Simultaneous HPLC determination of phenylurea herbicides and their corresponding anilines in water after on-line preconcentration

Fabrication and performance of a three-dimensionally adjustable device for the amperometric detection of microchip capillary electrophoresis

A microchip CE-amperometric detection (AD) system has been fabricated by integrating a two-dimensionally adjustable CE microchip and an AD cell containing a one-dimensionally adjustable disk detection electrode in a Plexiglas holder. It facilitates the precise 3-D alignment between the channel outlet and the detection electrode without a complicated 3-D manipulator. The performance of this unique system was demonstrated by separating five aromatic amines (1,4-phenyldiamine, aniline, 2-methylaniline, 4-chloroaniline, and 1-naphthylamine) of environmental concern. Factors influencing their separation and detection processes were examined and optimized. The five analytes have been well separated within 140 s in a 74 cm long separation channel at a separation voltage of +2500 V using a 10 mM phosphate buffer (pH 3.5). Highly linear response is obtained for the five analytes over the range 20-200 microM with the detection limits ranging from 0.46 to 1.44 microM, respectively. The present system demonstrated long-term stability and reproducibility with RSDs of less than 5% for the peak current (n = 9). The new approach for the microchannel-electrode alignment should find a wide range of applications in CE, flowing injection analysis, and other microfluidic analysis systems.

Development of an automated on-line solid-phase extraction-high-performance liquid chromatographic method for the analysis of aniline, phenol, caffeine and various selected substituted aniline and phenol compounds in aqueous matrices

A fully automated solid-phase extraction (SPE)-high-performance liquid chromatographic method has been developed for the simultaneous analysis of substituted anilines and phenols in aqueous matrices at the low- to sub-microg/l level. Diode array and electrochemical detection operated in tandem mode were used for analyte detection. Two new polymeric sorbent materials (Hysphere-GP and Hysphere-SH) were evaluated for the on-line SPE of substituted anilines and phenols from aqueous matrices and their performance was compared with the PRP-1 and PLRP-S sorbents. Hysphere-GP sorbent packed in 10 x 2 mm cartridges was found to give better results in terms of sensitivity and selectivity of the overall analytical method. The proposed analytical method was validated for the analysis of these compounds in Axios river water that receives industrial, communal and agricultural wastes. The detection limits for all the compounds range between 0.05 and 0.2 microg/l, except for aniline and phenol which have detection limits of 0.5 and 1 microg/l, respectively (aniline detected by electrochemical detection). The recoveries for all the compounds are higher than 75% except for aniline (6%), phenol (50%) and 3-chlorophenol (67%). Finally, in order to evaluate the efficiency of the Hysphere-GP (10 x 2 mm) cartridges for sample stabilization and storage, the stability of the compounds of interest at the sorbed state onto these cartridges has been evaluated under three different temperature regimes (deep freeze, refrigeration, 20 degrees C).

Determination of aromatic amines in water samples by capillary electrophoresis with electrochemical and fluorescence detection

Two capillary electrophoresis methods have been compared for the determination of aniline derivatives in environmental water samples. With the first method the anilines were separated as cations by free zone electrophoresis at low pH, and detected by amperometry. For this, the separation capillary was connected through a palladium field decoupler to an electrochemical detection cell which had been modified to match the volume scale of the separation. Most anilines tested, except chlorinated compounds, could be detected with full sensitivity at a detection potential of +0.7 V. Detection limits with this detection scheme were on a low microg/l level. The alternative method involved the derivatization of the anilines with fluorescamine, the separation of the derivatives formed by micellar electrokinetic chromatography, and fluorescence detection. For detection a lamp-based, fibre optics instrument was used. Detection limits with fluorimetry were comparable with those obtained with amperometric detection (in the order of 1 microg/l). Still, this method was preferred since it gave a higher separation efficiency and shorter analysis times (approximately 4 min). The most important argument, however, was its higher reliability and ease-of-handling. Preliminary experiments with water samples collected in areas where pollution with anilines may be expected showed that the method is highly specific, with few interferences showing up in the electropherograms.

Optimization of the separation of mono- and dichloroanilines in ion interaction high-performance liquid chromatography

To optimize the ion-interaction chromatographic separation of nine chloroaniline isomers, the effect on retention of six experimental parameters is investigated by means of multivariate analysis. The factors considered are the organic modifier concentration in the mobile phase; the length of the alkyl chain of the alkylammoniumion salts used as the ion-interaction reagents (IIRs); the concentration of IIRs; the pH of the mobile phase, the flow-rate and the ionic strength. The use of fractional factorial and star designs allowed one to draw out useful information on the retention mechanism involved and to build a model characterized by both descriptive and predictive ability. Concerning descriptions, the results suggest a retention mechanism mainly based on reversed-phase partition, while the main role of the alkylamine (used as IIR) seems to mask the activity of the residual silanol groups on the stationary phase. As a result efficiency is improved. For prediction purposes, the regression models allow the optimization of the chromatographic separation, as regards both resolution and total analysis time. The study allowed one to develop a method able to separate the nine mono- and dichloroanilines in a total analysis time within 66 min and with detection limits ranging from 4.0 to 21.0 microg/l.