ) in ethylene glycol monoethyl ether (EGMEE, 2-ethoxyethanol) containing approximately 15 wt % of water. In these experiments, the solvent is continuously circulated between the absorber (packed-bed reactor at 30, 40, or 45 °C) and the desorber (at 80, 85, or 90 °C). The CO₂ -solvent reaction equilibria have been investigated by using ¹³C NMR spectroscopy, which provides confirmatory evidence that the formation of mono- and biscarbamate derivatives of PZ accounts for most of the CO₂ absorbed by the AMP/PZ/EGMEE/H₂O blend. The solid-state structures of AMP carbamate and of the carbonate salt of protonated AMP have been determined by using XRD. Both AMPCO₂(-) and CO(3)(2-) species completely convert to the monoalkyl carbonates on dissolving the respective salts in methanol, ethanol, or ethylene glycol.

Cyclic carbonate synthesis catalysed by bimetallic aluminium-salen complexes

The development of bimetallic aluminium-salen complexes [{Al(salen)}(2)O] as catalysts for the synthesis of cyclic carbonates (including the commercially important ethylene and propylene carbonates) from a wide range of terminal epoxides in the presence of tetrabutylammonium bromide as a cocatalyst is reported. The bimetallic structure of one complex was confirmed by X-ray crystallography. The bimetallic complexes displayed exceptionally high catalytic activity and in the presence of tetrabutylammonium bromide could catalyse cyclic carbonate synthesis at atmospheric pressure and room temperature. Catalyst-reuse experiments demonstrated that one bimetallic complex was stable for over 60 reactions, though the tetrabutylammonium bromide decomposed in situ by a retro-Menschutkin reaction to form tributylamine and had to be regularly replaced. The mild reaction conditions allowed a full analysis of the reaction kinetics to be carried out and this showed that the reaction was first order in aluminium complex concentration, first order in epoxide concentration, first order in carbon dioxide concentration (except when used in excess) and unexpectedly second order in tetrabutylammonium bromide concentration. Further kinetic experiments demonstrated that the tributylamine formed in situ was involved in the catalysis and that addition of butyl bromide to reconvert the tributylamine into tetrabutylammonium bromide resulted in inhibition of the reaction. The reaction kinetics also indicated that no kinetic resolution of racemic epoxides was possible with this class of catalysts, even when the catalyst was derived from a chiral salen ligand. However, it was shown that if enantiomerically pure styrene oxide was used as substrate, then enantiomerically pure styrene carbonate was formed. On the basis of the kinetic and other experimental data, a catalytic cycle that explains why the bimetallic complexes display such high catalytic activity has been developed.