Dielectric waveguides for ultrahigh field magnetic resonance imaging

Novel materials in magnetic resonance imaging: high permittivity ceramics, metamaterials, metasurfaces and artificial dielectrics

This article reviews recent developments in designing and testing new types of materials which can be: (i) placed around the body for in vivo imaging, (ii) be integrated into a conventional RF coil, or (iii) form the resonator itself. These materials can improve the quality of MRI scans for both in vivo and magnetic resonance microscopy applications. The methodological section covers the basic operation and design of two different types of materials, namely high permittivity materials constructed from ceramics and artificial dielectrics/metasurfaces formed by coupled conductive subunits, either in air or surrounded by dielectric material. Applications of high permittivity materials and metasurfaces placed next to the body to neuroimaging and extremity imaging at 7 T, body and neuroimaging at 3 T, and extremity imaging at 1.5 T are shown. Results using ceramic resonators for both high field in vivo imaging and magnetic resonance microscopy are also shown. The development of new materials to improve MR image quality remains an active area of research, but has not yet found significant use in clinical applications. This is mainly due to practical issues such as specific absorption rate modelling, accurate and reproducible placement, and acceptable size/weight of such materials. The most successful area has been simple “dielectric pads” for neuroimaging at 7 T which were initially developed somewhat as a stop-gap while parallel transmit technology was being developed, but have continued to be used at many sites. Some of these issues can potentially be overcome using much lighter metasurfaces and artificial dielectrics, which are just beginning to be assessed.

Remote RF excitation for small-bore MR imager at 15.2 T

We report a method for remote excitation of the RF signal for preclinical-equivalent ultra high field Magnetic Resonance Imaging (MRI). A parallel-plate waveguide together with a bio-inspired surface coil were used to perform remote excitation experiments to acquire images with a small-bore MR imager at 15.2 T. The imager bore size limits the RF coil transmitter dimensions, so the Gielis super-formula was used to design an RF coil with small dimensions. Electromagnetic simulations of the principal mode were run to study the waveguide filled with air and loaded with a saline solution-filled tube. Radiation patterns were also computed in a semi-anechoic chamber for the same scenarios as above. A saline solution-filled spherical phantom and a formaldehyde-fixed mouse phantom were used to acquire images. Radiation patterns showed an omnidirectional distribution with no side lobes, and a very smooth behaviour with almost no loss of information in the saline solution-filled tube and without. The theoretical wave impedance was calculated and compared with simulated results showing an excellent correspondence. Spherical phantom image data and simulation results of B₁ were contrasted and showed an important correlation. Ex vivo mouse images were of high quality and exhibited clear delineation of anatomical structures. These imaging results are in very good agreement with the simulations. Numerical, theoretical and experimental results validate this approach, using a bio-inspired surface coil with a simple waveguide for preclinical small-bore MRI at ultra high field.

Clinical value of (dedicated) 3 Tesla and 7 Tesla MRI for cT1 glottic carcinoma: A feasibility study

OBJECTIVE

To assess the feasibility of the clinical use of 3 Tesla and 7 Tesla Magnetic Resonance Imaging for early (cT1) glottic carcinoma, including structural assessment of technical image quality and visibility of the tumor; and if feasible, to correlate MRI findings to routine diagnostics.

METHODS

Prospective feasibility study. Twenty patients with primary clinical T1 glottic carcinoma underwent both routine clinical staging and CT. In addition, a 3 T and 7 T MRI protocol, developed for small laryngeal lesions, was performed in a 4-point immobilization mask, using dedicated surface coils. Afterwards, routine endoscopic direct suspension laryngoscopy under general anaesthesia was performed.

RESULTS

Only 2 of 7 (29%) of 7 T MRI scans were rated as moderate to good technical image quality. After exclusion of three patients with only mild to moderate dysplasia at the time of MRI, 13 of 17 (76%) of 3 T MRIs were of adequate technical image quality. Tumor visualization was adequate in 8 of 13 (62%) of patients with invasive squamous cell carcinomas. With exclusion of the four MRIs with motion artefacts, the tumor and its boundaries could be adequately seen in 8 of 9 (89%) patients with squamous cell carcinoma versus only one in four (25%) of patients with carcinoma in situ lesions.

CONCLUSIONS

7 Tesla MRI was considered not feasible. 3 Tesla MRI, with adequate patient selection, namely clinical exclusion of patients with a history of claustrophobia and inclusion of only histologically proven invasive squamous cell carcinoma, can be feasible. Especially with further improvement of MR image quality.

LEVEL OF EVIDENCE

2B, prospective diagnostic study.

Design of a forward view antenna for prostate imaging at 7 T

PURPOSE

To design a forward view antenna for prostate imaging at 7 T, which is placed between the legs of the subject in addition to a dipole array.

MATERIALS AND METHODS

The forward view antenna is realized by placing a cross-dipole antenna at the end of a small rectangular waveguide. Quadrature drive of the cross-dipole can excite a circularly polarized wave propagating along the axial direction to and from the prostate region. Functioning of the forward view antenna is validated by comparing measurements and simulations. Antenna performance is evaluated by numerical simulations and measurements at 7 T.

RESULTS

Simulations of B₁⁺ on a phantom are in good correspondence with measurements. Simulations on a human model indicate that the signal-to-noise ratio (SNR), specific absorption rate (SAR) efficiency and SAR increase when adding the forward view antenna to a previously published dipole array. The SNR increases by up to 18% when adding the forward view antenna as a receive antenna to an eight-channel dipole array in vivo.

CONCLUSIONS

A design for a forward view antenna is presented and evaluated. SNR improvements up to 18% are demonstrated when adding the forward view antenna to a dipole array.

Modular transmit/receive arrays using very-high permittivity dielectric resonator antennas

PURPOSE

Dielectric resonator antenna (DRAs) are compact structures that exhibit low coupling between adjacent elements and therefore can be used as MRI transmit arrays. In this study, we use very high permittivity materials to construct modular flexible transceive arrays of a variable numbers of elements for operation at 7T.

METHODS

DRAs were constructed using rectangular blocks of ceramic (lead zirconate titanate, ε_r  = 1070) with the transverse electric (TE)₀₁ mode tuned to 298 MHz. Finite-difference time-domain simulations were used to determine the B₁ and specific absorption rate distributions. B1+ maps were acquired in a phantom to validate the simulations. Performance was compared to an equally sized surface coil. In vivo images were acquired of the wrist (four elements), ankle (seven elements), and calf muscle (16 elements).

RESULTS

Coupling between DRAs spaced 5 mm apart on a phantom was -18.2 dB compared to -9.1 dB for equivalently spaced surface coils. DRAs showed a higher B1+ intensity close to the antenna but a lower penetration depth compared to the surface coil.

CONCLUSION

DRAs show very low coupling compared to equally sized surface coils and can be used in transceive arrays without requiring decoupling networks. The penetration depth of the current DRA geometry means they are ideally suited to imaging of extremities. Magn Reson Med 79:1781-1788, 2018. © 2017 The Authors Magnetic Resonance in Medicine published by Wiley Periodicals, Inc. on behalf of International Society for Magnetic Resonance in Medicine. This is an open access article under the terms of the Creative Commons Attribution NonCommercial License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited and is not used for commercial purposes.

Improved image quality and reduced power deposition in the spine at 3 T using extremely high permittivity materials

Purpose

To explore the effect of using extremely high permittivity (ε_r∼1,000) materials on image quality and power requirements of spine imaging at 3 T.

Theory and Methods

A linear array of high permittivity dielectric blocks made of lead zirconate titanate (PZT) was designed and characterized by electromagnetic simulations and experiments. Their effect on the transmit efficiency, receive sensitivity, power deposition, and diagnostic image quality was analyzed in vivo in 10 healthy volunteers.

Results

Simulation results showed that for quadrature mode excitation, the PZT blocks improve the transmit efficiency by 75% while reducing the maximum 10g average specific absorption rate (SAR₁₀) by 20%. In vivo experiments in 10 healthy volunteers showed statistically significant improvements for the transmit efficiency, and image quality. Compared to active radiofrequency shimming, image quality was similar, but the required system input power was significantly lower for quadrature excitation using the PZT blocks.

Conclusion

For single‐channel transmit systems, using high permittivity PZT blocks offer a way to improve transmit efficiency and image quality in the spine. Results show that the effect, and therefore optimal design, is body mass index and sex specific. Magn Reson Med 79:1192–1199, 2018. © 2017 The Authors Magnetic Resonance in Medicine published by Wiley Periodicals, Inc. on behalf of International Society for Magnetic Resonance in Medicine. This is an open access article under the terms of the Creative Commons Attribution NonCommercial License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited and is not used for commercial purposes.