Low-field 1 H NMR spectroscopy: Factors impacting signal-to-noise ratio and experimental time in the context of mixed microstructure polyisoprenes

Correction of field instabilities in biomolecular solid-state NMR by simultaneous acquisition of a frequency reference

With the advent of faster magic-angle spinning (MAS) and higher magnetic fields, the resolution of biomolecular solid-state nuclear magnetic resonance (NMR) spectra has been continuously increasing. As a direct consequence, the always narrower spectral lines, especially in proton-detected spectroscopy, are also becoming more sensitive to temporal instabilities of the magnetic field in the sample volume. Field drifts in the order of tenths of parts per million occur after probe insertion or temperature change, during cryogen refill, or are intrinsic to the superconducting high-field magnets, particularly in the months after charging. As an alternative to a field-frequency lock based on deuterium solvent resonance rarely available for solid-state NMR, we present a strategy to compensate non-linear field drifts using simultaneous acquisition of a frequency reference (SAFR). It is based on the acquisition of an auxiliary 1D spectrum in each scan of the experiment. Typically, a small-flip-angle pulse is added at the beginning of the pulse sequence. Based on the frequency of the maximum of the solvent signal, the field evolution in time is reconstructed and used to correct the raw data after acquisition, thereby acting in its principle as a digital lock system. The general applicability of our approach is demonstrated on 2D and 3D protein spectra during various situations with a non-linear field drift. SAFR with small-flip-angle pulses causes no significant loss in sensitivity or increase in experimental time in protein spectroscopy. The correction leads to the possibility of recording high-quality spectra in a typical biomolecular experiment even during non-linear field changes in the order of 0.1 ppm h- 1 without the need for hardware solutions, such as stabilizing the temperature of the magnet bore. The improvement of linewidths and peak shapes turns out to be especially important for 1 H-detected spectra under fast MAS, but the method is suitable for the detection of carbon or other nuclei as well.

Applicable and cost-efficient microplastic analysis by quantitative 1 H-NMR spectroscopy using benchtop NMR and NoD methods

In continuation of our work on the proof-of-concept that quantitative NMR spectroscopy may be a valuable tool in microplastic (MP) analysis and quantification, we present here investigations using low-field NMR spectrometers and nondeuterated solvents for the analysis of solutions of MP particles in suitable solvents. The use of low-field NMR spectrometers (benchtop NMR) that are considerably more cost-effective in terms of purchase and operating costs compared with high-field NMR spectrometers and the use of nondeuterated solvents (NoD method) leads to an applicable and cost-efficient method for mass-based MP analysis. For benchtop 80-MHz NMR, limits of detection for polyvinylchloride (PVC), polyethylene terephthalate (PET), and polystyrene (PS) are in the same range as if a high-field 500-MHz NMR spectrometer was used for quantification (500 MHz: PET 1 μg/ml, PVC 42 μg/ml, and PS 9 μg/ml; 80 MHz: PET 4 μg/ml, PVC 19 μg/ml, and PS 21 μg/ml) for polymers being dissolved in deuterated solvents. The same is true for the corresponding limits of quantification. Moreover, it is shown for the first time that quantitative determination of the mass concentration of PET, PVC, and PS is also possible using NoD methods by evaluating the integrals of polymer-specific signals relative to an internal or external standard. Detection limits for NoD methods are in a similar range as if deuterated solvents were used (PET 2 μg/ml, PVC 39 μg/ml, and PS 8 μg/ml) using a high-field 500-MHz spectrometer or the 80-MHz spectrometer (PET 5 μg/ml).

Recent Applications of Benchtop Nuclear Magnetic Resonance Spectroscopy

Benchtop nuclear magnetic resonance (NMR) spectroscopy uses small permanent magnets to generate magnetic fields and therefore offers the advantages of operational simplicity and reasonable cost, presenting a viable alternative to high-field NMR spectroscopy. In particular, the use of benchtop NMR spectroscopy for rapid in-field analysis, e.g., for quality control or forensic science purposes, has attracted considerable attention. As benchtop NMR spectrometers are sufficiently compact to be operated in a fume hood, they can be efficiently used for real-time reaction and process monitoring. This review introduces the recent applications of benchtop NMR spectroscopy in diverse fields, including food science, pharmaceuticals, process and reaction monitoring, metabolomics, and polymer materials.

Selected Instrumental Techniques Applied in Food and Feed: Quality, Safety and Adulteration Analysis

This review presents an overall glance at selected instrumental analytical techniques and methods used in food analysis, focusing on their primary food science research applications. The methods described represent approaches that have already been developed or are currently being implemented in our laboratories. Some techniques are widespread and well known and hence we will focus only in very specific examples, whilst the relatively less common techniques applied in food science are covered in a wider fashion. We made a particular emphasis on the works published on this topic in the last five years. When appropriate, we referred the reader to specialized reports highlighting each technique's principle and focused on said technologies' applications in the food analysis field. Each example forwarded will consider the advantages and limitations of the application. Certain study cases will typify that several of the techniques mentioned are used simultaneously to resolve an issue, support novel data, or gather further information from the food sample.