Kinetics and mechanism of the reaction of Cl atoms with HO2 radicals

Effects of water, ammonia and formic acid on HO2 + Cl reactions under atmospheric conditions: competition between a stepwise route and one elementary step

Quantum chemical calculations at M06-2X and CCSD(T) levels of theory have been performed to investigate the effects of H2O, NH3, and HCOOH on the HO2 + Cl → HCl + O2 reaction. The results show that catalyzed reactions with three catalysts could proceed through two different mechanisms, namely a stepwise route and one elementary step, where the former reaction is more favorable than the latter. Meanwhile, for the stepwise route, a single hydrogen atom transfer pathway in the presence of all catalysts has more advantages than the respective double hydrogen atom transfer pathway. Then, the relative impacts of catalysts under tropospheric conditions were investigated by considering the temperature dependence of the rate constants and the altitude dependence of catalyst concentrations. The calculated results show that at 0 km altitude, the HO2 + Cl → HCl + O2 reaction with catalysts, such as H2O, NH3, or HCOOH, cannot compete with the reaction without a catalyst, as the effective rate constant with a catalyst is smaller by 2-6 orders of magnitude than the naked reaction within the temperature range 280-320 K. The calculated results also show that at altitudes of 5, 10 and 15 km, the effective rate constant of the HCOOH-catalyzed reaction increases obviously with an increase in altitude. At 15 km altitude, its value is up to 9.63 × 10-11 cm3 per molecule per s, which is close to the corresponding value of the reaction without a catalyst, showing that the contribution of HCOOH to the HO2 + Cl → HCl + O2 reaction cannot be neglected at high altitudes. The new findings in this investigation are not only of great necessity and importance for elucidating the gas-phase reaction of HO2 with Cl in the presence of acidic, neutral and basic catalysts, but are also of great interest for understanding the importance of other types of hydrogen abstraction in the atmosphere.

A Kinetic and Product Study of the Cl + HO2 Reaction

Absolute rate data and product branching ratios for the reactions Cl + HO2 --> HCl + O2 (k1a) and Cl + HO2 --> OH + ClO (k1b) have been measured from 226 to 336 K at a total pressure of 1 Torr of helium using the discharge flow resonance fluorescence technique coupled with infrared diode laser spectroscopy. For kinetic measurements, pseudo-first-order conditions were used with both reagents in excess in separate experiments. HO2 was produced by two methods: through the termolecular reaction of H atoms with O2 and also by the reaction of F atoms with H2O2. Cl atoms were produced by a microwave discharge of Cl2 in He. HO2 radicals were converted to OH radicals prior to detection by resonance fluorescence at 308 nm. Cl atoms were detected directly at 138 nm also by resonance fluorescence. Measurement of the consumption of HO2 in excess Cl yielded k1a and measurement of the consumption of Cl in excess HO2 yielded the total rate coefficient, k1. Values of k1a and k1 derived from kinetic experiments expressed in Arrhenius form are (1.6 +/- 0.2) x 10(-11) exp[(249 +/- 34)/T] and (2.8 +/- 0.1) x 10(-11) exp[(123 +/- 15)/T] cm3 molecule(-1) s(-1), respectively. As the expression for k1 is only weakly temperature dependent, we report a temperature-independent value of k1 = (4.5 +/- 0.4) x 10(-11) cm3 molecule(-1) s(-1). Additionally, an Arrhenius expression for k1b can also be derived: k1b = (7.7 +/- 0.8) x 10(-11) exp[-(708 +/- 29)/T] cm3 molecule(-1) s(-1). These expressions for k1a and k1b are valid for 226 K < or = T < or = 336 and 256 K < or = T < or = 296 K, respectively. The cited errors are at the level of a single standard deviation. For the product measurements, an excess of Cl was added to known concentrations of HO2 and the reaction was allowed to reach completion. HCl product concentrations were determined by IR absorption yielding the ratio k1a/k1 over the temperature range 236 K < or = T < or = 296 K. OH product concentrations were determined by resonance fluorescence giving rise to the ratio k1b/k1 over the temperature range 226 K < or = T < or = 336 K. Both of these ratios were subsequently converted to absolute numbers. Values of k1a and k1b from the product experiments expressed in Arrhenius form are (1.5 +/- 0.1) x 10(-11) exp[(222 +/- 17)/T] and (10.6 +/- 1.5) x 10(-11) exp[-(733 +/- 41)/T] cm3 molecule(-1) s(-1), respectively. These expressions for k1a and k1b are valid for 256 K < or = T < or = 296 and 226 K < or = T < or = 336 K, respectively. A combination of the kinetic and product data results in the following Arrhenius expressions for k1a and k1b of (1.4 +/- 0.3) x 10(-11) exp[(269 +/- 58)/T] and (12.7 +/- 4.1) x 10(-11) exp[-(801 +/- 94)/T] cm3 molecule(-1) s(-1), respectively. Numerical simulations were used to check for interferences from secondary chemistry in both the kinetic and product experiments and also to quantify the losses incurred during the conversion process HO2 --> OH for detection purposes.