Separation and determination of five major opium alkaloids with mixed mode of hydrophilic/cation-exchange monolith by pressurized capillary electrochromatography

An integrated microfluidic device for solid-phase extraction and spectrophotometric detection of opium alkaloids in urine samples

A novel lab-on-chip integrated microfluidic device for solid-phase extraction (SPE) and spectrophotometric detection of morphine (MOR), codeine (COD), and papaverine (PAP) was developed. The extracted analytes were analyzed with a miniature UV-Vis spectrophotometer. The SPE adsorptive phase composed of polyurethane/polyaniline (PU/PANI) nanofibers was fabricated by electrospinning and in situ oxidative polymerization techniques. The sorbent was characterized by Fourier transform infrared (FTIR) spectroscopy and scanning electron microscopy (SEM). The main factors of extraction such as desorption conditions, pH, salt effect, and extraction time were investigated. The partial least square (PLS) regression was applied to improve the quantification of analytes. The linear dynamic ranges (LDRs) for MOR, COD, and PAP were 4-240, 4-210, and 1-150 ng mL^-1, respectively. Finally, the proposed method was successfully applied for the determination of MOR, COD, and PAP in human urine samples and the extraction recoveries were obtained in the range of 66.7-85.0% with RSDs < 8.3%.

Multi-component profiles through the blood-brain barrier in rat after oral administration of over-the-counter drug Keke capsule by ultra-performance liquid chromatography/quadrupole- time-of-flight MSE method

Keke capsule as a traditional Chinese medicine formulation is used to relieve cough, for analgesia and to reduce bronchial asthma. The multi-components are absorbed into the blood and brain after oral administration of Keke capsule, with no systematic investigation so far. A reliable and rapid UPLC-QTOF-MS^E combined with a data processing software platform was used to characterize the components of Keke capsule and simultaneously identify bioactive components in blood and brain tissues in rat after oral administration. Consequently, a total of 41 components of Keke capsule, including alkaloids, flavone, flavonols, triterpene, lignanoid, organic acids, glycosides and coumarin were identified. Twenty-one components were found in plasma, including 18 prototypes and three metabolites; 15 components were found in brain tissues, including 10 prototypes and five metabolites. Alkaloids and flavonoids in Keke capsule were the main components which were absorbed into blood. The main alkaloids of Keke capsule can pass through the blood-brain barrier and show different distribution tendencies in brain tissues. The main components of keke capsule was simultaneously analyzed by throughput analysis, and the corresponding bioactive components were examined by blood-brain barrier in the rat after oral administration of the capsule.

Organic monoliths for hydrophilic interaction electrochromatography/chromatography and immunoaffinity chromatography

This article is aimed at providing a review of the progress made over the past decade in the preparation of polar monoliths for hydrophilic interaction LC (HILIC)/capillary electrochromatography (HI-CEC) and in the design of immuno-monoliths for immunoaffinity chromatography that are based on some of the polar monolith precursors used in HILIC/HI-CEC. In addition, this review article discusses some of the applications of polar monoliths by HILIC and HI-CEC, and the applications of immuno-monoliths. This article is by no means an exhaustive review of the literature; it is rather a survey of the recent progress made in the field with 83 references published in the past decade on the topics of HILIC and immunoaffinity chromatography monoliths.

Optimized ultrasound-assisted extraction procedure for the analysis of opium alkaloids in papaver plants by cyclodextrin-modified capillary electrophoresis

This study investigated the use of ultrasound-assisted extraction to improve the extraction efficiency of morphine, codeine and thebaine from the papaver plants. Extraction conditions such as type of solvent, temperature, duration, frequency and power level of ultrasonic were optimized and the influences of different parameters on resolution of alkaloids in CE were studied. The optimized condition for CE separation includes a sodium phosphate buffer (100 mM, pH 3.0) containing 5 mM alpha-CD. The optimized extraction conditions for ultrasound-assisted extraction was an extraction time of 1 h, an ultrasonic frequency of 60 kHz with water-methanol (80:20) at 40 degrees C as the extraction solvent. The LOD for alkaloids was found to be 0.1 microg/mL at a signal-to-noise ratio of 3:1. The RSDs for peak areas were in the range of 1.4-4.4%. The amounts of opium alkaloids (mg/100 g dried sample) in four Iranian papaver plants were found to be in the range of 7.8-8.7 (morphine), 5.5-9.5 (codeine) and 1.4-10.4 (thebaine). It should be emphasized that no cleanup of the filtered extract was required; hence, direct determination after extraction drastically simplifies the analytical process.

CEC-ESI ion trap MS of multiple drugs of abuse

This article describes a method for the separation and determination of nine drugs of abuse in human urine, including amphetamines, cocaine, codeine, heroin and morphine. This method was based on SPE on a strong cation exchange cartridge followed by CEC-MS. The CEC experiments were performed in fused silica capillaries (100 microm x 30 cm) packed with a 3 mum cyano derivatized silica stationary phase. A laboratory-made liquid junction interface was used for CEC-MS coupling. The outlet capillary column was connected with an emitter tip that was positioned in front of the MS orifice. A stable electrospray was produced at nanoliter per minute flow rates applying a hydrostatic pressure (few kPa) to the interface. The coupling of packed CEC columns with mass spectrometer as detector, using a liquid junction interface, provided several advantages such as better sensitivity, low dead volume and independent control of the conditions used for CEC separation and ESI analysis. For this purpose, preliminary experiments were carried out in CEC-UV to optimize the proper mobile phase for CEC analysis. Good separation efficiency was achieved for almost all compounds, using a mixture containing ACN and 25 mM ammonium formate buffer at pH 3 (30:70, v/v), as mobile phase and applying a voltage of 12 kV. ESI ion-trap MS detection was performed in the positive ionization mode. A spray liquid, composed by methanol-water (80:20, v/v) and 1% formic acid, was delivered at a nano-flow rate of approximately 200 nL/min. Under optimized CEC-ESI-MS conditions, separation of the investigated drugs was performed within 13 min. CEC-MS and CEC-MS(2) spectra were obtained by providing the unambiguous confirmation of these drugs in urine samples. Method precision was determined with RSDs values <or=3.3% for retention times and <or=16.3% for peak areas in both intra-day and day-to-day experiments. LODs were established between 0.78 and 3.12 ng/mL for all compounds. Linearity was satisfactory in the concentration range of interest for all compounds (r(2)>or=0.995). The developed CEC-MS method was then applied to the analysis of drugs of abuse in spiked urine samples, obtaining recovery data in the range 80-95%.

CEC of phytochemical bioactive compounds

Although there are many publications related to technological or methodological developments of CEC, few focus on the analysis of natural products, especially phytochemical bioactive compounds. This review summarized the application of CEC in the analysis of phytochemical bioactive components, including flavonoids, nucleosides, steroids, lignans, quinones and coumarins, as well as fingerprint analysis of herbs. The strategies for optimization of CEC conditions and detection were also discussed.

CEC: selected developments that caught my eye since the year 2000

During the last decade, a number of new developments have emerged in the field of CEC. This paper focuses only on monolithic columns prepared from synthetic polymers. Monolithic columns have become a well-established format of stationary phases for CEC immediately after their inception in the mid-1990s. They are readily prepared in situ from liquid precursors. Also, the control over both porous properties and surface chemistries is easy to achieve. These advantages make the monolithic separation media an attractive alternative to capillary columns packed with particulate materials. Since the number of papers concerned with just this single topic of polymer-based monolithic CEC columns is large, this overview describes only those approaches this author found interesting.