Solid phase extraction of organophosphorus, triazine, and triazole-derived pesticides from water samples. A critical study

Determination of triadimenol based on the quenching effect on resonance light scattering from the triadimenol–deoxyribonucleic acid–hydrochloric acid system

Analysis of triadimenol was carried out using deoxyribonucleic acids (DNA) via the resonance light scattering (RLS) technique. After adding triadimenol into aqueous medium of pH 1.72, the RLS of DNA was remarkably quenched. A resonance light scattering peak at 310 nm was found, and the quenched intensity of RLS at this wavelength was proportional to the concentration of triadimenol. The linear range of the calibration curve was approximately 0-3 microg mL-1 with a detection limit (S/N=3) of 0.07 microg mL-1. The triadimenol in samples of water, cucumber and human serum was determined. The results were satisfactory, and the recovery rates were in the range of 96.3-106.0%, 94.8-105.9% and 92.3-100.5%, respectively. The interaction mechanism was also studied.

Selective enrichment of sulfides, thiols and methylthiophosphates from water samples on metal-loaded cation-exchange materials for gas chromatographic analysis

The suitability of using metal-loaded sorbents for solid-phase extraction to enrich organic sulfur compounds from water samples was studied. To test the retention behavior of a number of sulfides, thiols and methylthiophosphates, a cation-exchanger was loaded with various metal ions. The elution behavior of sulfur compounds was investigated with different solvents. A combination of Pb2+-modified cation-exchanger as sorbent and CS2 (1%, v/v) in toluene proved to be the most suitable approach for the given problem. Using GC with a pulsed flame photometric detector yielded detection limits of between 0.6 and 2.9 microg/l. The results showed good reproducibility with relative standard deviations of 2-11%.

Considerations necessary in gathering occurrence data for selected unstable compounds in the USEPA Unregulated Contaminant Candidate List in USEPA Method 526

U.S. Environmental Protection Agency (EPA) Method 526 was developed for the analysis of target analytes that are subject to degradation by hydrolysis. Two technical hurdles that had to be overcome were preservation of the target analytes and selection of a suitable solid-phase extraction material. The target analytes were diazinon, disulfoton, fonofos, terbufos, prometon, 1,2-diphenylhydrazine, nitrobenzene, acetochlor, 2,4,6-trichlorophenol, 2,4-dichlorophenol, and cyanazine. Diazolidinyl urea was used for the first time as a microbial inhibitor in an EPA drinking water method. Experiment confirmed antimicrobial agents containing copper or mercury salts increased hydrolysis degradation rates. Trisodium ethylenediaminetetraacetic acid salt was added to chelate metal ions that may increase hydrolysis rates. A pH 7 buffer of tris(hydroxymethyl)aminomethane (Tris) and Tris hydrochloride was used to minimize rates of hydrolysis. The use of ascorbic acid prevented degradation of 2,4-dichlorophenol, terbufos, fonofos, diazinon, and disulfoton due to residual chlorine. Samples were extracted using a styrene divinylbenzene solid-phase material and analyzed by capillary column gas chromatography/mass spectrometry. A 21-day storage stability study, together with precision and accuracy studies, showed that this method has suitable sensitivity, accuracy, precision, and ruggedness for use in the EPA's Unregulated Contaminant Monitoring Rule drinking water occurrence survey.

Multiresidue methods using solid-phase extraction techniques for monitoring priority pesticides, including triazines and degradation products, in ground and surface waters

The review describes the use of solid-phase extraction (SPE) techniques for monitoring priority pesticides in ground and surface waters. The focus is on triazine herbicides and their degradation products. Data concerning the fate, occurrence, properties and extraction of triazines and their degradation products using different SPE techniques are tabulated and discussed.

Solid-phase extraction for multiresidue analysis of organic contaminants in water

To overcome the limitations of the detection systems associated with gas or liquid chromatography, a sample pretreatment is required with the objective to provide a sample fraction enriched with all the target analytes and as free as possible from other matrix components. There is now no doubt that solid-phase extraction (SPE) has now become the method of choice for carrying out simultaneously the extraction and concentration of many compounds in aqueous samples. Many recent applications of SPE to multiresidue analysis are reviewed with an emphasis on the importance of the choice of the sorbent and of the sample volume. SPE is particularly well adapted to multiresidue analysis including compounds from a wide range of polarity or characterized by various physico-chemical properties. However, SPE is not completely free from practical problems inherent to the nature of the compounds or to the coupling to the chromatographic systems. Many examples are reported to illustrate these problems which can in most cases be circumvented. New developments in SPE are also reviewed.