Sensitive Determination of Folic Acid using a Solid Bismuth Microelectrode by Adsorptive Stripping Voltammetry

Microelectrode Voltammetric Analysis of Low Concentrations of Se(IV) Ions in Environmental Waters

The current research is an attempt to analyze on-site selenium(IV) ions in environmental water samples using an eco-friendly miniaturized sensor developed by deposition of a very thin amount of metallic bismuth in a solid Bi electrode tightly closed in miniaturized housing. Numerous experimental variables are optimized, including the composition of the supporting electrolyte and its pH, as well as activation and accumulation conditions. Under optimized measurement conditions, the method shows high sensitivity, permitting a very low limit of detection equal to 7 × 10-10 mol L-1 to be achieved in a short accumulation time of 50 s. The performance of this microsensor was investigated against numerous interference factors and its good anti-interference capability was demonstrated. A series of voltammetric experiments by differential pulse cathodic stripping voltammetry (DPCSV) were carried out and they proved that the miniaturized sensor is characterized by very good accuracy and precision as well as long-term stability. The solid bismuth microelectrode displays a good voltammetric response in the analysis of diverse samples with a complex matrix and demonstrates a good recovery rate.

A Novel Eco-Friendly and Highly Sensitive Solid Lead-Tin Microelectrode for Trace U(VI) Determination in Natural Water Samples

For the first time a solid state lead-tin microelectrode (diameter ϕ 25 µm) was utilized for U(VI) ion determination by adsorptive stripping voltammetry. The described sensor is characterized by high durability, reusability and eco-friendly features, as the need for using lead and tin ions for metal film preplating has been eliminated, and consequently, the amount of toxic waste has been limited. The advantages of the developed procedure resulted also from the utilization of a microelectrode as a working electrode, because a restricted amount of metals is needed for its construction. Moreover, field analysis is possible to perform thanks to the fact that measurements can be carried out from unmixed solutions. The analytical procedure was optimized. The proposed procedure is characterized by two orders of magnitude linear dynamic range of U(VI) determination from 1 × 10^-9 to 1 × 10^-7 mol L^-1 (120 s of accumulation). The detection limit was calculated to be 3.9 × 10^-10 mol L^-1 (accumulation time of 120 s). RSD% calculated from seven subsequent U(VI) determinations at a concentration of 2 × 10^-8 mol L^-1 was 3.5%. The correctness of the analytical procedure was confirmed by analyzing a natural certified reference material.

An Activated Bismuth Layer Formed In Situ on a Solid Bismuth Microelectrode for Electrochemical Sensitive Determination of Ga(III)

In this paper, an activated bismuth layer formed in situ on a solid bismuth microelectrode, used as a working electrode for the electrochemical sensitive determination of Ga(III), based on anodic stripping voltammetry (ASV) is discussed. The new electrode significantly enhances the sensitivity in the ASV determination of Ga(III) and exhibits superior performance in comparison to a bismuth film electrode prepared on a glassy carbon disc. The experimental variables, such as the potential and time of solid-bismuth-microelectrode activation, the composition of the supporting electrolyte, and the influence of possible interferences on the Ga(III) signal response, were tested. The most favorable values were selected (pH = 4.6; acetate buffer; activation potential/time: -1.8 V/6 s and -1.4 V/60 s). In the optimized conditions, the peak current was found to be proportional to the concentration of Ga(III) over the range from 2 × 10^-8 to 2 × 10^-6 mol L^-1 with R = 0.993. The limit of detection (LOD) was 7 × 10^-9 mol L^-1. Finally, the proposed method was successfully applied for gallium determination in certified reference waters, such as surface water and waste water, as well as tap and river water samples. The water samples were analyzed without any pretreatment and recovery values from 92.4 to 105.5% were obtained.

The Use of a Solid Bismuth Microelectrode for Vanadium Quantification by Adsorptive Stripping Voltammetry in Environmental Water Samples

This paper presents for the first time the use of an environmentally friendly solid bismuth microelectrode for the voltammetric quantification of V(V) in natural water samples. These studies were designed to replace the film bismuth electrode that had been introduced to eliminate the conventional sensors based on highly toxic mercury. In the proposed procedure, V(V) is preconcentrated at the solid bismuth microelectrode surface via the formation of electroactive complexes with cupferron from a solution of 0.1-mol L⁻¹ acetate buffer, pH = 4.6 at a potential of −0.4 V. The linearity of the calibration graph is in the V(V) concentration range from 8 × 10⁻¹⁰ to 1 × 10⁻⁷ mol L⁻¹ with a preconcentration time of 1 min. The limit of detection (calculated as 3 σ) is 2.5 × 10⁻¹⁰ mol L⁻¹ for a preconcentration time of 1 min. It was also demonstrated that significant improvement in analytical parameters was achieved as a result of the activation of the solid electrode surface at a potential of −2.5 V for 2 s. The developed procedure is highly selective for the presence of foreign ions and organic compounds in tested samples. The accuracy of the recommended procedure was checked using SPS-WW1 waste water-certified reference materials of a complex composition, in which the concentration of V(V) determined by the proposed method was 95.1 ± 1.6 ng mL⁻¹. Moreover, in keeping with the outlined procedure, river, tap and rain water samples were analyzed without any pretreatment, and recovery values from 96% to 106% were obtained.

Silver-enhanced fluorescence of bimetallic Au/Ag nanoclusters as ultrasensitive sensing probe for the detection of folic acid

Folic acid (FA) is the natural form of water-soluble vitamins widely found in most plants and animal products and its deficiency leads to several human body abnormalities. The advancements of metal nanoclusters are highly increasing due to their molecule-like optical properties and attractive applications. Because of increasingly demand of noble metal nanoclusters as sensing templates, different synthesis methods have been developed for facile synthesis of noble metal nanoclusters. Herein, red-emitting fluorescent bovine serum albumin (BSA)-capped Au-Ag bimetallic NCs are facilely synthesized through green one-pot synthetic approach. The effect of silver on the fluorescence properties of Au NCs was investigated and it was found that introduction of silver can enhance the fluorescence intensity. The fluorescence intensity of the as-prepared Au-Ag nanoclusters gets quenched in the presence of folic acid in an aqueous medium and it was used as ultrasensitive sensing probe for FA detection. The developed Au-Ag NCs-based sensing probe shows linear response in the wide range of 0-100 μM and the detection limit is as low as 0.47 nM. Its applicability has also been confirmed successfully in real human serum, urine and FA tablet samples. Due to the high stability, sensitivity and selectivity, the developed bimetallic cluster sensing system is highly promising to be applied in the pharmaceutical and clinical laboratories.