Real-time monitoring of the progress of polymerization reactions directly on surfaces at open atmosphere by ambient mass spectrometry

A dopant for improved sensitivity in easy ambient sonic-spray ionization mass spectrometry

Recently, 3-nitrobenzonitrile (3-NBN) has been used to improve sensitivity of sonic-spray ionization mass spectrometry. Easy ambient sonic-spray ionization (EASI) is one of the simplest, gentlest and most used spray-based desorption/ionization ambient techniques, but limited sensitivity has been commonly taken as its major drawback. Herein we investigate the use of 3-NBN as a dopant in EASI-MS for improved sensitivity. Using a few typical EASI samples as test cases, the presence of 10 ppm (µg ml(-1) ) of 3-NBN in the spray solvent showed two to fourfold gains in EASI-MS sensitivity as measured both by total ion current and S/N ratios, accompanied with significant reductions in chemical noise. Sensitivity for DESI using 3-NBN as a dopant also improved and dopant DESI versus dopant EASI sensitivities were compared. The use of solvent dopants seems therefore to be a promising strategy to improve sensitivity for spray-based ambient MS techniques. Copyright © 2015 John Wiley & Sons, Ltd.

Going beyond electrospray: mass spectrometric studies of chemical reactions in and on liquids

There has been a burst in the number and variety of available ionization techniques to use mass spectrometry to monitor chemical reactions in and on liquids. Chemists have gained the capability to access chemistry at unprecedented timescales, and monitor reactions and detect intermediates under almost any set of conditions. Herein, recently developed ionization techniques that facilitate mechanistic studies of chemical processes are reviewed. This is followed by a discussion of our perspective on the judicious application of these and similar techniques in order to study reaction mechanisms.

Ambient mass spectrometry imaging: a comparison of desorption ionization by sonic spray and electrospray

Easy ambient sonic spray ionization (EASI) and desorption electrospray ionization (DESI) were used for imaging of a number of samples, including sections of rat brain and imprints of plant material on porous Teflon. A novel approach termed Displaced Dual-mode Imaging was utilized for the direct comparison of the two methods: Images were recorded with the individual rows alternating between EASI and DESI, yielding a separate image for each technique recorded under perfectly similar conditions on the same sample. EASI works reliably for imaging of all samples, but the choice of spray solvent and flow rate is more critical in tissue imaging with EASI than with DESI. The overall sensitivity of EASI is, in general, slightly lower than that of DESI, and the representation of the dynamic range is different in images of the two techniques for some samples. However, for abundant compounds, EASI works well, resulting in images of similar quality as DESI. EASI can thus be used in imaging experiments where the application of high voltage is impractical or undesirable. The present study is in its nature also a comparison of the characteristics of the two techniques, showing results also applicable for non-imaging work, with regards to sensitivity and experimental conditions.

Quantitative real-time monitoring of chemical reactions by autosampling flow injection analysis coupled with atmospheric pressure chemical ionization mass spectrometry

Although qualitative and/or semiquantitative real-time monitoring of chemical reactions have been reported with a few mass spectrometric approaches, to our knowledge, no quantitative mass spectrometric approach has been reported so far to have a calibration valid up to molar concentrations as required by process control. This is mostly due to the absence of a practical solution that could well address the sample overloading issue. In this study, a novel autosampling flow injection analysis coupled with an atmospheric pressure chemical ionization mass spectrometry (FIA/APCI-MS) system, consisting of a 1 μL automatic internal sample injector, a postinjection splitter with 1:10 splitting ratio, and a detached APCI source connected to the mass spectrometer using a 4.5 in. long, 0.042 in. inner diameter (ID) stainless-steel capillary, was thus introduced. Using this system together with an optional FIA solvent modifier, e.g., 0.05% (v/v) isopropylamine, a linear quantitative calibration up to molar concentration has been achieved with 3.4-7.2% relative standard deviations (RSDs) for 4 replicates. As a result, quantitative real-time monitoring of a model reaction was successfully performed at the 1.63 M level. It is expected that this novel autosampling FIA/APCI-MS system can be used in quantitative real-time monitoring of a wide range of reactions under diverse reaction conditions.

Nebulization ionization and desorption ionization analysis of reactive organofunctionalized silanes in nanofilm products

Three different and recently developed desorption ionization techniques, transmission-mode desorption electrospray ionization (TM-DESI), low temperature plasma (LTP) ionization and nano-assisted laser desorption ionization (NALDI), are compared with electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) for the analysis of two nanofilm products (NFPs) for surface coating, which contain hydrolysates and condensates of organo-functionalized silanes. The NFPs were characterized in different states from the liquid phase to the fully formed surface film. The LTP spectra were dominated by the silanes, while the corresponding di-, tri- and tetrasiloxanes were common in ESI, APCI and TM-DESI. This indicates readily condensation of the silanes during the ESI and APCI ionization processes leading to the observed siloxanes. NALDI showed larger siloxane structures than the other techniques, indicating film formation on the NALDI target. Real-time monitoring of the film formation on a glass surface by LTP showed a decreasing abundance of the silanes, while the abundances of the di-, tri and tetrasiloxanes increased significantly within the first 100 s. LTP was superior in showing the non-reacted content of the NFPs, while ESI, APCI and TM-DESI were characterized by artefact formation of siloxanes. NALDI was ideal for showing the siloxane structures of the formed film. The applicabilities of each of the ionization techniques were examined, showing the advantage of utilizing more than one ionization technique for the analysis of reactive species.