Synthesis of Donor–Acceptor Copolymers Derived from Diketopyrrolopyrrole and Fluorene via Eco-Friendly Direct Arylation: Nonlinear Optical Properties, Transient Absorption Spectroscopy, and Theoretical Modeling

A series of PFDPP copolymers based on fluorene (F) and diketopyrrolopyrrole (DPP) monomers were synthesized via direct arylation polycondensation using Fagnou conditions which involved palladium acetate as catalyst (a gradual catalyst addition of three different percentages were used), potassium carbonate as the base, and neodecanoic acid in N, N-dimethylacetamide. This synthesis provides a low cost compared with traditional methods of transition-metal-catalyzed polymerization. Among the different amounts of catalyst used in the present work, 12% was optimal because it gave the highest reaction yield (81.5%) and one of the highest molecular weights (Mn = 13.8 KDa). Copolymers’ chemical structures, molecular weight distributions, and optical and thermal properties were analyzed. The linear optical properties of PFDPP copolymers resulted very similarly independently to the catalyst amounts used in the synthesis of the PFDPP copolymers: two absorptions bands distinctive of donor–acceptor copolymers, Stokes shifts of 41 nm, a good quantum yield of fluorescence around 47%, and an optical bandgap of 1.7 eV were determined. Electronic nonlinearities were observed in these copolymers with a relatively high two-photon absorption cross-section of 621 GM at 950 nm. The dynamics of excited states and aggregation effects were studied in solutions, nanoparticles, and films of PFDPP. Theoretical calculations modeled the ground-state structures of the (PFDPP)n copolymers with n = 1 to 4 units, determining the charge distribution by the electrostatic potential and modeling the absorption spectra determining the orbital transitions responsible for the experimentally observed leading bands. Experimental and theoretical structure–properties analysis of these donor–acceptor copolymers allowed finding their best synthesis conditions to use them in optoelectronic applications.

Chemoselective synthesis of fully substituted pyrroles via a one-pot four-component isocyanide-based reaction

Small-ring heterocycles comprising pyrrole and pyrazole are well known for their rich biological properties. In this article, an efficient green sonochemical approach was designed for the synthesis of novel, fully substituted pyrroles connected to pyrazole scaffolds via a one-pot, four-component isocyanide-based sequential reaction. This reaction was carried out using various 5-amino-pyrazoles, aldehydes, dialkyl acetylenedicarboxylates and isocyanides for the synthesis of fully functionalized pyrroles with high chemoselectivity in the presence of a catalytic amount of PTSA·H2O, in good to excellent yields under ultrasound irradiation. This waste-free (-H2O) reaction exhibited a high atom economy and step economy via creating four new bonds, including two C-N and two C-C bonds, and the formation of two five-member heterocycles which are connected in a single operation. The mechanism of this four-component domino process involved sequential imination-dipolar cyclization-[1,5]-H shift reactions. The synthesized compounds possess interesting fluorescence features, and the bioactive scaffolds might attract great interest in the fields of clinical diagnostics and biomedical research in the future.

Synthesis of 2,5-Dibutyl-3,6-dimethyl-1 H,2 H,4 H,5 H-pyrrolo[3,4- c]pyrrole-1,4-dione: A Diketopyrrolopyrrole Scaffold for the Formation of Alkenyldiketopyrrolopyrrole Compounds

This manuscript describes an unprecedented and efficient synthesis of a new DPP scaffold, 2,5-dibutyl-3,6-dimethyl-1 H,2 H,4 H,5 H-pyrrolo[3,4- c]pyrrole-1,4-dione (DMDPP), containing methyl groups at the 3,6-positions as a precursor to preparing 3,6-divinyl-substituted DPP compounds. Subsequently, following the synthesis of DMDPP, we performed an efficient and mild C-H functionalization of the methyl groups with a variety of aromatic aldehydes to synthesize the first examples of 3,6-divinyl-substituted DPP compounds in moderate to good yields.

Near-Infrared-Absorbing Metal-Free Organic, Porphyrin, and Phthalocyanine Sensitizers for Panchromatic Dye-Sensitized Solar Cells

Dye-sensitized solar cells (DSCs) are a promising source of renewable energy. However, the power conversion efficiency (PCE) of devices has been limited largely by the difficulty of producing electricity using photons from the near-infrared (NIR) spectral region. Metal-free organic sensitizers frequently employ strong electron-donating or -withdrawing moieties to tune the optical band gap to allow the absorption of lower energy wavelengths in charge-transfer systems, whereas porphyrins and phthalocyanines use substituents to shift the Soret and Q bands toward lower energy absorption. Very few devices employing precious metal-free dyes have achieved panchromatic and NIR photon conversion for electricity generation at wavelengths >750 nm despite a tremendous number of sensitizers published over the last 25 years. This Minireview seeks to compile a summary of these sensitizers to encourage assimilation, analysis, and development of efficient future sensitizers with absorption extending into the NIR. Herein, we discuss common synthetic strategies, optical properties, and electronic properties of the most successful panchromatic organic sensitizers.

Broad spectral-response organic D–A–π–A sensitizer with pyridine-diketopyrrolopyrrole unit for dye-sensitized solar cells

In this work, four D–A–π–A sensitizers PDPP-I–IV based on pyridine-flanked DPP moieties (PDPP) were designed and synthesized for broadly spectral-response in dye-sensitized solar cells.

Colorimetric and fluorogenic signalling of fluoride ions by diketopyrrolopyrrole-based chemosensor

A new colorimetric and on–off fluorescence sensor based on diketopyrrolopyrrole (DPP) was synthesized for detection of fluoride anion.

Record high electron mobility of 6.3 cm² V⁻¹ s⁻¹ achieved for polymer semiconductors using a new building block

A new electron acceptor building block, 3,6-di(pyridin-2-yl)pyrrolo[3,4-c ]pyrrole-1,4(2H ,5H)-dione (DBPy), is used to construct a donor-acceptor polymer, PDBPyBT. This polymer exhibits a strong self-assembly capability, to form highly crystalline and oriented thin films with a short π-π stacking distance of 0.36 nm. PDBPyBT shows ambipolar charge-transport performance in organic thin-film transistors, reaching a record high electron-mobility value of 6.30 cm(2) V(-1) s(-1).

Conjugated polymers containing diketopyrrolopyrrole units in the main chain

Research activities in the field of diketopyrrolopyrrole (DPP)-based polymers are reviewed. Synthetic pathways to monomers and polymers, and the characteristic properties of the polymers are described. Potential applications in the field of organic electronic materials such as light emitting diodes, organic solar cells and organic field effect transistors are discussed.

Carbazole-based organogel as a scaffold to construct energy transfer arrays with controllable fluorescence emission

A diaryldiketopyrrolopyrrole derivative functionalized with phenothiazine moieties (DPPP) was synthesized and introduced into the ordered 4-(3,6-di-tert-butyl-9H-carbazol-9-yl)benzamide (TBCB) organogel system. It was found that TBCB-based gel became a scaffold to make DPPP molecules line up along the gel fibers, resulting in new self-assembled arrays, whose XRD patterns were quite different from those of the neat TBCB gel and DPPP crystal. In the composite gel, the occurrence of a partial energy transfer from the excited light-harvesting antenna of TBCB to the DPPP acceptor was confirmed on the basis of time-dependent and time-resolved fluorescence investigations. Remarkably, the composite gel could emit intense red light or purplish white light by tuning the excitation wavelength. Such ordered soft materials with color-tunable emission may possess potential applications in sensor and photonic devices.