Improved process moldability and part quality of short-glass–fiber-reinforced polypropylene via overflow short-shot water-assisted injection molding

Water-assisted injection molding (WAIM) is a promising molding process developed based on conventional injection molding (CIM). It has been a research hotspot in recent years and is still receiving extensive attention from many scholars and industries because of its significant potential advantages in practical applications. However, compared with CIM, since the additional water-related parameters are involved, the process moldability of thermoplastics is significantly reduced, especially for fiber-reinforced thermoplastics, which stunts the development of WAIM process. In this work, short-shot WAIM with an overflow cavity (OSSWAIM) was developed to address the problems and broaden the application scope of WAIMs. The results showed that compared with overflow WAIM (OWAIM) and short-shot WAIM (SSWAIM), OSSWAIM could significantly improve the process moldability and part quality of fiber-reinforced thermoplastics, especially for thermoplastic composites with a high fiber weight fraction. Besides, it was also found that water penetration had a slight influence on the fiber orientation near the water inlet, but had a significant influence on the fiber orientation near the end of mold cavity. Finally, three processing parameters affecting the water penetration, i.e., water pressure, melt temperature, and water injection delay time were investigated in terms of their influences on the fiber orientation within OSSWAIM.

Effect of Rapid Mold Heating on the Structure and Performance of Injection-Molded Polypropylene

The tailoring by the process of the properties developed in the plastic objects is the more effective way to improve the sustainability of the plastic objects. The possibility to tailor to the final use the properties developed within the molded object requires further understanding of the relationship between the properties of the plastic objects and the process conduction. One of the main process parameters that allow adjusting the properties of molded objects is the mold temperature. In this work, a thin electrical heater was located below the cavity surface in order to obtain rapid and localized surface heating/cooling cycles during the injection molding process. An isotactic polypropylene was adopted for the molding tests, during which surface temperature was modulated in terms of values and heating times. The modulation of the cavity temperature was found able to control the distribution of relevant morphological characteristics, thus, properties along the sample thickness. In particular, lamellar thickness, crystallinity distribution, and orientation were analyzed by synchrotron X-ray experiments, and the morphology and elastic modulus were characterized by atomic force microscopy acquisitions carried out with a tool for the simultaneous nanomechanical characterization. The crystalline degree slightly increased with the cavity temperature, and this induced an increase in the elastic modulus when high temperatures were adopted for the cavity surface. The cavity temperature strongly influenced the orientation distribution that, on its turn, determined the highest values of the elastic modulus found in the shear layer. Furthermore, although the sample core, not experiencing a strong flow field, was not characterized by high levels of orientation, it might show high values of the elastic modulus if temperature and time during crystallization were sufficient. In particular, if the macromolecules spent adequate time at temperatures close to the crystallization temperature, they could achieve high levels of structuring and, thus, high values of elastic modulus.