Investigation of structure-performance properties of a special type of polysulfone blended membranes

Boosting brackish water treatment via integration of mesoporous γ-Al2O3NPs with thin-film nanofiltration membranes

In this study, a simple method based on non-ionic surfactant polysorbates-80 was used to create mesoporous γ-Al₂O₃NPs. The properties of the prepared mesoporous alumina nanoparticles (Al₂O₃NPs) were verified using ATR-FTIR, XRD, SEM, TEM, DLS, and BET surface area analysis. Then, thin-film nanocomposite (TFN) nanofiltration membranes were fabricated by interfacial polymerization of embedded polyamide layers with varied contents (0.01 to 0.15 wt.%) of mesoporous γ-Al₂O₃NPs. The surface roughness, porosity, pore size, and contact angle parameters of all the prepared membranes were also determined. The performance of the fabricated membranes was investigated under various mesoporous γ-Al₂O₃NPs loads, time, and pressure conditions. Mesoporous γ-Al₂O₃NPs revealed an important role in raising both the membrane hydrophilicity and the surface negativity. The addition of 0.03 wt.% mesoporous γ-Al₂O₃NPs to the TFN membrane increased water flux threefold compared to the TF control (TFC) membrane, with maximum water flux reaching 96.5, 98, 60, and 52 L/(m².h) for MgSO₄, MgCl₂, Na₂SO₄, and NaCl influent solutions, respectively, with the highest salt rejection of 96.5%, 92.2%, 98.4%. The TFN-Al₂O₃ membrane was also able to soften water and remove polyvalent cations such as Mg²⁺ with a highly permeable flux. The TFN-Al₂O₃ membrane successfully removed the hardness of the applied water samples below the WHO limit compared to using merely the TFC membrane. Furthermore, the TFN-Al₂O₃ nanofiltration membrane unit proved to be a promising candidate for the desalination of real brine like that collected from the Safaga area, Egypt.

High-flux TFN nanofiltration membranes incorporated with Camphor-Al2O3 nanoparticles for brackish water desalination

A new approach of highly fluxes thin film nanocomposite (TFN) nanofiltration (NF) membranes is reported. The fabricated module was made by incorporation of commercial-Al₂O₃ (CO.TFN) and camphor-Al₂O₃NPs (CA.TFN) into polyamide layers throughout the interfacial polymerization method. A simple biological reduction technique was adopted in preparation of camphor-Al₂O₃ NPs by using CinnamomumCamphora (CC) leaf extract. The crystallography of the commercial and camphor-Al₂O₃ NPs was examined by XRD and FTIR analyses. The CO.TFN and CA.TFN membranes were characterized by determining their surface roughness, pore size, porosity, zeta potential and contact angle parameters. The morphology and the cross-sectional of the NF membranes were studied by atomic force microscope (AFM) and scanning electron microscope (SEM). NF performance was investigated at various Al₂O₃ NPs loads, applied pressure, and time. The results, of the membranes fabricated at low cost, showed the high permeable flux and elimination of multivalent cations (Mg²⁺, Ca²⁺, and water softening). Incorporating 0.98 mM of camphor-Al₂O₃ NPs into the TFC membrane increased the water flux up to 4 times compared to only 1.5 times for commercial-Al₂O₃ NPs. Moreover, the salt rejection of CO.TFN and CA.TFN NF membranes increased to 95.1% and 96.5%, respectively for the feed solution (2 g/L Na₂SO₄ at 25 °C). The optimized NF membrane module of 0.98 mM camphor-Al₂O₃-NPs (CA.TFN) shows the maximum water flux 69.0,62.2, 60.5 and 55.4 L/m².h for the feed solutions of following salts NaCl, Na₂SO₄, MgCl₂ and MgSO₄ with high salt rejections 92.4%, 96.5%, 91.7% and 95.3%, respectively. This proves that camphor-Al₂O₃ NPs have a significant role in increasing the membrane hydrophilicity. Hence, the CA.TFN membrane module proved to be a promising candidate for the real brackish water desalination as that collected from Marsa Alam, Egypt.

Cannabinoids and Terpenes as an Antibacterial and Antibiofouling Promotor for PES Water Filtration Membranes

Plant phytochemicals have potential decontaminating properties, however, their role in the amelioration of hydrophobic water filtration membranes have not been elucidated yet. In this work, phytochemicals (i.e., cannabinoids (C) and terpenes (T) from C. sativa) were revealed for their antibacterial activity against different Gram-positive and Gram-negative bacteria. As such, a synergistic relationship was observed between the two against all strains. These phytochemicals individually and in combination were used to prepare polyethersulfone (PES) hybrid membranes. Membrane characterizations were carried out using scanning electron microscopy, Fourier transform infrared spectroscopy, energy-dispersive X-ray spectroscopy. Moreover, contact angle, water retention, surface roughness, mechanical testing, and X-ray florescence analysis were also carried out. According to results, the CT-PES hybrid membrane exhibited the lowest contact angle (40°), the highest water retention (70%), and smallest average pore size (0.04 µm). The hybrid membrane also exhibited improved water flux with no surface leaching. Quantitative bacterial decline analysis of the CT-PES hybrid membranes confirmed an effective antibacterial performance against Gram-positive and Gram-negative bacteria. The results of this study established cannabinoids and terpenes as an inexpensive solution for PES membrane surface modification. These hybrid membranes can be easily deployed at an industrial scale for water filtration purposes.