BaO clusters on MgO nanocubes: a quantitative analysis of optical-powder properties

Segregation Engineering in MgO Nanoparticle-Derived Ceramics: The Impact of Calcium and Barium Admixtures on the Microstructure and Light Emission Properties

Nanostructured segregates of alkaline earth oxides exhibit bright photoluminescence emission and great potential as components of earth-abundant inorganic phosphors. We evaluated segregation engineering of Ca²⁺- and Ba²⁺-admixtures in sintered MgO nanocube-derived compacts. Compaction and sintering transform the nanoparticle agglomerates into ceramics with residual porosities of Φ = 24-28%. Size mismatch drives admixture segregation into the intergranular region, where they form thin metal oxide films and inclusions decorating grain boundaries and pores. An important trend in the median grain size evolution of the sintered bodies with d_{Ca(10 at. %)} = 90 nm < d_{Ba(1 at. %)} = 160 nm < d_MgO = 250 nm ∼ d_{Ca(1 at. %)} = 280 nm < d_{Ba(10 at. %)} = 870 nm is rationalized by segregation and interface energies, barriers for ion diffusion, admixture concentration, and the increasing surface basicity of the grains during processing. We outline the potential of admixtures on interface engineering in MgO nanocrystal-derived ceramics and demonstrate that in the sintered compacts, the photoluminescence emission originating from the grain surfaces is retained. Interior parts of the ceramic, which are accessible to molecules from the gas phase, contribute with oxygen partial pressure-dependent intensities to light emission.

Preparation and Pharmacokinetics Evaluation of Solid Self-Microemulsifying Drug Delivery System (S-SMEDDS) of Osthole

The study was performed aiming to enhance the solubility and oral bioavailability of poorly water-soluble drug osthole by formulating solid self-microemulsifying drug delivery system (S-SMEDDS) via spherical crystallization technique. Firstly, the liquid self-microemulsifying drug delivery system (L-SMEDDS) of osthole was formulated with castor oil, Cremophor RH40, and 1,2-propylene glycol after screening various lipids and emulsifiers. The type and amount of polymeric materials, good solvents, bridging agents, and poor solvents in S-SMEDDS formulations were further determined by single-factor study. The optimal formulation contained 1:2 of ethyl cellulose (EC) and Eudragit S100, which served as matrix forming and enteric coating polymers respectively. Anhydrous ethanol and dichloromethane with a ratio of 5:3 are required to perform as good solvent and bridging agent, respectively, with the addition of 0.08% SDS aqueous solution as poor solvent. The optimized osthole S-SMEDDS had a high yield (83.91 ± 3.31%) and encapsulation efficiency (78.39 ± 2.25%). Secondly, osthole L-SMEDDS was solidified to osthole S-SMEDDS with no significant changes in terms of morphology, particle size, and zeta potential. In vitro release study demonstrated a sustained release of the drug from osthole S-SMEDDS. Moreover, in vivo pharmacokinetic study showed that the T_max and mean residence time (MRT_(0-t)) of osthole were significantly prolonged and further confirmed that osthole S-SMEDDS exhibited sustained release effect in rabbits. Comparing with osthole aqueous suspension and L-SMEDDS, osthole S-SMEDDS increased bioavailability by 205 and 152%, respectively. The results suggested that S-SMEDDS was an effective oral solid dosage form, which can improve the solubility and oral bioavailability of poorly water-soluble drug osthole.

O2 adsorption dependent photoluminescence emission from metal oxide nanoparticles

Optical properties of metal oxide nanoparticles are subject to synthesis related defects and adsorbates.

Surface Decoration of MgO Nanocubes with Sulfur Oxides: Experiment and Theory

We investigated the effect of surface sulfate formation on the structure and spectroscopic properties of MgO nanocubes using X-ray diffraction, electron microscopy, several spectroscopic techniques, and ab initio calculations. After CS₂ adsorption and oxidative treatment at elevated temperatures the MgO particles remain cubic and retain their average size of ∼6 nm. Their low coordinated surface elements (corners and edges) were found to bind sulfite and sulfate groups even after annealing up to 1173 K. The absence of MgO corner specific photoluminescence emission bands at 3.4 and 3.2 eV substantiates that sulfur modifies the electronic properties of characteristic surface structures, which we attribute to the formation of (SO₃)^2- and (SO₄)^2- groups at corners and edges. Ab initio calculations support these conclusions and provide insight into the local atomic structures and spectroscopic properties of these groups.

Surface exciton separation in photoexcited MgO nanocube powders

In MgO nanocube powders surface excitons can separate and the resulting charge carriers provide reactive adsorption sites at well-defined surface elements. We employed photoluminescence (PL) emission bands originating from the photoexcitation of nanocube corners and edges as quantitative probes to explore their chemical reactivity towards molecular hydrogen. Surface excitons which form at corners and edges exhibit similar cross-sections for separation in vacuum. The separation of edge excitons, however, is significantly enhanced in hydrogen atmosphere when hydrogen adsorption occurs as a simultaneous surface process. The electronic structure of MgO nanocube edges which split hydrogen heterolytically upon generation of surface hydroxyls and hydrides is unaffected by the photoexcitation of corners. Respective edges, however, are efficient absorption sites for UV photons. Transfer of exciton energy to oxygen ions in corners is followed by exciton separation which transforms corner ions into surface radicals leading to a well-defined starting point for the site selective functionalization of metal oxide nanostructures.

Optical properties of nanocrystal interfaces in compressed MgO nanopowders

The optical properties and charge trapping phenomena observed on oxide nanocrystal ensembles can be strongly influenced by the presence of nanocrystal interfaces. MgO powders represent a convenient system to study these effects due to the well-defined shape and controllable size distributions of MgO nanocrystals. The spectroscopic properties of nanocrystal interfaces are investigated by monitoring the dependence of absorption characteristics on the concentration of the interfaces in the nanopowders. The presence of interfaces is found to affect the absorption spectra of nanopowders more significantly than changing the size of the constituent nanocrystals and, thus, leading to the variation of the relative abundance of light-absorbing surface structures. We find a strong absorption band in the 4.0-5.5 eV energy range, which was previously attributed to surface features of individual nanocrystals, such as corners and edges. These findings are supported by complementary first-principles calculations. The possibility to directly address such interfaces by tuning the energy of excitation may provide new means for functionalization and chemical activation of nanostructures and can help improve performance and reliability for many nanopowder applications.

Zinc oxide scaffolds on MgO nanocubes

Powders of isolated and well-dispersed oxide nanocubes are promising components for photoelectronic applications that benefit from tunable optical properties, surface reactivity and the ease of realization of their controlled assembly. Here, we demonstrate that combustion of zinc and magnesium metal vapors at reduced pressures followed by subsequent vacuum annealing of the resulting nanoparticle powders yields single-crystalline Zn(x)Mg(1-x)O nanocubes of exceptional regular cubic shape and edge lengths below 25 nm. In line with ab initio calculations, which predict preferential Zn(2+) segregation into low coordinated surface elements of the MgO nanocubes, we track the occupation of edge sites by chains of Zn(2+)-O(2-) units through their spectroscopic signatures. As a method to generate composite nanostructures with controlled spatial distribution of the chemical components, the annealing induced ion segregation can be extended to other well-dispersed metastable nanoparticles. We expect that the energy of segregation mainly depends on the site coordination number, which can promote controlled demixing within the nanoparticles.