Nanoparticles used for fingermark detection—A comprehensive review

Improving flow dynamics and storage longevity of a low-cost phosphorescent fingerprint powder

An inexpensive, commercially available doped strontium aluminate phosphor with long-lived afterglow was prepared as a luminescent fingerprint dusting powder suited for challenging, highly patterned substrates; however, prolonged exposure to humidity was found to reduce that powder's affinity for fingermarks. Here, an enhanced preparation for synthesizing that fingerprint dusting powder is presented that prevents powder aggregation and loss of function upon exposure to humid environments. This was achieved by introducing a flow regulator during synthesis: hydrophobic silica SIPERNAT® D10 or SIPERNAT® D17. Increasing the hydrophobicity of the powder prevents aggregation by inhibiting the uptake of water, thereby improving the material's flow dynamics and transfer behavior from brush to fingermark. The angle of repose and flow characteristics made by the modified powders were quantified, with excellent affinity for fingermarks observed, even after being stored under 85% (±5%) humidity for 4 weeks. A preliminary comparison of the performance of the modified hydrophobic powders relative to the unmodified precursor revealed that more of the SIPERNAT® treated powder typically adhered to fingermarks while simultaneously imparting less background development. In addition, fewer clumps of particulate were observed in the developed fingermarks after addition of a hydrophobic flow regulator. This technical report outlines the updated method for synthesizing the fingerprint powder, with summarized flow performance results, and a demonstration of the modified powder's affinity for simulated fingermark evidence.

De Novo Green Fluorescent Protein Chromophore-Based Probes for Capturing Latent Fingerprints Using a Portable System

Rapid visualization of latent fingerprints, preferably at their point of origin, is essential for effective crime scene evaluation. Here, we present a new class of green fluorescent protein chromophore-based fluorescent dyes (LFP-Yellow and LFP-Red) that can be used for real-time visualization of LFPs within 10 s. Compared with traditional chemical reagents for LFPs, these fluorescent dyes are completely water-soluble, exhibit low cytotoxicity, and are harmless to users. Level 1-3 details of the LFPs could be clearly revealed through "off-on" fluorescence signal readout. Additionally, the fluorescent dyes were constructed based on an imidazolinone core and so do not contain pyridine groups or metal ions, which ensures that the DNA is not contaminated during extraction and identification after the LFPs are treated with the dyes. Combined with our as-developed portable system for capturing LFPs, LFP-Yellow and LFP-Red enabled the rapid capture of LFPs. Therefore, these green fluorescent protein chromophore-based probes provide an approach for the rapid identification of individuals who were present at a crime scene.

Preparation of a low-cost fingerprint powder that harnesses white light to emit long-lived phosphorescence

An inexpensive, commercially available doped strontium aluminate phosphor with long-lived afterglow has been prepared and assessed in the role of a luminescent fingerprint dusting powder. Blue, green, and aqua phosphorescence persisting for ca. 30 s was obtainable from treated fingermarks after charging the powders with the white light (400-700 nm) setting of a forensic light source. Imaging the phosphorescent afterglow enabled the elimination of background emissions encountered during latent fingermark examination. This was demonstrated by visualising fingermarks on substrates that possess inbuilt fluorescent security features and highly patterned substrate backgrounds, without any need for bespoke scientific equipment.

Nanosheets of two-dimensional photoluminescent lanthanide phosphonocarboxylate frameworks decorated with free carboxylic groups for latent fingerprint imaging

The synthesis, structural characterization, exfoliation, and photophysical studies of two-dimensional (2-D) lanthanide phosphonates, named Ln(m-pbc); [Ln(m-Hpbc)(m-H₂pbc)(H₂O)] (Ln = Eu, Tb; m-pbc = 3-phosphonobenzoic acid) based on the phosphonocarboxylate ligand, are reported. These compounds are neutral polymeric 2D layered structures with pendent uncoordinated carboxylic groups between layers. The nanosheets were obtained by a top-down strategy involving sonication-assisted solution exfoliation and characterized by atomic force microscopy and transmission electron microscropy, showing lateral dimensions from nano- to micro-meter scales, and thicknesses down to several layers. The photoluminescence studies demonstrate that the m-pbc ligand acts as an efficient antenna toward Eu and Tb(III) ions. The emission intensities of dimetallic compounds are clearly enhanced after incorporation of Y(III) ions due to the dilution effect. Ln(m-pbc)s were then applied for labelling latent fingerprints. It is worth noting that the reaction between active carboxylic groups and fingerprint residues benefits the labelling, showing efficient imaging for fingerprints on all kinds of material surfaces.

SALDI-MS and SERS Multimodal Imaging: One Nanostructured Substrate to Rule Them Both

Imaging techniques based on mass spectrometry or spectroscopy methods inform in situ about the chemical composition of biological tissues or organisms, but they are sometimes limited by their specificity, sensitivity, or spatial resolution. Multimodal imaging addresses these limitations by combining several imaging modalities; however, measuring the same sample with the same preparation using multiple imaging techniques is still uncommon due to the incompatibility between substrates, sample preparation protocols, and data formats. We present a multimodal imaging approach that employs a gold-coated nanostructured silicon substrate to couple surface-assisted laser desorption/ionization mass spectrometry (SALDI-MS) and surface-enhanced Raman spectroscopy (SERS). Our approach integrates both imaging modalities by using the same substrate, sample preparation, and data analysis software on the same sample, allowing the coregistration of both images. We transferred molecules from clean fingertips and fingertips covered with plasticine modeling clay onto our nanostructure and analyzed their chemical composition and distribution by SALDI-MS and SERS. Multimodal analysis located the traces of plasticine on fingermarks and provided chemical information on the composition of the clay. Our multimodal approach effectively combines the advantages of mass spectrometry and vibrational spectroscopy with the signal enhancing abilities of our nanostructured substrate.

Pristine Graphic Carbon Nitride Quantum Dots for the Visualized Detection of Latent Fingerprints

User-friendly fingerprint powders, namely efficient, low-cost and nontoxic ones, are always desirable for the development of latent fingerprints (LFPs). Here, we described the use of pristine graphic carbon nitride quantum dots (g-C₃N₄ QDs) as a new kind of user-friendly fingerprint powder. The g-C₃N₄ QDs can be easily prepared from urea and sodium citrate precursors through low temperature solid-phase reaction. Due to their good optical properties and selective interactions with secretion residuals, the g-C₃N₄ QDs powders were exploited to develop LFPs on different substrates by the powder dusting technique. The LFP images on a plastic bag exhibited a high ridge and furrow contrast ratio, allowing for easy identification of level 1 - 3 details of LFPs. This work indicates that the g-C₃N₄ QD powders provide good performance for LFP visualization and is likely to be adopted for some applications in forensic investigations.

Polymer-Coated Nanoparticles for Therapeutic and Diagnostic Non-10B Enriched Polymer-Coated Boron Carbon Oxynitride (BCNO) Nanoparticles as Potent BNCT Drug

Boron neutron capture therapy (BNCT) is a powerful and selective anti-cancer therapy utilizing 10B-enriched boron drugs. However, clinical advancement of BCNT is hampered by the insufficient loading of B-10 drugs throughout the solid tumor. Furthermore, the preparation of boron drugs for BNCT relies on the use of the costly B-10 enriched precursor. To overcome these challenges, polymer-coated boron carbon oxynitride (BCNO) nanoparticles, with ~30% of boron, were developed with enhanced biocompatibility, cell uptake, and tumoricidal effect via BNCT. Using the ALTS1C1 cancer cell line, the IC50 of the PEG@BCNO, bare, PEI@BCNO were determined to be 0.3 mg/mL, 0.1 mg/mL, and 0.05 mg/mL, respectively. As a proof-of-concept, the engineered non-10B enriched polymer-coated BCNO exhibited excellent anti-tumor effect via BNCT due to their high boron content per nanoparticle and due to the enhanced cellular internalization and retention compared to small molecular 10B-BPA drug. The astrocytoma ALTS1C1 cells treated with bare, polyethyleneimine-, and polyethylene glycol-coated BCNO exhibited an acute cell death of 24, 37, and 43%, respectively, upon 30 min of neutron irradiation compared to the negligible cell death in PBS-treated and non-irradiated cells. The radical approach proposed in this study addresses the expensive and complex issues of B-10 isotope enrichment process; thus, enabling the preparation of boron drugs at a significantly lower cost, which will facilitate the development of boron drugs for BNCT.

Harnessing long-lived visible phosphorescence to eliminate background interference from fingermark images

Minimising background fluorescence can enhance the visible details of treated fingerprints. Here, a 4-tpt fingerprint powder exhibiting long-lived phosphorescence is applied to this end. The powder was found to suppress background fluorescence, including on challenging surfaces, when using standard forensic equipment and eschewing specialized or bespoke imaging techniques.