Enhanced detection sensitivity of "fluorescence reduction" by shifting the analyte absorbance spectrum and use of a fluorescent paper with higher signal/noise ratio

Stacking of unlabeled sodium dodecyl sulfate-proteins within a fluorimetrically detected moving boundary, electroelution and mass spectrometric identification

The previously reported fluorimetric detection of sodium dodecyl sulfate (SDS)-protein in the presence of cascade blue in agarose gel electrophoresis using barbital buffer was found to be equally feasible in the absence of the fluorescent marker and using Tris-Tricinate buffer, provided that SDS was loaded with the sample but not contained in the catholyte. That fluorescent detection is thought to be due to the formation of a moving boundary between leading SDS and trailing barbital, or Tricinate buffer. This hypothesis is supported by the following evidence: (i) The fluorometrically detected band disappears with addition of SDS to the catholyte; (ii) band area is proportional to protein and/or SDS load; (iii) mobility of SDS-proteins differing in mass is the same at agarose concentrations up to 3%; (iv) lowering of protein mobility by increase in gel concentration and/or increase in the size of the SDS-protein leads to band disappearance. Fluorescent detection of the band is like to be nonspecific and due to the light scattering properties of a stack comprising moving boundaries of any analytes with net mobilities intermediate between SDS (or micellar SDS) and the trailing buffer constituent at their regulated very high concentrations. The steady-state stack of SDS-proteins in the size range of 14.4-45.0 kDa, and the transient stack of an SDS-protein of 66.2 kDa have lent themselves to electroelution and characterization by mass of the proteins after removal of SDS and buffer exchange using matrix assisted laser desorption/ionization-time of flight (MALDI-TOF)-mass spectrometry. The possibility to form a stack of protein between leading SDS and trailing buffer anions under conditions of weak molecular sieving (open-pore gel and small-sized protein) contributes to the understanding of moving boundaries in gel electrophoresis, but in view of the narrowly defined conditions, under which this stack forms, is of limited practical significance for the gel electrophoresis of SDS-proteins.

Recovery of sodium dodecyl sulfate-proteins from gel electrophoretic bands in a single electroelution step for mass spectrometric analysis

Mass spectrometric analysis of proteins derived from bands in gel electrophoresis is incompatible with the covalent fluorescent labeling of the protein. Thus, if one wishes to take advantage of the capacity for computer-directed electroelution of electrophoresis apparatus with intermittent fluorescent scanning of the migration path, the protein must be labeled fluorescently in a noncovalent, reversible fashion. This was recently achieved by staining of SDS-proteins with Cascade blue and electrophoresis in barbital buffer. However, the method was not a practical one for the purpose of isolating proteins from gel electrophoretic bands and their transfer into the mass spectrometer for three reasons: (i) Ten consecutive electroelution steps were required to obviate pH changes in the electroelution chamber; (ii) electroeluates from six gel electrophoretic lanes needed to be pooled; (iii) excessive protein loads ranging from 7 to 33 microg/pool were required. The present study reports the solution to those three problems. Mass spectrometric (MALDI-TOF) characterization of five proteins was demonstrated (i) after a single electroelution step; (ii) using electroelution from a single gel of 0.3-cm(2) cross-sectional area; and (iii) using a protein load of 2 (in one case 4) microg. However, the migration rates of the Cascade blue-SDS-protein-barbital complexes derived from proteins with widely varying molecular weights proved to be the same. Thus, despite the three advances made, the method to date remains restricted to samples of single proteins.

Electroelution of nonfluorescent stacked proteins detected by fluorescence optics from gel electrophoretic bands for transfer into mass spectrometry

The extreme accuracy of spectrometrically determined masses of proteins has opened the possibility to identify proteins separated as gel electrophoretic bands in the absence of specific immunologic ways of identification. For the purpose of protein transfer from gel electrophoretic bands to mass spectrometer, electroelution from the intact gel has advantages, in particular when apparatus with capacity for fluorescent scanning allows one to direct the electroelution cell over the band under computer control. To avoid fluorescent labeling of the protein which is incompatible with mass spectrometric identification, it is proposed to selectively stack the unlabeled protein and detect it by comigrating tracking dye prior to electroelution. The feasibility of the approach is exemplified in case of a single protein, but still remains to be demonstrated in conjunction with the selective stacking or unstacking of a single protein from a mixture of several proteins.

Transfer of SDS-proteins from gel electrophoretic zones into mass spectrometry, using electroelution of the band into buffer without sectioning of the gel

Five SDS-proteins, ranging in molecular weight from 14 to 66 kDa, were detected without covalent fluorescent labeling by the automated gel electrophoresis apparatus with intermittent fluorescence scanning (HPGE apparatus, LabIntelligence) during electrophoresis in barbiturate buffer in the presence of Cascade Blue. The SDS-proteins were electroeluted from the gel into 220 microl of buffer by a modification of the procedure of Gombocz and Cortez. The electroeluate was freed of SDS, ultrafiltered and subjected to MALDI-TOF mass spectrometry. The masses of the five native proteins were found to be maintained after electrophoresis and electroelution in the presence of the potential contaminants SDS, barbituric acid and Cascade Blue. The procedure of protein transfer from SDS-PAGE into mass spectrometry, without excision of bands, gel maceration and protein recovery by diffusion, therefore is shown to be suitable for the identification by mass of intact proteins derived from gel electrophoretic bands.

Carrier ampholytes rehabilitated: gel isoelectric focusing on pH gradients visualized in real-time by automated fluorescence scanning in the HPGE-1000 apparatus

All synthetic carrier ampholyte mixtures (SCAMs) contain some naturally fluorescing carrier ampholytes (CAs). The detection of these during isoelectric focusing (IEF), using gel electrophoresis apparatus with intermittent scanning of fluorescence, allows one to follow in real-time the "life cycle" of the pH gradient, i.e., its genesis, steady-state, and decay. The most prominently fluorescing CAs can be calibrated by pH measurement at or after the steady state ("calibration CAs"). By application of the calibration CAs, the fluorescence pattern of CAs can be interpreted in terms of pH gradient (p/s). Simultaneously with the visualization of the pH gradient in that way, protein samples can be detected by "fluorescence reduction" and assigned pH values in dependence on focusing time and, at or after the steady state of the protein, pI' values. The method remedies the inherent blindness of IEF with regard to the state of the pH gradient within its limited "life cycle". It allows one to load the sample at a time when the shape of the pH gradient is optimal for the purpose of its resolution from neighboring components. The visualization of the cathodic drift during IEF eliminates the danger to resolution and to loss of sample associated with "blind" IEF. Most importantly, the possibility to follow the pH in the position of the protein as a function of time provides an objective, accurate measure of the pI' not available from pH measurement at an arbitrary focusing time. The method therefore preempts the advantage of using an IEF method which is free of the pH gradient drift, i.e., immobilized pH gradient (IPG)-IEF. Moreover, it preserves the "natural pH gradient", does not present any of its sample entry problems and those due to very low conductance, and is compatible with agrose gels and their relatively diminished restrictiveness to migration.

Mass spectrometric analysis of the electroeluates of fluorescent proteins after preparative electrophoresis in the automated HPGE-1000 apparatus

Bands of green fluorescent protein (GFP) and R-phycoerythrin (PHYCO) in gel electrophoresis on the automated apparatus for gel electrophoresis with periodic fluorescence scanning (HPGE), the HPGE-1000 apparatus, were retrieved from the gel by electroelution. While PHYCO was recovered in a single volume of electroeluate buffer after the predicted migration time, GFP fluorescence was lost under the same conditions and could only be recovered using multiple changes of electroeluate buffer. The multiple volumes of buffer necessitated pooling, concentration, and storage, conditions under which a minor GFP component, GFP-II, formed artifactually. PHYCO after electroelution also exhibits a minor component present in the original preparation. The electroeluate of GFP, transferred into a mass spectrometer after pooling, concentration and storage, is indistinguishable in mass from the original preparation.

Separation and microgram-scale isolation of sea urchin egg granules by electrophoresis in polyvinylpyrrolidone solution, using horizontal gel electrophoresis apparatus with fluorescence detector

A homogenate of sea urchin (Lytechinus pictus) eggs rich in exocytotic membrane vesicles (granules) was subjected to analytical and preparative electrophoresis in the commercial automated horizontal gel electrophoresis apparatus (HPGE-1000, LabIntelligence, Belmont, CA) capable of intermittent scanning of the migration path, using buffered solutions of polyvinylpyrrolidone (PVP). The nonfluorescent granules were detected by "fluorescence reduction", i.e., a decrease of fluorescence intensity due to the absorbance and/or light scattering properties of the particle. Granules migrated at linear migration rates in buffers ranging from 0 to 2.5% PVP. Two bands were observed and optimally separated in 1.5% PVP solution. As shown by sodium dodecyl sulfate (SDS)-polypeptide patterns, the material recovered from the bands was qualitatively indistinguishable from the two major fractions A and C of granules previously separated by free-flow electrophoresis in the absence of polymer. Ferguson plot analysis failed to provide the sizes of the granules in view of the narrow PVP concentration range available for mobility measurement and the unavailability of chemically homogeneous size standards.