Quantitative remineralization evolution kinetics of artificially demineralized human enamel using photothermal radiometry and modulated luminescence

Impact of angle on photothermal radiometry and modulated luminescence (PTR/LUM) value

OBJECTIVE

To evaluate the impact of scanning angles to detect/quantify non-cavitated caries by photothermal-radiometry and modulated-luminescence (PTR/LUM, Canary System) and to evaluate the association of PTR/LUM value with lesion depth (LD), including sound tissue thickness under the lesion (ST).

METHODS

Thirty human extracted premolars were selected based on micro-computed tomography [μ-CT: sound (n=12), lesions into outer-half of enamel (n=6), lesions into inner-half of enamel (n=6), lesions into outer one-third of dentine (n=6)]. Each tooth sample was scanned 90° directly contacted to the center of non-cavitated lesion or sound smooth surface, and tilted 10° and 20° in four directions: buccal/lingual/occlusal/cervical. The procedure was repeated 48 h later. Lesion depth and ST [ST=5000 µm (maximum PTR/LUM scanning depth)-LD] were measured at the same scanning direction on μ-CT images. Sensitivity, specificity, area under the Receiver Operating Characteristic curve (AUC), and intraclass correlation coefficients (ICC) for different scanning angles were calculated. Sensitivity was further evaluated based on lesion extensions. Relationships between PTR/LUM value and lesion depth, and between PTR/LUM value and LD/ST-Ratio were evaluated.

RESULTS

PTR/LUM value showed significant differences among scanning angles. Overall sensitivity (78%-89%), specificity (66%-87%), AUC (0.86-0.92) and ICC (0.89-0.99), sensitivity based on lesion extensions presented no significant differences among angles. PTR/LUM value showed moderate correlations (0.56-0.74) with deepest lesion depth and LD/ST-Ratios.

CONCLUSION

The scanning angle within 20° increments might impact PTR/LUM value statistically; however, it did not affect PTR/LUM detection performance. PTR/LUM values were positively correlated with non-cavitated lesion depth, and not affected by sound tissue thickness under the lesion.

CLINICAL SIGNIFICANCE

Clinically, it is challenging to measure/scan at the same location and same angle longitudinally, however, it is important to standardize these parameters. Scanning within 20° deviation from perpendicular did not affect detection performance of PTR/LUM, and PTR/LUM value showed positive moderate correlation with caries depth.

Quantitative Measurements of the Depth of Enamel Demineralization before and after Bleach: An In Vitro Study

Objective

This study is aimed at determining two main points. First, if the Canary System™ (CS), initially used to assess caries, can measure a decalcification depth of bleached enamel quantitatively, and second, whether or not whitening has a harmful effect on enamel. This device can be considered a useful tool in the clinical assessment of the progression of demineralization after bleaching.

Materials and Methods

This study collected sixty human premolars that are in a good state recently extracted for orthodontic reason. To properly disinfect and preserve the premolars, they were stored in a saline solution and later in distilled water for a period of two weeks to allow the premolars to rehydrate. Later, 24 hours before the experiment, the premolars were introduced into a solution of artificial saliva to acquire back their minerals. The mineral content of the teeth was measured by the Canary System™ before bleaching. The teeth were bleached with 30% hydrogen peroxide (fläsh HP 30%), 30 min per week and for 3 consecutive weeks to simulate the conditions of strong bleaching in the clinic. The extent of demineralized enamel was measured by the Canary System™ at three points on the enamel surface of each tooth. The data were averaged for each application of the bleaching product. The demineralization extent of the teeth was measured by the Canary System™ before and after bleaching. The significance level was set at 0.05, and SPSS version 26 was used. The data were analyzed by using Wilcoxon's and Student's tests.

Results

Mineral loss occurred after the first bleaching session; the Canary System™ detected a decalcification in the first bleaching session (532 ± 322 μm) compared to the other sessions (p ≤ 0.05), while no significant change was detected between the second and the third sessions (p > 0.05).

Conclusion

Based on the findings of the present study, under in vitro conditions, it was possible to measure the demineralization extent of bleached enamel with the Canary System™.

Detection of Caries Around Resin-Modified Glass Ionomer and Compomer Restorations Using Four Different Modalities In Vitro

The aim of this study was to evaluate the ability of visual examination (International Caries Detection and Assessment System—ICDAS II), light-emitting diodes (LED) fluorescence (SPECTRA), laser fluorescence (DIAGNODent, DD), photothermal radiometry and modulated luminescence (PTR-LUM, The Canary System, CS) to detect natural decay beneath resin-modified glass ionomer (RMGIC) and compomer restorations in vitro. Twenty-seven extracted human molars and premolars, consisting of 2 control teeth, 10 visually healthy/sound and 15 teeth with natural cavitated lesions, were selected. For the carious teeth, caries was removed leaving some carious tissue on one wall of the preparation. For the sound teeth, 3 mm deep cavity preparations were made. All cavities were restored with RMGIC or compomer restorative materials. Sixty-eight sites (4 sites on sound unrestored teeth, 21 sound sites and 43 carious sites with restorations) were selected. CS and DD triplicate measurements were done at 2, 1.5, 0.5, and 0 mm away from the margin of the restoration (MOR). SPECTRA images were taken, and two dentists provided ICDAS II scoring for the restored surfaces. The SPECTRA data and images were inconclusive due to signal interference from the restorations. Visual examinations of the restored tooth surfaces were able to identify 5 of the 15 teeth with caries. In these situations, the teeth were ranked as having ICDAS II 1 or 2 rankings, but they could not identify the location of the caries or depth of the lesion. CS and DD were able to differentiate between sound and carious tissue at the MOR, but larger variation in measurement, and poorer accuracy, was observed for DD. It was concluded that the CS has the potential to detect secondary caries around RMGIC and compomer restorations more accurately than the other modalities used in this study.

Multi-Centre Clinical Evaluation of Photothermal Radiometry and Luminescence Correlated with International Benchmarks for Caries Detection

INTRODUCTION

A clinical study was initiated to investigate a caries detection device (The Canary System (CS)), based on photothermal radiometry and modulated luminescence (PTR-LUM). The primary objective of this study was to determine if PTR-LUM values (in the form of Canary Numbers; CN) correlate with International Caries Diagnostic and Assessment System (ICDAS II) scores and clinical situations. The secondary objectives of this study were to monitor the safety of PTR-LUM, and collect data to determine how CN values could be used to differentiate healthy from decayed tooth surfaces on a normalized scale.

METHODS

The trial was a four site, non-blinded study. Data was collected from 92 patients, resulting in 842 scanned tooth surfaces over multiple appointments. Surfaces were assessed according to ICDAS II, and further stratified into five clinical situation categories: 1) healthy surface, 2) non-cavitated white and/or brown spots; 3) caries lesions; 4) cavitation and 5) teeth undergoing remineralization therapy.CN data was analyzed separately for smooth and occlusal surfaces. Using a semi-logarithmic graph to plot raw CN (rCN) and normalized (CN) values, rCN data was normalized into a scale of 0-100.

RESULTS

Linear correlations (R2) between CN and ICDAS II groupings for smooth and occlusal surfaces were calculated as 0.9759 and 0.9267, respectively. The mean CN values derived from smooth (20.2±0.6) and occlusal (19±1.0) surfaces identified as healthy had significantly lower CN values (P<0.05) compared with the values from the other clinical situation categories. No adverse events were reported.

CONCLUSION

The present study demonstrated the safety of PTR-LUM for clinical application and its ability to distinguish sound from carious tooth surfaces. A clear shift from the baseline in both PTR and LUM in carious enamel was observed depending on the type and nature of the lesion, and correlated to ICDAS II classification codes, which enabled the preliminary development of a Canary Scale.

Use of new minimum intervention dentistry technologies in caries management

Preservation of natural tooth structure requires early detection of the carious lesion and is associated with comprehensive patient dental care. Processes aiming to detect carious lesions in the initial stage with optimum efficiency employ a variety of technologies such as magnifying loupes, transillumination, light and laser fluorescence (QLF® and DIAGNOdent® ) and autofluorescence (Soprolife® and VistaCam®), electric current/impedance (CarieScan(®) ), tomographic imaging and image processing. Most fluorescent caries detection tools can discriminate between healthy and carious dental tissue, demonstrating different levels of sensitivity and specificity. Based on the fluorescence principle, an LED camera (Soprolife® ) was developed (Sopro-Acteon, La Ciotat, France) which combined magnification, fluorescence, picture acquisition and an innovative therapeutic concept called light-induced fluorescence evaluator for diagnosis and treatment (LIFEDT). This article is rounded off by a Soprolife® illustration about minimally or even non-invasive dental techniques, distinguishing those that preserve or reinforce the enamel and enamel-dentine structures without any preparation (MIT1- minimally invasive therapy 1) from those that require minimum preparation of the dental tissues (MIT2 - minimally invasive therapy 2) using several clinical cases as examples. MIT1 encompasses all the dental techniques aimed at disinfection, remineralizing, reversing and sealing the caries process and MIT2 involves a series of specific tools, including microburs, air abrasion devices, sonic and ultrasonic inserts and photo-activated disinfection to achieve minimal preparation of the tooth. With respect to minimally invasive treatment and prevention, the use of lasers is discussed. Furthermore, while most practices operate under a surgical model, Caries Management by Risk Assessment (CaMBRA) encourages a medical model of disease prevention and management to control the manifestation of the disease, or keep the oral environment in a state of balance between pathological and preventive factors. Early detection and diagnosis and prediction of lesion activity are of great interest and may change traditional operative procedures substantially. Fluorescence tools with high levels of magnification and observational capacity should guide clinicians towards a more preventive and minimally invasive treatment strategy.

Remineralization of artificial enamel lesions by theobromine

OBJECTIVE

This study investigated the remineralization potential of theobromine in comparison to a standard NaF dentifrice.

METHODS

Three tooth blocks were produced from each of 30 teeth. Caries-like lesion was created on each block using acidified gel. A smaller block was cut from each block for baseline scanning electron microscopy imaging and electron-dispersive spectroscopy (EDS) analysis for surface Ca level. A tooth slice was cut from each lesion-bearing block for transverse microradiography (TMR) quantification of baseline mineral loss (Δz) and lesion depth (LD). Then baseline surface microhardness (SMH) of each lesion was measured. The three blocks from each tooth were assigned to three remineralizing agents: (1) artificial saliva; (2) artificial saliva with theobromine (0.0011 mol/l), and (3) NaF toothpaste slurry (0.0789 mol/l F). Remineralization was conducted using a pH cycling model with storage in artificial saliva. After a 28-day cycle, samples were analyzed using EDS, TMR, and SMH. Intragroup comparison of pre- and posttest data was performed using t tests (p < 0.05). Intergroup comparisons were performed by post hoc multistep comparisons (Tukey).

RESULTS

SMH indicated significant (p < 0.01) remineralization only with theobromine (38 ± 32%) and toothpaste (29 ± 16%). With TMR (Δz/lD), theobromine and toothpaste exhibited significantly (p < 0.01) higher mineral gain relative to artificial saliva. With SMH and TMR, remineralization produced by theobromine and toothpaste was not significantly different. With EDS, calcium deposition was significant in all groups, but not significantly different among the groups (theobromine 13 ± 8%, toothpaste 10 ± 5%, and artificial saliva 6 ± 8%).

CONCLUSION

The present study demonstrated that theobromine in an apatite-forming medium can enhance the remineralization potential of the medium.