Heart-cutting 2-D CE using multiple detection points for chiral analysis of native amino acids

3-(4-Carboxybenzoyl)quinoline-2-carboxaldehyde labeling for direct analysis of amino acids in plasma is not suitable for simultaneous quantification of tryptophan, tyrosine, valine, and isoleucine by CE/fluorescence

Capillary electrophoresis coupled to LED-induced fluorescence detection is a robust and sensitive technique used for amino acids (AA) analysis in biological media, after labeling with 3-(4-carboxybenzoyl)quinoline-2-carboxaldehyde (CBQCA). We wanted to quantitate in plasma tryptophan (Trp), tyrosine (Tyr), valine (Val), and isoleucine (Ile). Among the different labeled AA-CBQCA, Trp has the lowest fluorescence yield, which makes its detection and quantification very difficult in biological samples such as plasma. We tried to improve Trp analysis by CE/LED-induced fluorescence detection to its maximal sensitivity by using large volume sample stacking as a preconcentration step in our analytical protocol. At pH 9.5, this step caused a drop in resolution during the separation of the four AAs and it was therefore necessary to work at pH 10. We have found that Tyr, Val, Ile, and Trp are detected and well separated from the other AAs, but Trp cannot be quantified in plasma samples, mainly because of the low fluorescence yield of the Trp-CBQCA derivative. The recorded LOD is 0.18 μM for Trp-CBQCA in standard solution with a resolution between Trp and Tyr of 1.2, while the LOD is 6 μM in plasma with the same resolution. Trp, Tyr, Val, and Ile are, however, efficiently quantified when using a 3 M acetic acid electrolyte and CE associated with capacitively coupled contactless conductivity detection, which also has the advantage of not requiring derivatization or large volume sample stacking. This article demonstrates, for the CE user, that quantitative analysis of these four AA in mouse plasma can be performed by CE-fluorescence after CBQCA labeling, with the exception of Trp. It can be advantageously replaced by CE/capacitively coupled contactless conductivity detection, the only efficient one for Trp, Tyr, Val, and Ile quantification. In this case, the LOD for Trp is 2 μM. The four AAs are separated with resolution with neighbors above 1.5.

Determination of amino acids by capillary and microchip electrophoresis with contactless conductivity detection - Theory, instrumentation and applications

This review article summarises aspects of the determination of amino acids using capillary and chip electrophoresis in combination with contactless conductivity detection from their historical beginnings to the present time. Discussion is included of the theory of conductivity detection in electromigration techniques, the design of contactless conductivity cells for detection in capillaries and on microchips, including the use of computer programs for simulation of the conductivity response and the process of the electrophoretic separation of amino acids. Emphasis is placed on optimisation of the background electrolyte composition, chiral separation, multidimensional separation, stacking techniques and the use of multidetection systems. There is also a description of clinical applications, the determination of amino acids in foodstuffs, waters, soils and composts with emphasis on modern techniques of sample treatment, such as microdialysis, liquid membrane extraction and many other techniques.

New Kind of Polymer Materials Based on Selected Complexing Star-Shaped Polyethers

In today’s analytical trends, there is an ever-increasing importance of polymeric materials for low molecular weight compounds including amines and drugs because they can act as carriers or capture amines or drugs. The use of this type of materials will allow the development of modern materials for the chromatographic column beds and the substrates of selective sensors. Moreover, these kinds of materials could be used as a drug carrier. Therefore, the aim of this study is presenting the synthesis and complexing properties of star-shaped oxiranes as a new sensor for the selective complexation of low molecular weight compounds. Propylene oxide and selected oxirane monomers with carbazolyl in the substituent were selected as the monomers in this case and tetrahydrofuran as its solvent. The obtained polymer structures were characterized using the MALDI-TOF. It was found that in the initiation step potassium hydride deprotonates the monomer molecule and takes also part in the nucleophilic substitution. The resulting polymeric material preferably cross-linked with selected di-oxiranes (1,2,7,8-diepoksyoktan in respect ratio 3:1 according to active center) was then used as a stationary phase in the column and thin layer chromatography for amine separation and identification. Sorption ability of the resulting deposits was determined using a quartz microbalance (QCMB). The study was carried out in stationary mode and flow cells to simulate actual operating phase conditions. Based on changes in electrode vibration frequency, the maximum amount of adsorbed analyte and the best conditions for its sorption were determined.

Selectivity enhancement in capillary electrophoresis by means of two-dimensional separation or dual detection concepts

For the identification and quantification of analytes in complex samples, highly selective analytical strategies are required. The selectivity of single separation techniques such as gas chromatography (GC), liquid chromatography (LC), or capillary electrophoresis (CE) with common detection principles can be enhanced by hyphenating orthogonal separation techniques but also by using complementary detection systems. In this review, two-dimensional systems containing CE in at least one dimension are reviewed, namely LC-CE or 2D CE systems. Particular attention is paid to the aspect of selectivity enhancement due to the orthogonality of the different separation mechanisms. As an alternative concept, dual detection approaches are reviewed using the common detectors of CE such as UV/VIS, laser-induced fluorescence, capacitively coupled contactless conductivity (C⁴D), electrochemical detection, and mass spectrometry. Special emphasis is given to dual detection systems implementing the highly flexible C⁴D as one detection component. Selectivity enhancement can be achieved in case of complementarity of the different detection techniques.

Using ZIF-8 as stationary phase for capillary electrophoresis separation of proteins

Recently, the separation of proteins has received much attention, although many techniques require expensive instrumentation and trained analysts. In this work, a low-cost, effective, and environmental friendship capillary electrophoresis (CE) for proteins separation was first time introduced. The ZIF-8 with outstanding properties of large surface area, and accessible tunnels and cages were coated the inner surface of silica capillary as a separation media by electrostatic interaction. The fast baseline separation of Lys, CC, BSA and RNase A can be obtained within 10 min using the ZIF-8 nanocrystals coated capillary column under the optimum separation conditions. Meanwhile, this system showed good reproducibility and stability. Using L-glutamic acid as the selector ligand, the D- and L-phenylalanine were successfully separated by the ZIF-8 nanocrystals coated capillary column. Furthermore, the method was also applied to separate egg white proteins, and three main proteins were separated in a single run.

High-Speed, Comprehensive, Two Dimensional Separations of Peptides and Small Molecule Biological Amines Using Capillary Electrophoresis Coupled with Micro Free Flow Electrophoresis

Two-dimensional (2D) separations are able to generate significantly higher peak capacities than their one-dimensional counterparts. Unfortunately, current hyphenated 2D separations are limited by the speed of the second dimension separation and the consequent loss of peak capacity due to under sampling of peaks as they elute from the first dimension separation. Continuous micro free flow electrophoresis (μFFE) separations eliminate under sampling as a limitation when incorporated as the second dimension of a 2D separation. In the current manuscript we describe the first coupling of capillary electrophoresis (CE) with μFFE to perform 2D CE × μFFE separations. The CE separation capillary was directly inserted into the μFFE separation channel using an edge on interface. Analyte peaks streamed directly into the μFFE separation channel as they migrated off the CE capillary. No complicated injection, valving, or voltage changes were necessary to couple the two separation modes. 2D CE × μFFE generated an ideal peak capacity of 2 592 in a 9 min separation of fluorescently labeled peptides (7.6 min separation window, 342 peaks/min). Data points were recorded every 250-500 ms (>8 data points/peak), effectively eliminating under sampling as a source of band broadening. CE × μFFE generated an ideal peak capacity of 1885 in a 2.7 min separation of fluorescently labeled small molecule bioamines (1.8 min separation window, 1053 peaks/min). Peaks in the 2D CE × μFFE separation of peptides covered 30% of the available separation space, resulting in a corrected peak capacity of 778 (102 peaks/min). The fractional coverage of the 2D CE × μFFE separation of small molecule bioamines was 20%, resulting in a corrected peak capacity of 377 (209 peaks/min).

Chiral selectors in CE: recent developments and applications

This review article provides an overview of the recent advances in enantioanalysis by use of electrophoretic techniques. Due to the big number of publications in the subject mentioned above, this article is focused on chiral method developments and applications published from 2008 until 2011, and it demonstrates chiral selectors used in CE. Numerous chiral selectors have been used over the years, and these include the cyclic and the linear oligo- and polysaccharides, the branched polysaccharides, the polymeric and monomeric surfactants, the macrocyclic and other antibiotics, and the crown ethers. Different dual-selector systems are also presented in this article, and the results are compared with those obtained by use of a single chiral selector. Finally, several pharmaceutical and biomedical applications based on chiral recognition are summarized.

Electrochemical methods in conjunction with capillary and microchip electrophoresis

Electromigrative techniques such as capillary and microchip electrophoresis (CE and MCE) are inherently associated with various electrochemical phenomena. The electrolytic processes occurring in the buffer reservoirs have to be considered for a proper design of miniaturized electrophoretic systems and a suitable selection of buffer composition. In addition, the control of the electroosmotic flow plays a crucial role for the optimization of CE/MCE separations. Electroanalytical methods have significant importance in the field of detection in conjunction with CE/MCE. At present, amperometric detection and contactless conductivity detection are the predominating electrochemical detection methods for CE/MCE. This paper reviews the most recent trends in the field of electrochemical detection coupled to CE/MCE. The emphasis is on methodical developments and new applications that have been published over the past five years. A rather new way for the implementation of electrochemical methods into CE systems is the concept of electrochemically assisted injection which involves the electrochemical conversions of analytes during the injection step. This approach is particularly attractive in hyphenation to mass spectrometry (MS) as it widens the range of CE-MS applications. An overview of recent developments of electrochemically assisted injection coupled to CE is presented.

Recent progress for capillary electrophoresis with electrochemical detection

Capillary electrophoresis (CE) is an attractive technique in separation science because of its high separation performance, short analysis time and low cost. Electrochemical detection (EC) is a powerful tool for CE because of its high sensitivity. In this review, developments of CE-EC from 2008 to August, 2011 are reviewed. We choose papers of innovative and novel results to demonstrate the newest and most important progress in CE-EC.

Recent advances in amino acid analysis by capillary electrophoresis

This paper describes the most important articles that have been published on amino acid analysis using CE during the period from June 2009 to May 2011 and follows the format of the previous articles of Smith (Electrophoresis 1999, 20, 3078-3083), Prata et al. (Electrophoresis 2001, 22, 4129-4138) and Poinsot et al. (Electrophoresis 2003, 24, 4047-4062; Electrophoresis 2006, 27, 176-194; Electrophoresis 2008, 29, 207-223; Electrophoresis 2010, 31, 105-121). We present new developments in amino acid analysis with CE, which are reported describing the use of lasers or light emitting diodes for fluorescence detection, conductimetry electrochemiluminescence detectors, mass spectrometry applications, and lab-on-a-chip applications using CE. In addition, we describe articles concerning clinical studies and neurochemical applications of these techniques.