General-base catalysed hydrolysis and nucleophilic substitution of activated amides in aqueous solutions

Hydrolysis of 1-(X-substituted-benzoyl)-4-aminopyridinium ions: effect of substituent X on reactivity and reaction mechanism

A kinetic study is reported for hydrolysis of 1-(X-substituted-benzoyl)-4-aminopyridinium ions 2a-i, which were generated in situ from the nucleophilic substitution reaction of 2,4-dinitrophenyl X-substituted-benzoates 1a-i with 4-aminopyridine in 80 mol% H(2)O/20 mol% DMSO at 25.0 ± 0.1 °C. The plots of pseudo-first-order rate constants k(obsd) vs. pyridine concentration are linear with a large positive intercept, indicating that the hydrolysis of 2a-i proceeds through pyridine-catalyzed and uncatalyzed pathways with the rate constant k(cat) and k(o), respectively. The Hammett plots for k(cat) and k(o) consist of two intersecting straight lines, which might be taken as evidence for a change in the rate-determining step (RDS). However, it has been proposed that the nonlinear Hammett plots are not due to a change in the RDS but are caused by stabilization of 2a-i in the ground state through a resonance interaction between the π-electron-donor substituent X and the carbonyl functionality. This is because the corresponding Yukawa-Tsuno plots exhibit excellent linear correlations with ρ(X) = 1.45 and r = 0.76 for k(cat) while ρ(X) = 1.39 and r = 0.72 for k(o). A possibility that the hydrolysis of 2a-i proceeds through a concerted mechanism has been ruled out on the basis of the large ρ(X) values. Thus, the reaction has been concluded to proceed through a stepwise mechanism in which the leaving group departs after the RDS since OH(-) is more basic and a poorer nucleofuge than 4-aminopyridine.

Kinetics and Mechanism of Tetrahydrofuran Synthesis via 1,4-Butanediol Dehydration in High-Temperature Water

We conducted an experimental investigation into the kinetics and mechanism of tetrahydrofuran synthesis from 1,4-butanediol via dehydration in high-temperature liquid water (HTW) without added catalyst at 200-350 degrees C. The reaction was reversible, with tetrahydrofuran being produced at an equilibrium yield of 84% (at 200 degrees C) to 94% (at 350 degrees C). The addition of CO2 to the reaction mixture increased the reaction rate by a factor of 1.9-2.9, because of the increase in acidity resulting from the formation and dissociation of carbonic acid. This increase was much less than that expected (factor of 37-60) from a previously suggested acid-catalyzed mechanism. This disagreement prompted experiments with added acid (HCl) and base (NaOH) to investigate the influence of pH on the reaction rate. These experiments revealed three distinct regions of pH dependence. At high and low pH, the dehydration rate increased with increasing acidity. At near-neutral pH, however, the rate was essentially insensitive to changes in pH. This behavior is consistent with a mechanism where H2O, in addition to H+, serves as a proton donor. This work indicates that the relatively high native concentration of + (large KW), which has commonly been thought to lead to the occurrence of acid-catalyzed reactions in HTW without added catalyst, does not explain the dehydration of 1,4-butanediol in HTW without catalyst. Rather, H2O serves directly as the proton donor for the reaction.