Dynamic Rheological and Microstructural Properties of Normal and Waxy Rice Starch Gels Containing Milk Protein Ingredients

Microstructural studies of imitation cheese with a shift in continuous phase

When casein is replaced with starch in imitation cheese, the functionality changes. Three different microscopy methods were applied to understand the microstructural differences in the product depending on which component dominates the microstructure. Confocal Laser Scanning Microscopy (CLSM) for component identification. Scanning Electron Microscopy (SEM) and Cryogenic Scanning Electron Microscopy (Cryo-SEM) for studying surface structures. Differences in the surface structures were detected between SEM and Cryo-SEM. In SEM, starch appeared rough and protein smooth, while in Cryo-SEM no starch roughness of the surface was found. A change in starch modification and effects of protein prehydration was also analysed. Adding octenyl succinic anhydride (OSA) modified starch for emulsifying properties resulted in a microstructure with fragmented protein at a protein level of 7 %, but not at 9 or 12 %. Protein prehydration had limited effect on microstructure. On a macrostructural level, the change to an emulsifying starch increased hardness in imitation cheese with 7 and 9 % protein. Protein prehydration slightly decreased the hardness, but the difference was not significant at all concentrations. This research provides valuable information about the microstructure of imitation cheese at a 50/50 composition, how the microstructure changes with an emulsifying starch and what occurs after a protein prehydration was included in the production.

Development of low glycemic index instant Phirni (pudding) mix-its visco-thermal, morphological and rheological characterization

High amylose rice (HAR) and carboxymethyl cellulose (CMC) are the preferred choices for enhancement of resistant starch content and lowering of glycemic index in dairy desserts. The effects of different levels of skimmed milk powder (SMP): HAR flour (45:55 to 75:25) and CMC (0.1 to 1%) were investigated on physical characteristics of dry-mix and on texture profile parameters, resistant starch (RS), predicted glycemic index (pGI), glycemic load (GL) and overall acceptability of phirni (a traditional milk pudding). Design expert predicted SMP (70): HAR (30) and CMC (0.8%) as optimum levels for reducing the pGI and maximizing the RS content and other quality characteristics in phirni. RS content of phirni (4.38%) prepared from optimized dry-mix (ODM) was higher while pGI (48.12) and GL (7.50) were lower as compared to phirni prepared from market dry-mix (MDM). The visco-thermal properties of ODM and MDM also showed significant variations. Storage modulus (G') and loss modulus (G'') indicated that ODM phirni was less solid than MDM phirni. Scanning electron micrographs showed fused structures in ODM, while coarse sheet like structures were observed across the surface of MDM. Thus, ODM can be a promising substitute for the available milk desserts for diabetic patients.

Influence of whey protein isolate on pasting, thermal, and structural characteristics of oat starch

We investigated the effects of different concentrations of whey protein isolate (WPI) on oat starch characteristics in terms of pasting, thermal, and structural properties. The pasting properties of the starch showed that hot paste viscosity increased with the addition of WPI in the system, and relative breakdown decreased. Thermal analysis showed a significant effect of WPI on oat starch by increasing the peak temperature of differential scanning calorimeter endotherms. The X-ray diffraction and Fourier transform infrared spectroscopy studies revealed that WPI increased the ordered structuration of starch paste, as evident by an increase in relative crystallinity; in addition, a decrease in infrared bands at 1,024 cm^-1 and 1,080 cm^-1 suggested decreased gelatinization of oat starch granules. Overall, WPI at different concentrations affected the oat starch gelatinization properties.

Influence of honey types and heating treatment on the rheological properties of glutinous rice flour gels

Present study compared the rheological properties of glutinous rice flour (GRF) gel (33.3%, w/v) added with raw bee honey (RBH) or stingless bee honey (SBH) with/without heating treatment. RBH (diatase activity: 12.14 Schade) and SBH (1.53 Schade) significantly reduced the network of GRF gel by lowering the gel viscosity, with RBH having the highest rate of viscosity decrease (- 2.74 × 10^-5 Pa). As the addition of heated-SBH or heated-RBH did not reduce gel viscosity, it was hypothesised that active diastase played a major role to weaken gel network. This was further supported by the significant and the lowest storage modulus (G') value of RBH-GRF gel (5.99 ± 0.02 Pa), as compared to SBH-GRF (6.27 ± 0.04 Pa) and control (6.33 ± 0.04 Pa). A detail of rheological behaviour of the gels was further explained using power law. Overall, this GRF gel model has successfully demonstrated the potential of honey diastase in weakening network of starch-based food.