Determination of tobramycin in human serum by capillary electrophoresis with contactless conductivity detection

A sensitive tobramycin electrochemical aptasensor based on multiple signal amplification cascades

The residue of tobramycin, a broad spectrum antibiotic commonly used in animal husbandry, has evitable impact on human health, which may cause kidney damage, respiratory paralysis, neuromuscular blockade and cross-allergy in humans. Sensitive monitoring of tobramycin in animal-derived food products is therefore of great importance. Herein, a new aptamer electrochemical biosensor for sensing tobramycin with high sensitivity is demonstrated via exonuclease III (Exo III) and metal ion-dependent DNAzyme recycling and hybridization chain reaction (HCR) signal amplification cascades. Tobramycin analyte binds aptamer-containing hairpin probe to switch its conformation to expose the toehold sequence, which triggers Exo III-based catalytic digestion of the secondary hairpin to release many DNAzyme strands. The substrate hairpins immobilized on the Au electrode (AuE) are then cyclically cleaved by the DNAzymes to form ssDNAs, which further initiate HCR formation of lots of long methylene blue (MB)-tagged dsDNA polymers on the AuE. Subsequently electro-oxidation of these MB labels thus exhibit highly enhanced currents for sensing tobramycin within the 5-1000 nM concentration range with an impressive detection limit of 3.51 nM. Furthermore, this strategy has high selectivity for detecting tobramycin in milk and shows promising potential for detect other antibiotics for food safety monitoring.

Simultaneous Determination of Ceftazidime in Three Different Pharmaceutical Preparations Combined with Either Tazobactam, Tobramycin or Sulbactam by HPTLC-Spectrodensitometric Method

A new, simple hight performance thin layer chromatography (HPTLC)-Spectrodensitometric strategy was created and approved for the synchronous estimation of four antibacterial specialists: ceftazidime (CEF), tazobactam (TAZ), tobramycin (TOB) and sulbactam (SUL). The four compounds were separated on TLC aluminum plates covered with silica gel 60 F254, using chloroform-acetonitrile-methanol-ammonia (4:1:0.5:0.15, v/v/v/v) as a mobile phase at 254 nm. Linear correlation was obeyed over the concentration ranges of 12.0-72.0, 2.0-12.0, 3.0-18.0 and 10.0-50.0 μg mL-1 for CEF, TAZ, TOB and SUL, respectively. The proposed approach is efficient, repeatable and convenient as a flexible method for the quality control of diverse combinations of these pharmaceuticals in various pharmaceutical preparations, with high percent recoveries that are highly consistent with labeled data. When the findings of the proposed technique were compared to those of the comparison methods, there were no critical contrasts in terms of precision and accuracy.

Monitoring of amoxicilline and ceftazidime in the microdialysate of diabetic foot and serum by capillary electrophoresis with contactless conductivity detection

Determination of the broad-spectrum antibiotics amoxicilline (AMX) and ceftazidime (CTZ) in blood serum and microdialysates of the subcutaneous tissue of the lower limbs is performed using CE with contactless conductivity detection (C⁴ D). Baseline separation of AMX is achieved in 0.5 M acetic acid as the background electrolyte and separation of CTZ in 3.2 M acetic acid with addition of 13% v/v methanol. The CE-C⁴ D determination is performed in a 25 µm capillary with suppression of the EOF using INST-coating on an effective length of 18 cm and the attained migration time is 4.2 min for AMX and 4.4 min for CTZ. The analysis was performed using 20 µl of serum and 15 µl of microdialysate, treated by the addition of acetonitrile in a ratio of 1/3 v/v and the sample is injected into the capillary using the large volume sample stacking technique. The LOQ attained in the microdialysate is 148 ng/ml for AMX and 339 ng/ml for CTZ, and in serum 143 ng/ml for AMX and 318 ng/ml for CTZ. The CE-C⁴ D method is employed for monitoring the passage of AMX and CTZ from the blood circulatory system into the subcutaneous tissue at the sites of diabetic ulceration in patients suffering from diabetic foot syndrome and also for measuring the pharmacokinetics following intravenous application of bolus antibiotic doses.

Determination of tobramycin in eye drops with an open-source hardware ion mobility spectrometer

The analysis of tobramycin was demonstrated successfully as an example for electrospray ionization on an open-source hardware ion mobility spectrometer. This instrument was assembled inexpensively in-house, and required only very few purpose-made components. The quantitative determination of tobramycin required 20 s for a reading. The calibration curve for the range from 50 to 200 μM was found to be linear with a correlation coefficient of r = 0.9994. A good reproducibility was obtained (3% relative standard deviation) and the limit of detection was determined as 8 μM. As the concentration of the active ingredient in the eye drops (ophthalmic solutions) is too high for the sensitivity of the instrument, the samples had to be diluted appropriately.

Sensitive determination of tobramycin using homocystine capped gold nanoclusters as probe by second-order scattering

A novel photoluminescent Hcy-AuNCs has been developed through one-pot reduction method, to establish a tobramycin sensing by second-order scattering (SOS). Hcy-AuNCs could spontaneously assemble to small-scaled aggregation, resulting in remarkable intensity enhancement of scattered luminescence signals. The luminescence of Hcy-AuNCs could be clearly observed under ultraviolet lamp, when excited at 365 nm, a significant luminescent intensity at 741 nm was monitored in SOS spectra. The introduction of AuNPs would cause large-scaled aggregation of Hcy-AuNCs that was rapidly settled in the solution, resulting in the decrease of SOS intensity. Besides, the non-radiative energy transfer between AuNPs and Hcy-AuNCs would also reduce the luminescent intensity. However, the addition of tobramycin would cause the aggregation of AuNPs due to the electrostatic and covalent bonding between AuNPs and tobramycin, thus eliminating the interference of AuNPs. The luminescence of Hcy-AuNCs reappeared, exhibiting an optical response toward tobramycin. The good linearity was obtained in a wide range from 4 nM to 300 nM with a low detection limit of 0.27 nM. The selectivity was acceptable toward different types of antibiotics. Finally, the proposed method was successfully applied to the widely used tobramycin eye drops.

Simultaneous separation of 12 different classes of antibiotics under the condition of complete protonation by capillary electrophoresis-coupled contactless conductivity detection

A novel capillary electrophoresis - capacitively coupled contactless conductivity detection (CE-C⁴D) method for the separation of 12 antibiotics, including four types of aminoglycosides, three types of fluoroquinolones, two types of tetracyclines, and three types of macrolides, was developed. Half of these antibiotics were not determined by ultraviolet (UV) because of their lack of UV-absorbing groups. Formic acid (FA) (pH 2.50) with low conductivity was employed as the background electrolyte (BGE) in comparison with three BGE systems (i.e., HAc, HCl and H₃PO₄), which not only allowed complete protonation and electrophoresis separation but provided more cost-effectiveness and shorter analysis time. Under these conditions, a UV detector was employed as an additional detection mode to evaluate the qualitative analysis of 6 antibiotics possessing UV absorbing groups. Moreover, it was found that the sensitivities of the C⁴D and UV detectors were similar. Albeit a slightly reduced sensitivity of C⁴D in the analysis of norfloxacin, enrofloxacin and tylosin compared to UV, enough points were achieved to detect all analytes by C⁴D. The repeatability with respect to peak areas and migration times was better than 4.69% and 2.48% (n = 5), respectively. Mixed liquid pharmaceutical formulations of tobramycin eye drops having non-UV absorbing groups and ofloxacin eye drops possessing UV absorbing groups have been separated and detected in a single run by this technique. The studied recoveries of the two were 100% and 103%, respectively.

Low-cost and versatile analytical tool with purpose-made capillary electrophoresis coupled to contactless conductivity detection: Application to antibiotics quality control in Vietnam

In this study, the development of our purpose-made capacitively coupled contactless conductivity detection (C⁴ D) for CE is reported. These systems have been employed as a simple, versatile, and cost-effective analytical tool. CE-C⁴ D devices, whose principle is based on the control of the ion movements under an electrical field, can be constructed even with a modest financial budget and limited infrastructure. A featured application was developed for quality control of antimicrobial drugs using CE-C⁴ D, with most recent work on determination of aminoglycoside and glycopeptide antibiotics being communicated. For aminoglycosides, the development of CE-C⁴ D methods was adapted to two categories. The first one includes drugs (liquid or powder form) for intravenous injection, containing either amikacin, streptomycin, kanamycin A, or kanamycin B. The second one covers drugs for eye drops (liquid or ointment form), containing either neomycin, tobramycin, or polymyxin. The CE-C⁴ D method development was also made for determination of some popular glycopeptide antibiotics in Vietnam, including vancomycin and teicoplanin. The best detection limit achieved using the developed CE-C⁴ D methods was 0.5 mg/L. Good agreement between results from CE-C⁴ D and the confirmation method (HPLC- Photometric Diode Array ) was achieved, with their result deviations less than 8% and 13% for aminoglycoside and glycopeptide antibiotics, respectively.

Improved reversed phase liquid chromatographic method with pulsed electrochemical detection for tobramycin in bulk and pharmaceutical formulation

Tobramycin is one of the aminoglycoside antibiotics that lack a UV absorbing chromophore. However, the application of pulsed electrochemical detection (PED) has been used successfully for the analysis of this and similar antibiotics. This work describes an improved liquid chromatographic (LC) method combined with PED, which is able to separate much more impurities than before. Using a Discovery C-18 RP column (250 mm×4.6 mm i.d., 5 μm), isocratic elution was carried out with a mobile phase, containing sodium sulfate (35 g/L), sodium octanesulphonic acid (1 g/L), tetrahydrofuran (14 mL/L) and 0.2 M phosphate buffer pH 3.0 (50 mL/L). Using these experimental conditions, the limit of quantification (LOQ, S/N=10) was 5 ng. The linearity was examined in the range LOQ-60 μg/mL and the coefficient of determination was 0.998. The method also proved to be repeatable and the recovery was close to 100%. The influence of the different chromatographic parameters on the separation was investigated by means of an experimental design. The proposed method is useful in quality control of tobramycin drug substances and drug products.

Impedimetric aptasensor for tobramycin detection in human serum

An RNA aptamer is proposed as a recognition element for the detection of tobramycin in human serum. A displacement assay was developed using faradaic-electrochemical impedance spectroscopy (F-EIS) as a detection technique. Two modified aptamers, a partially (ATA) and a fully O-methylated aptamer (FATA) were evaluated and compared. The affinity constant, K(D), for both aptamers was estimated by F-EIS resulting virtually identical within the experimental error. The selectivity towards other aminoglycosides was also studied. The analytical characteristics were evaluated in aqueous solution using both aptamers and FATA was selected for human serum experiments. Using a 1:0.5 dilution of the serum, a linear range between 3 μM and 72.1 μM was obtained, which included the therapeutic range of the antibiotic.

Contemporary sample stacking in CE

Sample stacking techniques remain an important tool for enhancement of the selectivity and sensitivity of analyses in contemporary CZE. This contribution reviews new knowledge on this topic published since 2006. It is organized according to the operational principles used, which include concentration adjustment, application of a pH step, MEKC and sweeping, and transient ITP. Techniques combining several of these principles and comparative studies are also included.

Capillary electrophoresis and microchip capillary electrophoresis with electrochemical and electrochemiluminescence detection

Recent advances and key strategies in capillary electrophoresis and microchip CE with electrochemical detection (ECD) and electrochemiluminescence (ECL) detection are reviewed. This article consists of four main parts: CE-ECD; microchip CE-ECD; CE-ECL; and microchip CE-ECL. It is expected that ECD and ECL will become powerful tools for CE microchip systems and will lead to the creation of truly disposable devices. The focus is on papers published in the last two years (from 2005 to 2006).