Surfactin fromBacillus velezensisH2O‐1: Production and Physicochemical Characterization for Postsalt Applications

Enhanced low-cost lipopeptide biosurfactant production by Bacillus velezensis from residual glycerin

Biosurfactants (BSFs) are molecules produced by microorganisms from various carbon sources, with applications in bioremediation and petroleum recovery. However, the production cost limits large-scale applications. This study optimized BSFs production by Bacillus velezensis (strain MO13) using residual glycerin as a substrate. The spherical quadratic central composite design (CCD) model was used to standardize carbon source concentration (30 g/L), temperature (34 °C), pH (7.2), stirring (239 rpm), and aeration (0.775 vvm) in a 5-L bioreactor. Maximum BSFs production reached 1527.6 mg/L of surfactins and 176.88 mg/L of iturins, a threefold increase through optimization. Microbial development, substrate consumption, concentration of BSFs, and surface tension were also evaluated on the bioprocess dynamics. Mass spectrometry Q-TOF-MS identified five surfactin and two iturin isoforms produced by B. velezensis MO13. This study demonstrates significant progress on BSF production using industrial waste as a microbial substrate, surpassing reported concentrations in the literature.

Homoscleromorpha-derived Bacillus spp. as potential sources of biotechnologically-relevant hydrolases and biosurfactants

Despite hydrolytic exoenzymes and biosurfactants having been gradually reported from the poriferan microbiome, little is known about these bioproducts in microorganisms inhabiting Homoscleromorpha sponges. Here, we investigated the production of hydrolases and biosurfactants in bacteria isolated from three shallow-water homoscleromorph species, Oscarella sp., Plakina cyanorosea, and Plakina cabofriense. A total of 99 of 107 sponge-associated bacterial isolates exhibited activity for at least one of the analyzed hydrolases. Following fermentation in Luria-Bertani (LB) and Tryptic Soy Broth (TSB), two isolates, 80BH11 and 80B1:1010b, showed higher lipase and peptidase activities. Both of them belonged to the Bacillus genus and were isolated from Oscarella. Central composite design leveraged up the peptidase activity in 280% by Bacillus sp. 80BH11 in the TSB medium for 48 h at 30 °C. The optimized model also revealed that pH 6.5 and 45 °C were the best conditions for peptidase reaction. In addition, Bacillus sp. 80BH11 was able to release highly emulsifying and remarkably stable surfactants in the LB medium. Surfactin was finally elucidated as the biosurfactant generated by this sponge-derived Bacillus. In conclusion, we hope to have set the scenery for further prospecting of industrial enzymes and biosurfactants in Homoscleromorpha microbiomes.

Bacillus velezensis H2O-1 surfactin efficiently maintains its interfacial properties in extreme conditions found in post-salt and pre-salt oil reservoirs

Biosurfactants are molecules with surfactant properties produced by microorganisms, and can be used in various industrial sectors, e.g., the oil industry. These molecules can be used in enhanced oil recovery (EOR) in the pre-salt and post-salt reservoirs, where conditions of temperature, pressure, and salinity are quite varied, requiring a study of the stability of these molecules under these conditions. Bacillus velezensis H2O-1 produces five different surfactin homologs with a fatty-acid chain ranging from C11 to C16 and with a high capacity to reduce surface (24.8 mN.m^-1) and interfacial tensions (1.5 and 0.8 8 mN.m^-1 using light, medium oil and n-hexadecane, respectively). The critical micellar concentration (CMC) was 38.7 mg.L^-1. Inversion wettability tests were carried out under the salinity conditions found in the post-salt (35 g.L^-1) and pre-salt (70 g.L^-1) reservoirs, in which it was observed that the surfactin reversed 100 % of the wettability of the calcite impregnated with light and medium oil. Using a central composite rotatable design, we demonstrated that surfactin maintained its interfacial properties when subjected simultaneously to extreme conditions of pressure, temperature and salinity commonly found in the post-salt (70 °C, 70 g.L^-1 and 27.58 MPa) and pre-salt (100 °C, 150 g.L^-1 and 48.2 MPa) layers. The results presented here highlight the efficiency and stability of H2O-1 surfactin in environmental conditions found in pre-salt and post-salt oil reservoirs.

Effect of Fluid-Rock Interactions on In Situ Bacterial Alteration of Interfacial Properties and Wettability of CO2-Brine-Mineral Systems for Geologic Carbon Storage

This study explored the feasibility of biosurfactant amendment in modifying the interfacial characteristics of carbon dioxide (CO₂) with rock minerals under high-pressure conditions for GCS. In particular, while varying the CO₂ phase and the rock mineral, we quantitatively examined the production of biosurfactants by Bacillus subtilis and their effects on interfacial tension (IFT) and wettability in CO₂-brine-mineral systems. The results demonstrated that surfactin produced by B. subtilis caused the reduction of CO₂-brine IFT and modified the wettability of both quartz and calcite minerals to be more CO₂-wet. The production yield of surfactin was substantially greater with the calcite mineral than with the quartz mineral. The calcite played the role of a pH buffer, consistently maintaining the brine pH above 6. By contrast, an acidic condition in CO₂-brine-quartz systems caused the precipitation of surfactin, and hence surfactin lost its ability as a surface-active agent. Meanwhile, the CO₂-driven mineral dissolution and precipitation in CO₂-brine-calcite systems under a non-equilibrium system altered the solid substrates, produced surface roughness, and caused contact angle variations. These results provide unique experimental data on biosurfactant-mediated interfacial properties and wettability in GCS-relevant conditions, which support the exploitation of in situ biosurfactant production for biosurfactant-aided CO₂ injection.

Chemical and biological dispersants differently affect the bacterial communities of uncontaminated and oil-contaminated marine water

The use of dispersants in marine environments is a common practice worldwide for oil spill remediation. While the effects of chemical dispersants have been extensively studied, those of biosurfactants, mainly surfactin that is considered one of the most effective surfactants produced by bacteria, have been less considered. We constructed microcosms containing marine water collected from Grumari beach (W_GB, Brazil) and from Schiermonnikoog beach (W_SI, The Netherlands) with the addition of oil (WO), Ultrasperse II plus oil (WOS), surfactin plus oil (WOB), and both dispersants (WS or WB) individually. In these treatments, the composition of bacterial communities and their predictive biodegradation potential were determined over time. High-throughput sequencing of the rrs gene encoding bacterial 16S rRNA revealed that Bacteroidetes (Flavobacteria class) and Proteobacteria (mainly Gammaproteobacteria and Alphaproteobacteria classes) were the most abundant phyla found among the W_GB and W_SI microbiomes, and the relative abundance of the bacterial types in the different microcosms varied based on the treatment applied. Non-metrical multidimensional scaling (NMDS) revealed a clear clustering based on the addition of oil and on the dispersant type added to the GB or SI microcosms, i.e., WB and WOB were separated from WS and WOS in both marine ecosystems studied. The potential presence of diverse enzymes involved in oil degradation was indicated by predictive bacterial metagenome reconstruction. The abundance of predicted genes for degradation of petroleum hydrocarbons increased more in surfactin-treated microcosms than those treated with Ultrasperse II, mainly in the marine water samples from Grumari beach.