Capillary electrophoresis in allergen preparation research and in production control

Profiling recombinant major birch pollen allergen Bet v 1a and carbamylated variants with CZE and CIEF

A preparation of recombinant birch pollen allergen of Betula verrucosa isoform 1a (Bet v 1a) containing chemically modified (carbamylated) variants has been analyzed by CZE and CIEF. In CZE, employing a 100 mmol/L MES buffer at pH 6.50, with 0.4 mmol/L tetraethylenepentamine (TEPA) added, allowed for the resolution of 17 protein fractions. The CIEF profiling of the allergen preparation required a combination of a wide-pH-range carrier ampholyte (CA) of pH 3-10 with two narrow-range CAs of pH 5-6 and 5-7. For CIEF, 91 mmol/L of glycine at pH 2.12 and 20 mmol/L of CHES at pH 10.00 were applied as anolyte and catholyte, respectively. The generated pH gradient was nonlinear with a flat slope for pH 4-6, thus providing an improved resolution. In CIEF, up to 18 protein fractions were distinguished as well. The pI of the target allergen Bet v 1a was 4.9 as determined by means of two pI marker compounds flanking the allergen. Relative purity of the target allergen within the preparation containing carbamylated variants was in accordance for both separation systems and varied between 40.7 and 42.8%.

Profiling preparations of recombinant birch pollen allergen Bet v 1a with capillary zone electrophoresis in pentamine modified fused-silica capillaries

Three preparation batches of the recombinant birch pollen allergen Bet v 1a have been analyzed by capillary zone electrophoresis (CZE) using a separation electrolyte consisting of 100 mmol L(-1) phosphate at pH 6.50 with 2.0 mmol L(-1) tetraethylenepentamine (TEPA) added. TEPA improved the resolution by wall shielding and selective attachment to allergens, but reduced migration repeatability at concentrations >2.0 mmol L(-1). Heterogeneity of preparations determined by CZE and electrospray ionization-quadrupole-time-of flight-MS were in accordance and revealed chemically modified (carbamylated) allergens in one of the preparations. The method was validated according to the ICH-guidelines. Repeatability of effective electrophoretic mobility (mu(eff)) was <0.55% R.S.D. (n = 5). Migration time corrected peak areas were used for quantification. Limit of quantification (LOQ) was 25 microg mL(-1) for the major isoform Bet v 1a, based on a signal-to-noise ratio of 10, and detector response was linear between LOQ and 0.90 mg mL(-1). Purity of the different rBet v 1a preparations was determined to be between 40 and 92% depending on the manufacturing protocol.

Modification of capillary electrophoresis capillaries by poly(hydroxyethyl methacrylate), poly(diethylene glycol monomethacrylate) and poly(triethylene glycol monomethacrylate)

Modification of capillary electrophoresis (CE) capillaries by poly(hydroxyethyl methacrylate) (poly(HEMA), poly(diethylene glycol monomethacrylate) (poly(DEGMA) and poly(triethylene glycol monomethacrylate) (poly(TEGMA), was studied. Methods based on physical adsorption of the modifier and on its chemical binding were compared on the basis of the electroosmotic flow (EOF) reproducibility, the EOF dependence on the pH, the symmetry of the peak of positively charged tyramine, the stability of the coating and the separation of standard and milk proteins in the modified capillaries. Reproducible coatings were obtained by chemical binding of the polymers to the capillary walls and by coating with a solution of a polymer, as also demonstrated by the atomic force microscopy.

High-performance separations in isolation and characterization of allergens

The present state of the use of separation techniques in the identification and characterization of allergens and in the monitoring of the quality of allergenic preparations is critically surveyed. After a brief summary of the range of problems encountered in obtaining and in the application of allergenic preparations and of the principal physico-chemical properties of allergens, chromatographic and electromigration methods of separation of components of these systems and their combinations with immunochemical procedures are discussed, with selected examples of application to real materials. Emphasis is placed on evaluation of the most important analytical parameters, such as reliability of the results, separation efficiency and resolution, and on the most recent results in the field.

Capillary electrophoresis of cytokinins and cytokinin ribosides

A CE separation of cytokinins and cytokinin ribosides and some other purine and pyrimidine bases has been developed. Two electrolyte systems have been tested: 150 mM phosphoric acid, pH 1.8 and 50 mM sodium dodecylsulphate + 20 mM borate, pH 9.2. The migration times were measured and the effects of the solute structures were discussed. Preliminary experiments with plant extracts have been performed to identify the cytokinins and their ribosides. Both the systems can be used, but 150 mM phosphoric acid is better suited for identification of cytokinins in plant extracts, as the electropherograms are subject to fewer interferences.

Size-exclusion liquid chromatography and capillary electrophoresis of pollen allergens

Allergens from the pollen of Phleum pratense, Dactylis glomerata. Arrhenatherum elatius, Secale cereale, Lolium perrene and Festuca sp. were analysed by size-exclusion chromatography (SEC) and capillary electrophoresis (CE). SEC was used for the determination of the molecular masses of main allergens. A CE method, using either 150 mmol/l phosphoric acid (pH 1.8) or a micellar system consisting of 50 mmol/l sodium dodecyl sulphate-20 mmol/l borate (pH 9.35), was developed as a rapid and efficient alternative to SEC, especially for process control of allergenic preparations. The results obtained by the two methods confirmed similarities in the structures of the studied pollen allergens.