Distinct Binding Interactions of α5β1-Integrin and Proteoglycans with Fibronectin

Dynamic single-molecule force spectroscopy was performed to monitor the unbinding of fibronectin with the proteoglycans syndecan-4 (SDC4) and decorin and to compare this with the unbinding characteristics of α₅β₁-integrin. A single energy barrier was sufficient to describe the unbinding of both SDC4 and decorin from fibronectin, whereas two barriers were observed for the dissociation of α₅β₁-integrin from fibronectin. The outer (high-affinity) barriers in the interactions of fibronectin with α₅β₁-integrin and SDC4 are characterized by larger barrier heights and widths and slower dissociation rates than those of the inner (low-affinity) barriers in the interactions of fibronectin with α₅β₁-integrin and decorin. These results indicate that SDC4 and (ultimately) α₅β₁-integrin have the ability to withstand deformation in their interactions with fibronectin, whereas the decorin-fibronectin interaction is considerably more brittle.

Modeling the clay minerals-enzyme binding by fusion fluorescent proteins and under atomic force microscope

In the present study, binding of cellulase protein to different clay minerals were tested using fluorescent-protein complex and microscopic techniques. Cellulase gene (Cel5H) was cloned into three fluorescent vectors and expressed as fusion enzymes. Binding of Cel5H-mineral particles was confirmed by confocal microscopy, and enzyme assay. Among the Cel5H-fusion enzymes, green-fusion enzyme showed higher intensity compared with other red and yellow fusion-proteins. Intensity of fusion-proteins was dependent on the pH of the medium. Confocal microscopy revealed binding of the all three fusion proteins with different clay minerals. However, montmorillonite displayed higher binding capacity than kaolinite clay. Likewise, atomic force microscopy (AFM) image profile analysis showed proteins appeared globular molecules in free-state on mica surface with an average cross sectional diameter of 110 ± 2 nm and rough surface of montmorillonite made protein appear flattened due to structural alteration. Even surface of kaolinite also exerted some strain on protein molecular conformation after binding to surface. Our results provide further evidence for 3D visualization of enzyme-soil complex and encourage furthering study of the force involved interactions. Therefore, our results indicate that binding of proteins to clay minerals was external and provides a molecular method to observe the interaction of clay minerals-enzyme complex.

Influencing the adhesion properties and wettability of mucin protein films by variation of the environmental pH

Mucins, the main component of the mucus secretions of goblet and epithelial cells, are known for exhibiting a different behaviour in accordance with their surrounding environment (i.e. among others the environmental pH), which induces a drastic change in their measured mechanical properties. In this work, we have first employed Atomic Force Microscopy (AFM) in Force Spectroscopy mode to evaluate the adhesion of porcine mucin films at the nanoscale, and the changes caused in this particular factor by a pH variation between 7.0 and 4.0, both quite common values in biological conditions. Measurements also involved additional varying factors such as the indenting tip chemistry (hydrophobic vs hydrophilic), its residence time on the measured film (0, 1 and/or 2 seconds), and increasing pulling rates (ranging from 0.1 up to 10 µm/s). A second approach regarded the macroscale behaviour of the films, due to their potential applicability in the development of a new set of stimuli-responsive biomaterials. This was possible by means of complementary Wilhelmy plate method (to test the wetting properties) and cell proliferation studies on films previously exposed to the corresponding pH solution. According to our results, treatment with lowest pH (4.0) provides porcine mucin with a more hydrophilic character, showing a much stronger adhesion for analogous chemistries, as well as enhanced capability for cell attachment and proliferation, which opens new pathways for their future use and consideration as scaffold-forming material.