Surface modification. II. Functionalization of solid surfaces with vinylic monomers

Probing Liquid-Solid and Vapor-Liquid-Solid Interfaces of Hierarchical Surfaces Using High-Resolution Microscopy

Liquid-solid (LS) and vapor-liquid-solid (VLS) interfaces are important for the fundamental understanding of how surface chemistry impacts industrial processes and applications. Superhydrophobic surfaces, from structural hierarchies, were fabricated by coating flat smooth surfaces with hollow glass microspheres. These surfaces are referred to as structural hierarchical-modified microsphere surfaces (SHiMMs). Two-phase LS and three-phase VLS interfaces of water droplets on SHiMMs, with an apparent static contact angle (aSCA) of ∼160°, were probed at microscale using environmental scanning electron microscopy (ESEM) and high-resolution optical microscopy (OM). Both ESEM and OM confirmed the presence of air pockets in 3-150 μm range at the VLS triple-phase of the droplet peripheral contact line. The wetting characteristics of the LS interface in the interior of the water droplet were probed using energy-dispersive spectroscopy, which corroborated well with the VLS triple-phase observations, confirming the presence of both the microscale air pockets and fractional complete wetting of the SHiMMs. The superhydrophobic water droplets on the SHiMMs also exhibited relatively high adhesion to the SHiMMs-a tilt angle of 10°-40° was needed for detaching the droplets off the surfaces. Semiquantitative three-phase contact-line analysis and experimental data indicated high-water aSCA, and large adhesion on the microscale-roughened SHiMMs is attributed to pinning of the probe liquid both at the triple VLS and interior LS interfaces. The control over microroughness and surface chemistry of the SHiMMs will allow tuning of both the static and dynamic liquid-surface interactions.

Investigations of the mechanism of gold nanoparticle stability and surface functionalization in capillary electrophoresis

Covalently functionalized gold nanoparticles influence capillary electrophoresis separations of neurotransmitters in a concentration- and surface-chemistry-dependent manner. Gold nanoparticles with either primarily covalently functionalized carboxylic acid (Au@COOH) or amine (Au@NH(2)) surface groups are characterized using extinction spectroscopy, transmission electron microscopy, and zeta potential measurements. The impact of the presence of nanoparticles and their surface chemistry is investigated, and at least three nanoparticle-specific mechanisms are found to effect separations. First, the degree of nanoparticle-nanoparticle interactions is quantified using a new parameter termed the critical nanoparticle concentration (CNC). CNC is defined as the lowest concentration of nanoparticles that induces predominant nanoparticle aggregation under specific buffer conditions and is determined using dual-wavelength photodiode array detection. Once the CNC has been exceeded, reproducible separations are no longer observed. Second, nanoparticle-analyte interactions are dictated by electrostatic interactions which depend on the pK(a) of the analyte and surface charge of the nanoparticle. Finally, nanoparticle-capillary interactions occur in a surface-chemistry-dependent manner. Run buffer viscosity is influenced by the formation of a nanoparticle steady-state pseudostationary phase along the capillary wall. Despite differences in buffer viscosity leading to changes in neurotransmitter mobilities, no significant changes in electroosmotic flow were observed. As a result of these three nanoparticle-specific interactions, Au@NH(2) nanoparticles increase the mobility of the neurotransmitters while a smaller opposite effect is observed for Au@COOH nanoparticles. Understanding nanoparticle behavior in the presence of an electric field will have significant impacts in separation science where nanoparticles can serve to improve either the mobility or detection sensitivity of target molecules.