Study of mixing of liquid/polymer in twin screw extruder by residence time distribution

Open-Celled Foams from Polyethersulfone/Poly(Ethylene Glycol) Blends Using Foam Extrusion

Polyethersulfone (PESU), as both a pristine polymer and a component of a blend, can be used to obtain highly porous foams through batch foaming. However, batch foaming is limited to a small scale and is a slow process. In our study, we used foam extrusion due to its capacity for large-scale continuous production and deployed carbon dioxide (CO₂) and water as physical foaming agents. PESU is a high-temperature thermoplastic polymer that requires processing temperatures of at least 320 °C. To lower the processing temperature and obtain foams with higher porosity, we produced PESU/poly(ethylene glycol) (PEG) blends using material penetration. In this way, without the use of organic solvents or a compounding extruder, a partially miscible PESU/PEG blend was prepared. The thermal and rheological properties of homopolymers and blends were characterized and the CO₂ sorption performance of selected blends was evaluated. By using these blends, we were able to significantly reduce the processing temperature required for the extrusion foaming process by approximately 100 °C without changing the duration of processing. This is a significant advancement that makes this process more energy-efficient and sustainable. Additionally, the effects of blend composition, nozzle temperature and foaming agent type were investigated, and we found that higher concentrations of PEG, lower nozzle temperatures, and a combination of CO₂ and water as the foaming agent delivered high porosity. The optimum blend process settings provided foams with a porosity of approximately 51% and an average foam cell diameter of 5 µm, which is the lowest yet reported for extruded polymer foams according to the literature.

Enhancement of Green Tires Performance through Ultrasound-Assisted Mixing

Combined with the traditional internal mixing process, a custom-built ultrasonic generator was introduced in this study. The effect of ultrasonic parameters on the comprehensive performance of tread rubber formulations was investigated. Compared to the traditional mixing process without ultrasonic wave loading, the introduction of ultrasonic enhanced the dispersion and distribution of composite particles in the rubber matrix and improved the overall performance of rubber products. The devil’s triangle relationship among the rolling resistance, wet skid resistance, and abrasion resistance of tires was improved. When the wet skid resistance was slightly lost, the rolling resistance and wear rate were effectively reduced. This study provides new insights into a strategy for optimizing the mixing process of the traditional internal mixer, reducing vehicle emissions, extending the service life of tires, and promoting the development of green tires.

Reactive Processing of Thermoplastic Polymers: A Review of the Fundamental Aspects

The review is devoted to the fundamental aspects of the reactive processing of thermoplastic polymers. First of all, some reactive processing examples, including polymer grafting (vinyl silane, maleic anhydride) and/or functionalization, bulk polymerization (urethane, lactams, acrylate, ∊-capolactone), polyester modification and new copolymers synthesis, are presented. From a fundamental point of view, the review covers the state of the art in the domains of rheology (specifically modelling of rheo-kinetics), diffusion and mixing in highly viscous reactive or non reactive media. Finally, 1, 2 and 3-D simulation of the reactive extrusion process in twin-screw extruder is reported at the end of the review.