Separation of aracytidine and cytidine by capillary electrophoretic techniques

Antineoplastic drugs and their analysis: a state of the art review

We provide an overview of the analytical methods available for the quantification of antineoplastic drugs in pharmaceutical formulations, biological and environmental samples.

Analysis of anticancer drugs: a review

In the last decades, the number of patients receiving chemotherapy has considerably increased. Given the toxicity of cytotoxic agents to humans (not only for patients but also for healthcare professionals), the development of reliable analytical methods to analyse these compounds became necessary. From the discovery of new substances to patient administration, all pharmaceutical fields are concerned with the analysis of cytotoxic drugs. In this review, the use of methods to analyse cytotoxic agents in various matrices, such as pharmaceutical formulations and biological and environmental samples, is discussed. Thus, an overview of reported analytical methods for the determination of the most commonly used anticancer drugs is given.

Simultaneous separation and determination of Tarabine PFS and Adriblastine using micellar electrokinetic chromatography and high performance liquid chromatography. Application to some biological fluids

The simultaneous determination of Tarabine PFS and Adriblastine by two independent techniques, viz. micellar electrokinetic chromatography (MEKC) and high performance liquid chromatography (HPLC), has been studied. For MEKC analysis, separations and identifications were accomplished using uncoated fused-silica capillaries and injections were performed in the hydrodynamic mode. The running buffer consisted of 0.05 M borate/phosphate pH 8.70, with 0.10 M SDS at an operating voltage of 15.0 kV and the temperature held at 25.0 degrees C. Under these conditions, the migration times of Tarabine PFS and Adriblastine were 2.70 and 6.40 min, respectively. Calibration curves were established for 0.010-0.300 microg/mL (r = 0.99) Tarabine PFS and 8.000-120.0 microg/mL (r = 0.99) Adriblastine. The limit of detection (LOD) was estimated and found to be 0.003 and 3.000 microg/mL of Tarabine PFS and Adriblastine, respectively. The limit of quantitation (LOQ) was found to be 0.009 and 8.000 microg/mL of Tarabine PFS and Adriblastine, respectively. For HPLC analysis, separations and determinations were performed on teicoplanin stationary phase with reversed mobile phase containing methanol:buffer pH 4.05 (20.0:80.0%, v/v) at 285 nm. Calibration curves were established for 3.000-90.00 microg/mL (r = 0.99) Tarabine PFS and for 10.00-120.0 microg/mL (r = 0.99) Adriblastine. LOD and LOQ were estimated and found to be 0.950 and 2.050 microg/mL of Tarabine PFS and 3.130 and 9.250 microg/mL of Adriblastine, respectively. Both MEKC and HPLC methods were applied for the simultaneous determination of analytes in urine samples. It was found that 8.00-10.0% (Tarabine PFS) and 13.0-15.0% (Adriblastine) of the injected dose was recovered in urine samples with 99.5-102% recovery.

Osteryoung square wave stripping voltammetry at mercury film electrode for monitoring ultra trace levels of Tarabine PFS and its interaction with ssDNA

The electrochemical oxidation and reduction behaviour of adsorbed species of antimetabolic antineoplastic agent Tarabine PFS (Cytosar-U) in Sorensen buffer solution of different pH values at an in situ-mercury film electrode (MFE) is studied using cyclic voltammetry (CV) and Osteryoung square-wave stripping voltammetry (OSWSV). Optimal experimental and operational parameters have been selected for the drug preconcentration and determination in aqueous medium. Based on the adsorption and accumulation of Tarabine PFS using Osteryoung square-wave anodic stripping voltammetry (OSWASV) at MFE, the drug is easily detected as 0.134 ng/ml (5.51 x 10(-10) M). Calibration plots have been constructed at different accumulation times. The standard deviation (n=10) at a concentration level of 6 x 10(-8) M Tarabine PFS is 0.062. The interaction of ssDNA with the drug under the optimal conditions at pH 7.7 has been studied. The formal potentials E degrees and E degrees ' and the equilibrium constants K(1) and K(2) have been calculated for the free form of Tarabine PFS and the bonded form with ssDNA, respectively. It was found that K(2) value for the bonded oxidized form is 298 times than that of K(1) for the bonded reduced form. Therefore, ssDNA has been found to interact strongly with the oxidized form of the drug. The method has been used for the nanogram determination of ssDNA with 1.9% variation coefficient. Detection limit of 3 ng/ml ssDNA has been achieved. Possible interfering organic compounds, cations and anions have been tested. The method has been applied for the drug determination in urine samples, down to 0.23 ng/ml could be easily achieved in such samples.

Micellar electrokinetic capillary chromatography quantification of cytosine arabinoside and its metabolite, uracil arabinoside, in human serum

Cytosine arabinoside (Ara-C) is widely used to induce remission in adult granulocytic leukemia. High doses can be infused in refractory leukemia or in relapse. After injection, Ara-C is quickly metabolized to uracil arabinoside (Ara-U), the main inactive metabolite. We here described a micellar electrokinetic capillary chromatography (MECC) method to simultaneously determine Ara-C/Ara-U in human serum using 6-O-methylguanine as an internal standard. The assay was linear from 6.25 to 200 microg/ml with a quantification limit between 3 and 6 microg/ml. The analytical precision was satisfactory between 2 and 4.3% (within-run) and 3.7 and 7.3% (between-runs). This assay was applied to the analysis of serum from acute granulocytic leukemia patient treated by high doses cytarabine (3 g/m2 body surface).

Capillary electrophoresis as a versatile tool for the bioanalysis of drugs--a review

This review article presents an overview of current research on the use of capillary electrophoretic techniques for the analysis of drugs in biological matrices. The principles of capillary electrophoresis and its various separation and detection modes are briefly discussed. Sample pretreatment methods which have been used for clean-up and concentration are discussed. Finally, an extensive overview of bioanalytical applications is presented. The bioanalyses of more than 200 drugs have been summarised, including the applied sample pretreatment methods and the achieved detection limits.