Immobilized stationary phases on the basis of polyethylene glycol

Separation of methicillin-resistant from methicillin-susceptible Staphylococcus aureus by electrophoretic methods in fused silica capillaries etched with supercritical water

Identification and prevention of Staphylococcus aureus-caused infections may benefit from a fast and dependable method to distinguish between the methicillin-resistant (MRSA) and methicillin-susceptible (MSSA) S. aureus strains. The current methods involving polymerase chain reaction and/or other molecular tests are usually laborious and time-consuming. We describe here a fast and low-cost method employing capillary zone electrophoresis (CZE) to distinguish between MRSA and MSSA. The method makes use of a supercritical water-treated fused silica capillary, the inner surface of which has subsequently been modified with (3-glycidyloxypropyl)trimethoxysilane. With optimized proportions of suitable additives to the background electrolyte, a CZE separation of MRSA from MSSA may be completed within 12 min. The cells were baseline-resolved, and resolution was determined to be 3.61. The isoelectric points of MSSA and MRSA were found to be the same for both groups of these strains, pI = 3.4.

Sol−Gel Poly(ethylene glycol) Stationary Phase for High-Resolution Capillary Gas Chromatography

A sol-gel chemistry-based method was developed for the preparation of highly stable capillary gas chromatography (GC) columns with surface-bonded poly(ethylene glycol) (PEG) stationary phase. Through a single-step procedure, it concurrently provided column deactivation, stationary-phase coating, and chemical immobilization of the coated film. Sol-gel reactions were carried out within fused-silica capillaries that were filled with properly designed sol solutions containing two sol-gel precursors, two different triethoxysilyl-derivatized poly(ethylene glycol)s, two sol-gel catalysts, and a deactivation reagent. Hydrolytic polycondensation reactions led to the formation of a sol-gel coating chemically bonded to the inner walls of the capillary. A number of sol-gel coated fused-silica capillary columns were prepared using sol-gel-active PEG derivatives. These columns demonstrated many inherent advantages, the main being the strong anchoring of the coating to the capillary wall resulting from chemical bonding with the silanol groups on the fused-silica capillary inner surface. This chemical bonding yielded strongly immobilized PEG coatings with outstanding thermal stability (up to 320 degrees C). To our knowledge, such a high thermal stability has not been achieved so far on conventionally prepared PEG GC columns. Sol-gel PEG columns provided excellent chromatographic performances: high number of theoretical plates, excellent run-to-run and column-to-column reproducibility, and pronounced selectivity for a wide range of test solutes. Using n-octadecane as a test solute (k = 7.14), an efficiency value of 3200 theoretical plates/m was obtained on a 10 m x 0.25 mm i.d. fused-silica capillary column. Five sol-gel PEG columns provided RSD values of 1.09% for column efficiency (solute, n-octadecane), 1.37% for retention factor (solute, n-octadecane), and 0.9% for separation factor (for solute pair o- and p-xylene). In five replicate measurements using the same column, RSD values of less than 0.50% for the retention time and 1.36% for retention factor (k) were obtained.

Capillary isoelectric focusing with UV-induced fluorescence detection

Low-molecular-mass fluorescent compounds excitable in the near UV region with suitable acidobasic and electrophoretic properties are suggested as isoelectric point (pI) markers for isoelectric focusing (IEF) with UV photometric and UV excited fluorometric detection. The experimental set-up of capillary IEF with UV excited fluorometric detection and properties of new UV-induced fluorescent pI markers are given. The pI values of 18 new pI markers determined independently of IEF methods range from 2.1 to 10.3. The examples of separation of new pI markers together with derivatized proteins by capillary IEF with photometric or fluorometric detection are presented.