Confinement Effects on the Optical Properties and Chain Conformations of Poly(9,9-di-n -octylfluorene-alt -benzothiadiazole) Nanotubes

Molecular Regulation of Polymeric Raman Probes for Ultrasensitive Microtumor Diagnosis and Noninvasive Microvessle Imaging

Raman imaging is a powerful tool for the diagnosis of cancers and visualization of various biological processes. Polymers possessing excellent biocompatibility are promising probes for Raman imaging. However, few polymers are reported to serve as Raman probes for in vivo imaging, mainly due to the intrinsic weak Raman signal intensity and fluorescence interference of these polymers. Herein, a poly(indacenodithiophene-benzothiadiazole) (IDT-BT) polymer is presented, which emits unprecedentedly strong Raman signals under the near-infrared wavelength (785 nm) excitation, thus functioning as a Raman probe for ultrasensitive in vivo Raman imaging. Further mechanistic studies unveil that the unique Raman feature of the IDT-BT polymer relies on molecularly regulating its absorbance edge adjacent to the desired excitation wavelength, thus avoiding fluorescence interference and simultaneously emitting strong Raman scattering under preresonant excitation. Taking advantage of this discipline, the IDT-BT polymeric probe successfully realizes intraoperative Raman imaging of micrometastasis as small as 0.3 mm × 0.3 mm, comparable to the most sensitive Raman probes currently reported. Impressively, the IDT-BT enables noninvasive microvascular imaging, which is not achieved using other Raman probes. This work opens a new avenue toward the development of polymeric Raman probes for in vivo Raman imaging.

Brush Printing Creates Polarized Green Fluorescence: 3D Orientation Mapping and Stochastic Analysis of Conductive Polymer Films

Brush printing is a unique method used to obtain uniaxially oriented films, whereby a polymer solution is brushed onto a substrate. However, there have been only a few reports on the brush-printing method. Here, we report the preparation of a uniaxially oriented film of a green light-emitting conductive polymer, poly(9,9-dioctylfluorene-alt-benzothiadiazole) (F8BT). The fluorescence polarization ratio of the oriented F8BT films was as high as 11.3, and the average orientation factor reached 0.74 ± 0.06. The orientation factor and the torsion angle of F8BT were visualized by two mappings of fluorescence and Raman spectral measurements by confocal spectromicroscopy, respectively. These two x-y mapping data with many pixels (∼750 pixels) were evaluated by x-y-z mapping of the film thickness at a single position and were used to reveal the three-dimensional (3D) orientation mechanism from a stochastic approach. Polarized green fluorescence originates from polymer chains uniaxially oriented along the brush direction. The high orientation for a film thickness < 100 nm is established by shear stress, faster capillary flow, and flow-induced chain extension for a thin solution film on a substrate. The high orientation factor was also demonstrated by a high brushing speed, whereas an optimized brushing speed existed. We found that this optimization is attributed to the property of a non-Newtonian fluid. By applying this brush-printing method to the fabrication of an optoelectrical device, polarized green electroluminescence was preliminarily demonstrated by the OLED assembled from an oriented F8BT film.