Response surface methodology use in construction of polianiline-coated carbon paste electrode-based biosensor: Modification and characterization

In this study, the effect of amperometric glucose biosensor construction and using conditions on the current response was investigated in detail applying experimental design. Polyaniline (PANI) was synthesized on the carbon paste electrode (CPE) surface using the cyclic voltammetry technique in sodium oxalate (NaOx ) electrolyte medium, and an amperometric biosensor was constructed by immobilizing glucose oxidase (GOD). Biosensor preparation (aniline, GOD and NaOx concentrations, and scan rate) and operating conditions (pH and applied potential) were optimized by Box-Behnken and optimal designs, respectively, via State Ease Design Expert 7.0.1.1 software. ANOVA analyses showed that among the biosensor preparation parameters, the NaOx concentration has the highest effect on the current measured in the presence of glucose, whereas in the optimization of pH and potential parameters applied in current measurement studies, it has been revealed that pH has a very high effect on the measured current. Several compounds, such as MWCNT, two different ionic liquids and two different organic molecules were added to carbon paste, and, among them, 2-cyanoethylpyrrole (CPy) enhanced the efficacy highly, most probably due to its polymerization in the paste and increasing the electron transfer rate of the CPE. Sucrose- and lactose-sensitive biosensors were also constructed by co-immobilizing GOD with invertase (INV) or β-galactosidase, respectively, onto modified CPE, and sensitivities to their substrates were shown by cyclic voltammetry and impedance analysis. CPy modification caused an increase in the current values, and also Imax /KM values increased approximately 11.8, 7.83, and 2.56 times for glucose-, sucrose-, and lactose-sensitive CPEs, respectively.

SERS spectroelectrochemical study of electrode processes at copper hexacyanoferrate modified electrode

Electrochemical redox processes taking place at copper hexacyanoferrate (CuHCF) modified electrode have been investigated by near-infrared laser (785nm) induced surface-enhanced Raman spectroscopy (SERS). Raman bands observed within the spectral ranges of 2200-2000cm^-1 and 500-100cm^-1, as well as their dependence on electrode potential, have been analysed. The most characteristic Raman bands, related to triple CN bond vibrations and centered at 2187 and 2127cm^-1 were assigned to the oxidised and the reduced forms of CuHCF, respectively. Time-resolved Raman spectroelectrochemical study shows that the electrochemical redox interconversions between these two forms proceed relatively slow, thus resembling the behaviour of structurally related cobalt hexacyanoferrate, and differing essentially from that of Prussian blue layer studied previously. It has been shown by the time-resolved Raman spectroelectrochemistry that the rate of some redox processes of solute species like the anodic oxidation of ascorbate or cathodic reduction of hydrogen peroxide at CuHCF modified electrode appears to be limited by the slow electrochemical redox transformations within the modifier layer itself rather than by the redox interactions of a modifier with the solute species.