A Novel High-Capacity Anode Material Derived from Aromatic Imides for Lithium-Ion Batteries

High-Performance Li-Organic Batteries Based on Conjugated and Nonconjugated Schiff-Base Polymer Anode Materials

In recent years, organic materials have been increasingly studied as anode materials in lithium-ion batteries (LIBs) due to their remarkable advantages, including abundant raw materials, low prices, diverse structures, and high theoretical capacity. In this paper, three types of aromatic Schiff-base polymer materials have been synthesized and examined as anode materials in LIBs. Among them, the polymer [C6H4N = CHC6H4CH=N]n (TTD-PDA) has a continuous conjugated backbone (label as conjugated polymer), while polymers [(CH2)2N=CHC6H4CH=N]n (TTD-EDA) and [C6H4N=CH(CH2)3CH=N]n (GA-PDA) have discontinuous conjugated back-bones (label as nonconjugated polymer). The organic anodes based on TTD-PDA, TTD-EDA, and GA-PDA for LIBs are discovered to represent high reversible specific capacities of 651, 492, and 416 mAh g-1 at a current density of 100 mA g-1 as well as satisfactory rate capabilities with high capacities of 210, 90, and 178 mAh g-1 and 105, 57, and 122 mAh g-1 at current densities of 2 and 10 A g-1, indicating that these Schiff-base polymers are all promising anode materials for LIBs, which broadens the design of organic anode materials with high specific capacity, superior rate performance, and stable cycling stability.

FeIII Chelated with Humic Acid with Easy Synthesis Conditions and Good Performance as Anode Materials for Lithium-Ion Batteries

In this work, we prepared a green, cheap material by chelating humic acid with ferric ions (HA-Fe) and used it as an anode material in LIBs for the first time. From the SEM, TEM, XPS, XRD, and nitrogen adsorption-desorption experimental results, it was found that the ferric ion can chelate with humic acid successfully under mild conditions and can increase the surface area of materials. Taking advantage of the chelation between the ferric ions and HA, the capacity of HA-Fe is 586 mAh·g-1 at 0.1 A·g-1 after 1000 cycles. Moreover, benefitting from the chelation effect, the activation degree of HA-Fe (about 8 times) is seriously improved compared with pure HA material (about 2 times) during the change-discharge process. The capacity retention ratio of HA-Fe is 55.63% when the current density increased from 0.05 A·g-1 to 1 A·g-1, which is higher than that of HA (32.55%) and Fe (24.85%). In the end, the storage mechanism of HA-Fe was investigated with ex-situ XPS measurements, and it was found that the C=O and C=C bonds are the activation sites for storage Li ions but have different redox voltages.

Graphene coupled flower-like oxidized-polyacrylonitrile as high-performance anodes for sustainable lithium-ion batteries

In situ polymerization of acrylonitrile and graphene oxide in combination with thermal treatment was readily performed to produce robust hierarchical hybrids containing flower-like oxidized-polyacrylonitrile, which synergistically couple conductive graphene and a multi-electron redox-active matrix, affording large reversible capacity, high rate capability, and long cycle life toward cost-efficient and sustainable batteries.

Superlithiation Performance of Covalent Triazine Frameworks as Anodes in Lithium-Ion Batteries

Organics with the merit of renewability have been viewed as the promising alternative of inorganic electrode materials in lithium-ion batteries, but most of them display inferior performance due to the sluggish ion/electron diffusion and the potential dissolution in aprotic electrolytes. Here, covalent triazine frameworks (CTFs-1), full of vertical pores and layered spaces for Li⁺ transfer, have been synthesized with p-dicyanobenzene as the monomer by a facile two-step method including a prepolymerization with CF₃SO₃H as the catalyst and deep polymerization in molten ZnCl₂. CTFs-1-400, obtained at the deep polymerization temperature of 400 °C, exhibits the superlithiation property with the specific capacities of 1626 mA h g^-1 at 25 °C and 1913 mA h g^-1 at 45 °C at 100 mA g^-1, indicating the formation of Li₆C₆/Li₆C₃N₃ in the reduction process. Electrochemical analysis and density functional theory calculation indicate that the ultrahigh capacity is mainly contributed by the capacitance of micropores and the redox capacity of benzene and triazine rings. Moreover, CTFs-1-400 displays the specific capacity of 740 mA h g^-1 for 1000 cycles at 1 A g^-1 with almost no capacity fading.

The Synthesis of a Covalent Organic Framework from Thiophene Armed Triazine and EDOT and Its Application as Anode Material in Lithium-Ion Battery

As a class of redox active materials with some preferable properties, including rigid structure, insoluble characters, and large amounts of nitrogen atoms, covalent triazine frameworks (CTFs) have been frequently adopted as electrode materials in Lithium-ion batteries (LIBs). Herein, a triazine-based covalent organic framework employing 3,4-ethylenedioxythiophene (EDOT) as the bridging unit is synthesized by the presence of carbon powder through Stille coupling reaction. The carbon powder was added in an in-situ manner to overcome the low intrinsic conductivity of the polymer, which led to the formation of the polymer@C composite (PTT-O@C, PTT-O is a type of CTFs). The composite material is then employed in LIBs as anode material. The designed polymer shows a narrow band gap of 1.84 eV, proving the effectiveness of the nitrogen-enriched triazine unit in reducing the band gap of the resultant polymers. The CV results showed that the redox potential of the composite (vs. Li/Li+) is around 1.0 V, which makes it suitable to be used as the anode material in lithium-ion batteries. The composite material could exhibit the stable specific capacity of 645 mAh/g at 100 mA/g and 435 mAh/g at 500 mA/g, respectively, much higher than the pure carbon materials, indicating the good reversibility of the material. This work provides some additional information on electrochemical performance of the triazine and EDOT based CTFs, which is helpful for developing a deep understanding of the structure-performance correlations of the CTFs as anode materials.

The synthesis of alternating donor-acceptor polymers based on pyrene-4,5,9,10-tetraone and thiophene derivatives, their composites with carbon, and their lithium storage performances as anode materials

Two conjugated polymer@activated carbon composites were synthesized by the in situ polymerization of two donor-acceptor type polymers including poly[(thiophene-2,5-yl)-((pyrene-4,5,9,10-tetraone)-2,7-yl)] (PTPT) and poly[((2,3-dihydrothieno[3,4-b][1,4]dioxine)-5,7-yl)-((pyrene-4,5,9,10-tetraone)-2,7-yl)] (POTPT) on activated carbon (AC) by one-step cross-coupling reaction catalyzed by an organometallic catalyst. Cyclic voltammetry showed that both polymers exhibited ambipolar properties, low bandgaps, and low electrode potentials, which could be useful for their application as anodes in lithium-ion battery cells (LIBs). For PTPT@AC and POTPT@AC anodes, they showed a high capacity of 253.9 and 370.5 mA h g-1 at 100 mA g-1. Besides, the capacities of pure polymers were calculated to be 693.5 and 1276.5 mA h g-1 for PTPT and POTPT, respectively, at 100 mA g-1. Compared with PTPT, the introduction of the 3,4-ethylenedioxy unit into the side chain of the thiophene unit leads to substantially improved performance of POTPT due to the lowered LUMO energy levels of POTPT and the electron-rich feature of the EDOT unit. It is suggested that the structure-tuning strategy might be an effective method to prepare the new polymer-based anode for next generation LIBs with high performance and high safety.

Conjugated Carbonyl Polymer-Based Flexible Cathode for Superior Lithium-Organic Batteries

Conjugated carbonyl compounds are deemed as high theoretical capacity and green electrode materials for lithium-ion batteries (LIBs) but are limited by their high dissolution and poor electronic conductivity. In this paper, we have successfully synthesized a series of multicarbonyl conjugated polymers using the coupling polymerization reaction and then constructed carbonyl-conjugated polymer/carbon nanotube hybrid films by a vacuum-filtration method. Importantly, the hybrid films could serve as a flexible, binder-free, and free-standing organic cathode for LIBs, which could deliver a high reversible discharge capacity of 142.3 mAh g^-1 at 50 mA g^-1, good cycling stability with a capacity retention of 74.6% at 500 mA g^-1 after 300 cycles, and excellent rate capability of 120.6 mAh g^-1 at 1000 mA g^-1. In addition, the theoretical calculation has proved that the symmetrical conjugated structure can well accommodate four Li⁺ ions during the electrochemical reaction. Interestingly, the assembled full cell and flexible battery can power the small devices, suggesting its potential to use in bendable or wearable energy-storages devices.

Recent Progress in Polymeric Carbonyl-Based Electrode Materials for Lithium and Sodium Ion Batteries

Advancement in mobile electronics is driving progress in lithium ion batteries. Recently, organic electrode materials have emerged as promising candidates for lithium ion batteries due to their high theoretical capacity, ease of synthesis, versatility of structure, and abundance. Polymerization is a strategy used to overcome the issues associated with small organic molecules for charge storage application. The focus of this review is on the most recent progress in the field of polymeric carbonyl materials for lithium ion batteries (LIBs) and sodium ion batteries (SIBs). Advantages of organic electrode materials, device architecture, and charge storage mechanism are discussed. Challenges associated with carbonyl-based electrodes and some recent solutions are outlined. Later, a comparison of theoretical capacity, practical capacity, and cyclic life are presented for different carbonyl systems. Capacity-fading phenomena and structural degradation during charging are discussed where necessary. Some key parameters for the design of flexible batteries are highlighted and an overview of some recent contributions of our group in this field are reported. Finally, some future prospects for researchers in this field are outlined.