Activated sludge and other aerobic suspended culture processes

Enzymatic phosphatization of fish scales-a pathway for fish fossilization

Phosphatized fish fossils occur in various locations worldwide. Although these fossils have been intensively studied over the past decades they remain a matter of ongoing research. The mechanism of the permineralization reaction itself remains still debated in the community. The mineralization in apatite of a whole fish requires a substantial amount of phosphate which is scarce in seawater, so the origin of the excess is unknown. Previous research has shown that alkaline phosphatase, a ubiquitous enzyme, can increase the phosphate content in vitro in a medium to the degree of saturation concerning apatite. We applied this principle to an experimental setup where fish scales were exposed to commercial bovine alkaline phosphatase. We analyzed the samples with SEM and TEM and found that apatite crystals had formed on the remaining soft tissue. A comparison of these newly formed apatite crystals with fish fossils from the Solnhofen and Santana fossil deposits showed striking similarities. Both are made up of almost identically sized and shaped nano-apatites. This suggests a common formation process: the spontaneous precipitation from an oversaturated solution. The excess activity of alkaline phosphatase could explain that effect. Therefore, our findings could provide insight into the formation of well-preserved fossils.

Evolution and Prospects in Managing Sewage Sludge Resulting from Municipal Wastewater Purification

Municipal sewage sludge is the residual material produced as a waste of municipal wastewater purification. It is a sophisticated multi-component material, hard to handle. For many years, it has been landfilled, incinerated, and widely used in agriculture practice. When unproperly discharged, it is very polluting and unhealthy. The rapidly increasing global amount of municipal sewage sludge produced annually depends on urbanization, degree of development, and lifestyle. Some diffused traditional practices were banned or became economically unfeasible or unacceptable by the communities. In contrast, it has been established that MSS contains valuable resources, which can be utilized as energy and fertilizer. The objective of the review was to prove that resource recovery is beneficially affordable using modern approaches and proper technologies and to estimate the required resources and time. The open sources of information were deeply mined, critically examined, and selected to derive the necessary information regarding each network segment, from the source to the final point, where the municipal sewage sludge is produced and disposed of. We found that developed and some developing countries are involved with ambitious and costly plans for remediation, the modernization of regulations, collecting and purification systems, and beneficial waste management using a modern approach. We also found that the activated sludge process is the leading technology for wastewater purification, and anaerobic digestion is the leading technology for downstream waste. However, biological technologies appear inadequate and hydrothermal carbonization, already applicable at full scale, is the best candidate for playing a significant role in managing municipal sewage sludge produced by big towns and small villages.

A mathematical model for the activated sludge process with a sludge disintegration unit

We develop and investigate a model for sludge production in the activated sludge process when a biological reactor is coupled to a sludge disintegration unit (SDU). The model for the biological reactor is a slimmed down version of the activated sludge model 1 in which only processes related to carbon are retained. Consequently, the death-regeneration concept is included in our model which is an improvement on almost all previous models. This provides an improved representation of the total suspended solids in the biological reactor, which is the key parameter of interest. We investigate the steady-state behaviour of this system as a function of the residence time within the biological reactor and as a function of parameters associated with the operation of the SDU. A key parameter is the sludge disintegration factor. As this parameter is increased the concentration of total suspended solids within the biological reactor decreases at the expense increasing the chemical oxygen demand in the effluent stream. The existence of a maximum acceptable chemical oxygen demand in the effluent stream therefore imposes a maximum achievable reduction in the total suspended solids. This paper improves our theoretical understanding of the utility of sludge disintegration as a means to reduce excess sludge formation. As an aside to the main thrust of our paper we investigate the common assumption that the sludge disintegration processes occur on a much shorter timescale than the biological processes. We show that the disintegration processes must be exceptional slow before the inclusion of the biological processes becomes important.

A Simple Analysis Method of Specific Anammox Activity Using a Respirometer

Anaerobic ammonium oxidation (anammox) is a biological nitrogen removal process with attractive prospects, such as no carbon addition, less aeration, lower greenhouse gas generation, and lower sludge production. However, it is difficult to maintain a stable anammox process since the anammox bacteria have a slow growth rate and high sensitivity to many factors. Therefore, it is very important to analyze and maintain the anammox activity as a process indicator for its successful operation. The conventional method for measuring the concentration of nitrogen compounds, such as ammonium, nitrite, or nitrogen gas is inconvenient during the reaction time for specific anammox activity (SAA) analysis, which can result in an inaccurately determined SAA due to the substrate loss and temperature change. In this study, a respirometer was utilized to analyze the SAA. The SAA values from a respirometer (rSAA) showed a similar pattern to the SAA values (mSAA) from the conventional method. All of the SAA analyses showed the highest value at 35 °C with a granule size of <1 mm. Statistical analysis showed no significant differences regardless of the analysis method, since the p-values for the t-test and Wilcoxon rank-sum test were >0.05. Therefore, the respirometer can be used as a simple and efficient tool for SAA analysis. Moreover, the operating maintenance and management of the anammox process can be improved due to the simple SAA analysis in the field.