Correlation between porosity and dissolution rate constants for disintegrating tablets

Correlation and prediction of moisture-mediated dissolution stability for benazepril hydrochloride tablets

PURPOSE

This report investigated dissolution stability of benazepril hydrochloride tablets.

METHODS

Reduction in dissolution rate was observed for benazepril hydrochloride tablets when they were subjected to stressed storage condition (40 degrees C/75% RH) for prolonged periods of time (1-3 months). Moisture contents of initial and stressed tablets were measured by Karl Fischer method. Comparative thermal and physical characterizations of initial and stressed tablets were also performed. A mathematical model that was used to predict possible reduction in dissolution rate was proposed and validated using experimental data.

RESULTS

It was found that there was a direct correlation between moisture content of benazepril hydrochloride tablets and their percentage of dissolution at 10 min. At moisture content below 3.5%, there were no significant changes in dissolution values. Beyond that point, however, a close to linear decrease in dissolution was observed as a function of increase in moisture content. Results from thermal and X-ray analysis have ruled out possible changes in drug substance. Other physical characterization, such as scanning electron microscope and mercury porosimetry measurements, revealed changes in core structure of stressed tablets vs. initial tablets. Based on results from these measurements, "preactivation" of disintegrant was identified as the mechanism for reduction in dissolution rate above critical moisture content. A simple physical model for moisture uptake of benazepril hydrochloride tablets was also proposed for predicting when, based on water vapor transmission and critical moisture content, dissolution rate will decline.

CONCLUSIONS

Physical changes of tablets mediated by moisture were the main cause for reduction in dissolution. Inclusion of desiccant, although beneficial, cannot prevent reduction in dissolution completely. The simple physical model proposed in this report was found to be useful in predicting the dissolution stability of the dosage form.

Wetting properties of bile salt solutions and dissolution media

The objective of this study was to determine the extent to which specific bile salt solutions and compendial dissolution media differ in their ability to wet a model surface. Solutions were examined in the concentration range of bile salts found in the gastrointestinal tract and at pH values approximating those of the stomach and small intestine. Wetting was evaluated from measurement of the surface tension of the solutions and contact angles of sessile drops on poly(methyl methacrylate). Compendial dissolution media had higher surface tensions and contact angles than bile salt solutions at 10 mM. Individual bile salts at 10 mM varied in surface tension lowering and contact angles. The contact angle-concentration profiles achieved plateau values at 2.5 mM. Dewetting was observed at low bile salt concentrations at pH 7.5. Calculated adhesion tension and interfacial tension were consistent with this behavior. The effect was attributed to the influence of the substrate surface charge on the orientation of the adsorbed bile salt molecule. Adhesion tension profiles showed that from low (<0.5 mM) to moderate (2 mM) concentrations preferential bile salt adsorption to the liquid-vapor interface occurred, but at higher values (>2 mM) the preference shifted toward the solid-liquid interface. These results have implications in the design of physiologically based dissolution media.

Dissolution of a soluble drug substance from vinyl polymer matrices

It was shown that vinyl polymers form good bases for in vitro sustained-release matrices, and that the character of the release curves is basically in line with their pH-solubility profiles. For a flow cell, the release curves may be approximated by the equation: In (m/m0) = - K(t -ti), where m is the amount not dissolved, m0 is the initial drug content, K is a dissolution constant, t is time, and ti is a lag time. Furthermore, it was shown that K is a function of tablet hardness (H) and polymer content (Q, percent). This functionality is well represented by the equation: In K = alpha H + gamma ln Q + epsilon, where alpha, gamma, and epsilon are polymer-dependent parameters. Matrix erosion is represented by an exponential decay: (p/p0) = exp(-Dt + a), where p is the amount not eroded, p0 is the initial weight, D is an erosion constant, and a is a soluble polymer-dependent parameter. In the case of these soluble polymers, K is not solely a function of D.