Highly sensitive rapid determination of orotic acid in urine samples using a field-amplified sample stacking approach in capillary electrophoresis coupled with contactless conductivity detection

Orotic aciduria is a severe, hereditary, life-threatening condition, particularly in newborns. An increased orotic acid (OA) content in urine may be a strong indicator of this condition. In this study, we developed a rapid, simple, highly sensitive diagnostic method for use in monitoring the OA levels in urine samples, which were successfully determined using capillary electrophoresis combined with capacitively coupled contactless conductivity detection (CE-C4D). A straightforward analysis with an increased sensitivity towards OA and an analysis time of approximately 5 min were realized, and the limit of detection of the developed method was 0.014 mg/L in aqueous solution. The optimized composition of the separation electrolyte was 20 mM 2-(N-morpholino)ethanesulfonic acid/histidine with 0.1 mM cetyltrimethylammonium bromide at a pH of 6.5. The sensitivity of the developed method was significantly increased using a sample stacking approach with a 10% acetonitrile (v/v) plug solution. The method was validated, and satisfactory recoveries of 80.0-92.3% were obtained. The amounts of OA in five urine samples were successfully determined.

Gamma-hydroxybutyrate (GHB), 1,4-butanediol (1,4BD), and gamma-butyrolactone (GBL) intoxication: A state-of-the-art review

γ-hydroxybutyrate (GHB) is synthesized endogenously from γ-aminobutyric acid (GABA) or exogenously from 1,4-butanediol (butane-1,4-diol; 1,4-BD) or γ-butyrolactone (GBL). GBL, and 1,4-BD are rapidly converted to GHB. The gastric absorption time, volume of distribution, and half-life of GHB are between 5 and 45 min, 0.49 ± 0.9 L/kg, and between 20 and 60 min, respectively. GHB and its analogues have a dose-dependent effect on the activation of GHB receptor, GABA-B, and GABA localized to the central nervous system. After ingestion, most patients present transient neurological disorders (lethal dose: 60 mg/kg). Chronic GHB consumption is associated with disorders of use and a withdrawal syndrome when the consumption is discontinued. GHB, GBL, and 1,4-BD are classified as narcotics but only the use of GHB is controlled internationally. They are used for drug facilitated (sexual) assault, recreational purposes, slamsex, and chemsex. To confirm an exogenous intake or administration of GHB, GBL, or 1-4-BD, the pre-analytical conservation is crucial. The antemortem cutoff doses for detection are 5 and 5-15 mg/L, with detection windows of 6 and 10 h in the blood and urine, respectively Control of GHB is essential to limit the number of users, abuse, associated risks, and death related to their consumption.

A five-electrode capacitively coupled contactless conductivity detector with a low limit of detection

The conductivity detector is a broadly used device that allows for the highly efficient detection of analytes, and continuous efforts have been directed toward lowering the limit of detection. In this study, a five-electrode capacitively coupled contactless conductivity detector (TIC⁴D) is proposed, which uses copper mesh between the electrodes for a grounding shield to reduce the interference of stray capacitance and noise. After adding the copper mesh shield, the difference value between the response signal and baseline at low KCl concentration is effectively increased, achieving 33 mV for 10^-9 M KCl solution. Meanwhile, for the unshielded detector, the difference is only 18 mV for the KCl solution at the same concentration. The response signal shows a linear function of the logarithm at the range of 10^-4 M to 10^-5 M KCl solution, and the TIC⁴D detector displays a higher slope (0.8448) than the conventional single-input capacitively coupled contactless conductivity detector (C⁴D: 0.5579) and dual-input capacitively coupled contactless conductivity detectors (DIC⁴D: 0.6173). Moreover, two TIC⁴D detectors are combined to achieve a dual-channel six-input differential capacitively coupled contactless conductivity detector (SIDC⁴D), reducing the high baseline levels caused by the multi-signal input. By differentially amplifying the output signal, the high baseline levels and noise interference can be effectively reduced. For the 10^-3 M KCl solution, the ratio of the response signal to baseline for SIDC⁴D can reach 8.500, almost 7 times that of TIC⁴D, and a lower limit of detection (LOD) of 3 × 10^-10 M is also achieved. This work may open a new door based on coupled contactless conductivity for detection performance.

Capillary electrophoresis of small ions and molecules in less conventional human body fluid samples: A review

In recent years, advances in sensitive analytical techniques have encouraged the analysis of various compounds in biological fluids. While blood serum, blood plasma and urine still remain the golden standards in clinical, toxicological and forensic science, analyses of other body fluids, such as breast milk, exhaled breath condensate, sweat, saliva, amniotic fluid, cerebrospinal fluid, or capillary blood in form of dried blood spots are becoming more popular. This review article focuses on capillary electrophoresis and microchip electrophoresis of small ions and molecules (e.g. inorganic cations/anions, basic/acidic drugs, small acids/bases, amino acids, peptides and other low molecular weight analytes) in various less conventional human body fluids and hopes to stimulate further interest in the field.

Selectivity enhancement in capillary electrophoresis by means of two-dimensional separation or dual detection concepts

For the identification and quantification of analytes in complex samples, highly selective analytical strategies are required. The selectivity of single separation techniques such as gas chromatography (GC), liquid chromatography (LC), or capillary electrophoresis (CE) with common detection principles can be enhanced by hyphenating orthogonal separation techniques but also by using complementary detection systems. In this review, two-dimensional systems containing CE in at least one dimension are reviewed, namely LC-CE or 2D CE systems. Particular attention is paid to the aspect of selectivity enhancement due to the orthogonality of the different separation mechanisms. As an alternative concept, dual detection approaches are reviewed using the common detectors of CE such as UV/VIS, laser-induced fluorescence, capacitively coupled contactless conductivity (C⁴D), electrochemical detection, and mass spectrometry. Special emphasis is given to dual detection systems implementing the highly flexible C⁴D as one detection component. Selectivity enhancement can be achieved in case of complementarity of the different detection techniques.