Sensitive determination of carbohydrates labelled withp-nitroaniline by capillary electrophoresis with photometric detection using a 406 nm light-emitting diode

Analytical devices based on light-emitting diodes--a review of the state-of-the-art

A general overview of the development of the uses of light-emitting diodes in analytical instrumentation is given. Fundamental aspects of light-emitting diodes, as far as relevant for this usage, are covered in the first part. The measurement of light intensity is also discussed, as this is an essential part of any device based on light-emitting diodes as well. In the second part, applications are discussed, which cover liquid and gas-phase absorbance measurements, flow-through detectors for chromatography and capillary electrophoresis, sensors, as well as some less often reported methods such as photoacoustic spectroscopy.

Utilisation of pH stacking in conjunction with a highly absorbing chromophore, 5-aminofluorescein, to improve the sensitivity of capillary electrophoresis for carbohydrate analysis

This study explores the use of pH stacking in conjunction with 5-aminofluorescein as a derivatization agent for the sensitive analysis of simple sugars such as glucose, lactose and maltotriose by capillary electrophoresis (CE). The derivatization agent was selected on the basis of its extremely high molar absorptivity, its compatibility with a 488nm light-emitting diode (LED) and the fact that it has two ionizable groups making it compatible with on-line stacking using a dynamic pH junction. The influence of both acetic and formic acids at concentrations of 0.19, 0.019 and 0.0019molL(-1) were investigated with regard to both derivatization efficiency and the ability to stack using a dynamic pH junction. Superior sensitivity and resolution was obtained in formic acid over acetic acid. Substantially lower peaks were obtained with 0.19molL(-1) formic acid when compared to 0.019 and 0.0019molL(-1) concentrations, which was confirmed by computer simulation studies to be due to the inadequate movement of the pH boundary for stacking. Further simulation studies combined with experimental data showed the separation with the best resolution and greatest sensitivity when the carbohydrates were derivatized with the 0.095molL(-1) formic acid. Utilisation of stacking via dynamic pH junction mode in conjunction with LED detection enabled efficiencies of 150,000 plates and detection limits in the order of 8.5x10(-8)molL(-1) for simple sugars such as glucose, lactose and maltotriose hydrate. The current system also demonstrates a 515 times improvement in sensitivity when compared to using a normal deuterium lamp, and 16 times improvement over other systems using LEDs.

Light-emitting diode-compatible probes for indirect detection of anions in CE

A range of compounds were evaluated as probes for the indirect detection of inorganic ions using CE and light-emitting diodes (LEDs) as the light source. Emphasis was placed on examining probes likely to absorb strongly in the UV-Vis region near 350-430 nm as compounds, which absorb at longer wavelengths tend to be bulkier and adsorb onto the capillary wall. These probes should act as a replacement for the very effective but carcinogenic probe chromate. Two probes were identified and evaluated: p-nitrophenol and 4-hydroxy-3,5-dinitrobenzoic acid. The former showed the most potential with low-mobility anions, while the later had a moderate electrophoretic mobility and was more suitable for a wider mobility range of analytes. However, neither could match the efficiencies and LOD of chromate for the separation of the fast inorganic ions such as chloride, nitrate and sulphate. Nevertheless, application of the 4-hydroxy-3,5-dinitrobenzoic acid system to the determination of oxalate in Bayer liquors showed excellent sensitivity and selectivity.