Development of a Rheology Die and Flow Characterization of Gas-Containing Polymer Melts

We present a novel measurement die for characterizing the flow behavior of gas-containing polymer melts. The die is mounted directly on the injection-molding cylinder in place of the mold cavity and thus enables near-process measurement of viscosity (i.e., under the conditions that would be present were a mold attached). This integration also resolves the issue of keeping gas-containing polymer melts under pressure during measurement to prevent desorption. After thermal characterization of the die, various correction approaches were compared against each other to identify the most suitable one for our case. We conducted measurements using polypropylene in combination with two different chemical blowing agents. Increasing the blowing-agent content to up to 6% revealed an interestingly low influence of gases on melt viscosity, which was confirmed by elongational viscosity measurements. For verification, we compared our results to corresponding measurements taken on a high-pressure capillary rheometer and found that they were in excellent agreement. Our die cannot only be used for rheological characterization. Combined with ultrasound sensors, it provides an innovative way of measuring the volumetric flow rate. This development represents an important step in improving the sustainability of gas-containing polymer processing.

Backpressure Optimization in Foam Injection Molding: Method and Assessment of Sustainability

Inspired by the Industry 4.0 trend towards greater user-friendliness and self-optimization of machines, we present a novel approach to reducing backpressure in foam injection molding. Our method builds on the compressibility of polymer-gas mixtures to detect undissolved gas phases during processing at insufficient backpressures. Identification of a characteristic behavior of the bulk modulus upon transition from homogeneous to heterogeneous polymer-gas mixtures facilitated the determination of the minimum pressure required during production to be determined, as verified by ultrasound measurements. Optimization of the pressure conditions inside the barrel by means of our approach saves resources, making the process more sustainable. Our method yielded a 45% increase in plasticizing capacity, reduced the torque needed by 24%, and required 46% less plasticizing work and lower pressures in the gas supply chain. The components produced exhibited both improved mechanical bending properties and lower densities. From an economic point of view, the main advantages of optimized backpressures are reduced wear and lower energy consumption. The methodology presented in this study has considerable potential in terms of sustainable production and offers the prospect of fully autonomous process optimization.