Nanoscale control of non-reciprocal ripple writing

Femtosecond laser-induced deep-subwavelength structures have attracted much attention as a nanoscale surface texturization technique. A better understanding of the formation conditions and period control is required. Herein, we report a method of non-reciprocal writing via a tailored optical far-field exposure, where the period of ripples varies along different scanning directions, and achieve a continuous manipulation of the period from 47 to 112 nm (±4 nm) for a 100-nm-thick indium tin oxide (ITO) on glass. A full electromagnetic model was developed to demonstrate the redistributed localized near-field at different stages of ablation with nanoscale precision. It explains the formation of ripples and the asymmetry of the focal spot determines the non-reciprocity of ripple writing. Combined with beam shaping techniques, we achieved non-reciprocal writing (regarding scanning direction) using an aperture-shaped beam. The non-reciprocal writing is expected to open new paths for precise and controllable nanoscale surface texturing.

Nanostructured Polystyrene Doped with Acetylsalicylic Acid and Its Antibacterial Properties

Homogeneous polystyrene foils doped with different concentrations of acetylsalicylic acid were prepared by the solvent casting method. The surface morphology and surface chemistry of as-prepared foils were characterized in detail. Excimer laser (krypton fluoride, a wavelength of 248 nm) was used for surface nanopatterning of doped polystyrene foils. Certain combinations of laser fluence and number of laser pulses led to formation of laser-induced periodic surface structures (LIPSS) on the exposed surface. Formation of the pattern was affected by the presence of a dopant in the polystyrene structure. Significant differences in surface chemistry and morphology of laser-treated foils compared to both pristine and doped polystyrene were detected. The pattern width and height were both affected by selection of input excimer exposure conditions, and the amount of 6000 pulses was determined as optimal. The possibility of nanostructuring of a honeycomb-like pattern doped with acetylsalicylic acid was also demonstrated. Selected nanostructured surfaces were used for study the antibacterial properties for a model bacteria strain of S. aureus. The combination of altered surface chemistry and morphology of polystyrene was confirmed to have an excellent antibacterial properties.

Cell-instructive high-resolution micropatterned polylactic acid surfaces

Micro and nanoscale topographical structuring of biomaterial surfaces has been a valuable tool for influencing cell behavior, including cell attachment, proliferation and differentiation. However, most fabrication techniques for surface patterning of implantable biomaterials suffer from a limited resolution, not allowing controlled generation of sub-cellular three-dimensional features. Here, a direct laser lithography technique based on two-photon absorption was used to construct several patterns varying in size between 500 nm and 15 μm. Through replication via an intermediate mold, the patterns were transferred into polylactic acid (PLA), a widely used biomedical polymer, while retaining the original geometry. An osteoblast-like cell line, MG-63 was used for characterizing the morphological response to the topographical patterns. The results indicated that semi-continuous (dashed) lines, with a height of 1 μm were able to induce cell elongation in the direction of the lines. However, when dashes with a height of 0.5 μm were combined with perpendicularly crossing continuous lines (rails) with a height of 8 μm, the contact guidance effect of the dashes was lost and elongation of the cells was observed in the direction of the larger features. A second pattern, consisting of different arrays of pillars showed that, depending on the pillar height, the cells were either able to spread over the pattern or were confined between the pattern features. These differences in the ability of cells to spread further resulted in the formation of tension forces through stress fibers and displacement of vimentin. The method for high-resolution micropatterning of PLA as presented here can also be applied to other biomedical polymers, making it useful both for fundamental studies and for designing new biomaterials with improved functionality.