Rapid, Trace‐Level Ammonia Gas Sensor Based on Surface‐Engineered Ag Nanoclusters@Polyaniline/Multiwalled Carbon Nanotubes and Insights into Their Mechanistic Pathways

NO2 Sensing Behavior of Compacted Chemically Treated Multi-Walled Carbon Nanotubes

This article is devoted to the investigation of the sensing behavior of chemically treated multi-walled carbon nanotubes (MWNTs) at room temperature. Chemical treatment of MWNTs was carried out with a solution of either sulfuric or chromic acids. The materials obtained were investigated by transmission electron microscopy, scanning electron microscopy, Raman-spectroscopy, X-ray diffraction, and Fourier transform infrared spectroscopy. The active layer of chemiresistive gas sensors was obtained by cold pressing (compaction) at 11 MPa of powders of bare and treated multi-walled carbon nanotubes. The sensing properties of pellets were investigated using a custom dynamic type of station at room temperature (25 ± 2 °C). Detection of NO₂ was performed in synthetic air (79 vol% N₂, 21 vol% O₂). It was found that the chemical treatment significantly affects the sensing properties of multi-walled carbon nanotubes, which is indicated by increasing the response of the sensors toward 100-500 ppm NO₂ and lower concentrations.

Recent Advances in Ammonia Gas Sensors Based on Carbon Nanomaterials

This review paper is devoted to an extended analysis of ammonia gas sensors based on carbon nanomaterials. It provides a detailed comparison of various types of active materials used for the detection of ammonia, e.g., carbon nanotubes, carbon nanofibers, graphene, graphene oxide, and related materials. Different parameters that can affect the performance of chemiresistive gas sensors are discussed. The paper also gives a comparison of the sensing characteristics (response, response time, recovery time, operating temperature) of gas sensors based on carbon nanomaterials. The results of our tests on ammonia gas sensors using various techniques are analyzed. The problems related to the recovery of sensors using various approaches are also considered. Finally, the impact of relative humidity on the sensing behavior of carbon nanomaterials of various different natures was estimated.

Development of low-cost hybrid multi-walled carbon nanotube-based ammonia gas-sensing strips with an integrated sensor read-out system for clinical breath analyzer applications

This work demonstrates the development of Ag@polyaniline/multi-walled carbon nanotube nanocomposite-based sensor strips and a suitable integrated electronic read-out system for the measurement of trace-level concentrations of ammonia (NH₃). The sensor is optimized under various operating conditions and the resulting sensor exhibited an enhanced response (32% for 2 ppm) with excellent selectivity. Stable performance was observed towards NH₃ in the presence of high concentrations of CO₂ (>40 000 ppm), simulated and real breath samples. A suitable electronic sensor read-out system has also been designed and developed based on multi-scale resistance-to-voltage conversion architecture, processed by a 32-bit microcontroller which is operatable over a wide range of sensor resistance (1 kΩ to 200 MΩ). As a proof of concept, integration of gas-sensing strips with the electronic read-out system was tested with various levels of NH₃ (<2 ppm as normal, >2 ppm as critical and 2 ppm as threshold), which is important for clinical breath analyzer applications. The developed prototype device can be readily incorporated into a portable, low-cost and non-invasive point-of-care breath NH₃ detection unit for portable pre-diagnostic breath analyzer applications.